Your search resulted in 170 documents. Displaying 25 entries per page.
Comparison of the anti-fungal efficacy of Cobra with drill perforation on oscillating pressure treated spruce transmission poles -Laboratory test
1988 - IRG/WP 3469
A laboratory method for measuring the depth of penetration of the fungicidal concentrations effective against basidiomycetes (brown rot) was developed. The tests on CCB oscillating pressure treated spruce transmission poles have shown that the depth of salt penetration can be increased by about 10 mm by a drill perforation before the impregnation. An even better penetration is reached, however, if...
E Graf, B Zgraggen
End grain sealing by polymer impregnation
1992 - IRG/WP 92-3708
The solution and dispersion characteristics of several hydrophobic derivatives of cellulose have been studied and the abilities of these polymers to afford effective end grain sealing of Corsican pine have been examined. Both solution and dispersion treatments with ethyl cellulose imparted good water repellency and end grain sealing to wood samples, however, the disperse systems possessed lower vi...
J M Lawther, W B Banks, D G Anderson, J A Cornfield
Biological resistances of wood-metaborate composites using the borax solution system
2001 - IRG/WP 01-30259
Combinations of wood and metaborate composite were prepared from sapwood specimens of Japanese cedar (Cryptomeria japonica) and the borax and metallic salts system using the diffusion-penetrated process. Wood-metaborate composites were produced as follows: water-saturated specimens were first impregnated by a saturated borax solution and then diffuse-penetrated with Zn2+, Ca2+, or Pb2+ solution. B...
Liang Lin, T Furuno
Microwave modification of Yellow Stringybark (Eucalyptus Muelleriana) posts for impregnation with Copper-Chrom-Arsenic (CCA) preservatives
2000 - IRG/WP 00-40185
Yellow Stringybark posts with diameters ranging from 60-100 mm were microwave conditioned using a 60 kW microwave (MW) generator. A substantial improvement in heartwood penetration of preservatives and relaxation of growth stresses was indicated such that there was no split formation following drying of the posts. High preservative absorption of copper-chrome-arsenic (CCA) was achieved ranging fro...
G Torgovnikov, P Vinden
A review of the efficacy and uses of deltamethrin for wood preservation
1996 - IRG/WP 96-30105
The synthetic pyrethroid deltamethrin, is one of the most active insecticides available for protecting and curing wood from attack by beetles and termites. Freshly felled trees can be protected against bark beetles by spraying to run off with a 0.025% Al solution (K-Otek EC25) with negligible leaching. Alternatively, sawn timber may be dipped in a 0.0125% Al solution for short to medium term prote...
A J Adams, J L Lindars
A new vacuum/pressure plant system
1988 - IRG/WP 3479
In the subtropical regions, the problem of wood supplying becomes more and more difficult to be solved. In that context, the Centre Technique Forestier Tropical had paid a particular attention to the valorization of products issued from plantations in dry zones of Africa. In these plantations, the products of clearings can be used as fencing, stakes or for traditional construction. However in thes...
C Dalois, R Schwartz, G R Y Déon
Microdistribution of water-borne preservatives in blue gum treated by full-cell process
1990 - IRG/WP 3617
The present work deals with the study of the microdistribution of copper, chrome and arsenic elements in Eucalyptus globulus Labill. sapwood, treated with a CCA water-borne preservative by full-cell process, with the help of scanning electron microscopy together with energy dispersion X-ray analysis technique. The work shows that the retention of CCA elements is high in vessels and vasicentric par...
D De Sousa Castro Reimão, J M Palacios
Three-year field trials of polymeric formulations which provide a new basis for the invention and design of non-toxic wide-spectrum wood preservatives
1994 - IRG/WP 94-40029
Three types of non-toxic polymeric formulations invented using a new approach to wood preservation were challenged with termites and fungi in three-year ground-contact field trials in the sub-tropical climate of Natal. These formulations were copper soaps of carboxylic acid groups of unsaturated fatty acids of waxes and edible vegetable oils; of resin acids of rosin, and, of synthetic unsaturated ...
A A W Baecker, A Pizzi
Thickened boron treatment
1990 - IRG/WP 3632
Commercial trials with thickened boron preservatives "Diffusol™" indicate a number of advantages when compared to traditional methods of dip-boron preservative treatment. These include: (i) more even uptake and distribution of preservative on and within the timber; (ii) faster diffusion times; (iii) the treatment of gauged timber (though improved retention); (iv) saving in energy costs (heating ...
P Vinden, J A Drysdale, M Spence
Gaseous preservative treatment of wood
1990 - IRG/WP 3631
A recent development in processing wood with a gaseous preservative means that dry, treated wood can be produced in under 30 hours with the benefits of product diversification, faster stock turnover and the ability to respond to short term demand. About 400,000 m³ of wood are treated each year in New Zealand with boron salts to protect from borer infestation. Traditionally this treatment is effec...
R Burton, A J Bergervoet, K Nasheri, P Vinden, D R Page
Solution stability and Mechanical properties of Chitosan treated Pine
2005 - IRG/WP 05-30377
During the last years the research on chitosan as a wood preservative has been enhanced. Up to now, most of the research has been applied to the anti-fungal properties of chitosan, and no research was conducted on the solution stability of chitosan solutions in repeated trials by impregnation of wood, or on the mechanical properties of chitosan-treated wood. In this paper, the stability of high- a...
E Larnøy, M Eikenes, H Militz
Internal pressure development within Oriented Strand Board during supercritical fluid impregnation
2000 - IRG/WP 00-40175
Supercritical fluids (SCF) offer an attractive alternative to conventional treatment processes for delivering material into wood, but there are many unanswered questions concerning the technology. One major concern is the potential for the development of excessive pressure gradients in the wood that might exceed the material properties and lead to crushing or other pressure-induced damage. Previou...
G Oberdorfer, P E Humphrey, R J Leichti, J J Morrell
The resistance of timbers to impregnation with wood preservatives
1979 - IRG/WP 3137
It is anatomical structure which determines liquid flow rate within different timber species. This cannot be deduced from properties such as density or rate of growth, and can only be found by experiment. A standard test has been in use at the Princes Risborough Laboratory for many years, employing a pressure-impregnation treatment, and a large number of timbers have been studied. The test consist...
Anonymous
Impregnation of timber with tannin as a mean of improving its dimensional stability
1992 - IRG/WP 92-3695
The results of a joint project carried out at the Timber Division of LNEC under the 2nd research programme of the CEC DGXII - "Wood as a renewable raw material" entitled "Stabilization of wood by impregnation processes" is presented. Pieces Maritime pine timber was impregnated with tannin under pressure to see if the treatment with tannin improved the behavior of wood regarding its dimensional sta...
J S Machado
Fixation of chromated wood preservatives through technical drying
1990 - IRG/WP 3623
Twin samples of sawn timber of Pinus sylvestris and Picea sp. were treated with copper-chromate-containing wood preservatives and subsequently kiln resp. air dried. After drying, the distribution of preservative and rate of fixation were determined. Drying of freshly treated wood in a condenser type kiln at temperatures of 60°C and 80°C and in a vacuum type kiln at 55°C with a pressure of about...
R-D Peek, H Klipp
Effects of the sulfuric acid modification of CCA treating solution
1987 - IRG/WP 3415
Sulfuric acid modification of CCA treating solution is often used to control the formation of sludges and undesirable deposits on the surface of treated wood. The consequences of sulfuric acid addition are examined in this work and negative effects are shown to far outweigh any benefits. Major risks include the loss of copper due to leaching from treated wood and the accelerated corrosion of treat...
R F Fox, H J Fry, E A Pasek, A S Ross
The potential of high pressure pulsation processes to treat white spruce lumber with water-borne preservatives
1988 - IRG/WP 3471
Laboratory work using end sealed 4x8x46 cm³ white spruce samples has been done to explore the suitability of three variants of a 2.1 MPa pulsation process for the impregnation of white spruce with CCA. The results showed that the process improved significantly the penetration of the preservatives and reduced significantly cell collapse, when compared with the results of treatment using a 2.1 MPa ...
J P Hösli, J N R Ruddick
The susceptibility to sludging of sulfate and oxide CCA
1990 - IRG/WP 3599
Radiata pine sapwood was treated separately with a sulphate CCA-C and an oxide CCA in a pilot scale pressure plant using a full cell process. CCA solutions were recovered from the final vacuum phase, placed in plastic tubes, and their susceptibility to sludging determined by examining changes in solution pH, time required for sludge to form and weight and chemical composition of sludge formed. Sul...
B T Mutandadzi, P D Evans
The effect of woody and non woody plants extractives on microbial resistance of non-durable species
2006 - IRG/WP 06-30392
The effect of Elm (Zelkova carpinifolia), Oak (Quercus castanifolia), Mulberry (Morus alba), Ash (Fraxinus excelsior) as woody plants, Rose (Rosa damascene) and Fumitory (Fumaria sp) as non woody plants extractives on durability of Beech (Fagus orientalis), Maple (Acer insgin), Alder (Alnus subcordata), and Lime (Tilia sp) were studied. First wood species having extractives were cut to small piece...
S M Kazemi, A Hosinzadeh, M B Rezaii
Beetle-Fungus Associations in Woody Substrates in the Context of International Trade
2007 - IRG/WP 07-10610
Interest in the role of insects in transmitting various fungi and in the potential for outbreaks of insects vectoring plant disease organisms has resulted in a large volume of literature on insect-fungi relationships. Mites are mentioned as an important third partner in these associations. This paper summarizes information and provides an update on major aspects of these intricate associations in ...
A Uzunovic
Arsenic removal by plant pumping mechanism from arsenic solution using activated aluminum oxide as adsorbent – a preliminary study
2006 - IRG/WP 06-50239
This study evaluated the performance of plant pumping mechanism for removal of arsenic from arsenic solution using activated aluminum oxide as adsorbent. Generally, plants absorb water from soil mainly by osmosis process and toxic elements present in soil also move along with water. To remove toxic elements present in contaminated soils/water, different chemical substances are widely used as
...
B Tarakanadha, H Koyanaka, T Hata, Y Imamura
Wood furfurylation process development. Part 2: Lowry impregnation trials
2007 - IRG/WP 07-40377
The objective was to evaluate whether Lowry-impregnation of Scots pine with FA100-mix, instead of the FA40-mix, would lead to similar or slightly higher WPGs and to investigate any potential changes in penetration pattern. The results indicate that the penetration was better, also penetrating the outer zone of the heartwood. Furthermore, it was possible to reduce the WPG-levels for pine down to 50...
M Westin, E Larnøy, S Lande
Comparative study between full cell and passive impregnation method of wood preservation for laser incised Douglas-fir lumber
2007 - IRG/WP 07-40359
Many wood species are highly resistant to conventional pressure treatment. To improve the chemical impregnation into Douglas-fir (Pseudotsuga menziesii Franco) lumber, the passive impregnation method had been developed. In this study, ability of the passive impregnation for lumber was compared with a conventional full cell method. Square Douglas-fir lumber with the incising density of 10,000 holes...
Md N Islam, K Ando, H Yamauchi, Y Kobayashi, N Hattori
The Comparison of Fixation and Leachability of Bark, Fruit and Leaf Tannin Extracts with Boron Minerals
2008 - IRG/WP 08-30473
Tannins extracted from several plants have natural durability properties. Due to these properties, some of the researchers have studied them for protecting wood. In this study, Scots pine (Pinus sylvestris) and beech (Fagus orientalis) wood samples were treated with bark, fruit, and leaf extracts as well as water-based wood preservative salts at various concentrations to increase fixation. The pen...
S Sen, C Tascioglu, K Tirak
Effects of Moisture Content and Species on Penetration of Liquid in Laser Incised Lumber by the Passive Impregnation Method
2008 - IRG/WP 08-40408
Penetration of liquid by passive impregnation method for Douglas-fir (Pseudotsuga menziesii Franco), sugi (Cryptomeria japonica D. Don) and Japanese larch (Larix leptolepis Gordon) were studied. Effects of initial moisture content of sugi (16, 43 and 70% moisture content) on liquid penetration by the method were also studied. Dried Douglas-fir and sugi, and green Japanese larch and sugi were treat...
N Hattori, M Nazrul Islam, K Ando, H Yamauchi