Your search resulted in 3115 documents. Displaying 25 entries per page.
Effectiveness of CCA-C and CCB preservatives after a 30 years stake test
2012 - IRG/WP 12-30606
The objective of this experiment was to assess the durability of four pine species treated with waterborne preservatives. In order to determinate this, a stake field test, following the IUFRO (International Union of Forestry Research Organizations) recommendations, was installed at Experimental Station of Luiz Antonio (21º 32’ S and 47º 42’ W), State of São Paulo, Brazil.
Species under t...
I PJankowsky, E S Lepage, C Salvela, J M Vidal, S Takeshita
High-throughput sequencing highlighted contrasted pioneer fungal communities associated to coniferous and deciduous wood preservation assays
2013 - IRG/WP 13-10800
Studying the fungal communities in the wood, in particular during the first events of the colonization, and the factors that underlie the dynamics of fungal species assemblages remain a challenge in ecology, because of the absence of fructification during the pioneer steps of wood degradation. The use of Next-generation DNA sequencing methods, which produce massive volumes of data, provided new pe...
Y Mathieu, A Dassé, I Le Bayon, M Kutnik, L Harvengt, E Gelhaye, M Buée
Methylene Chloride compared with white spirit as a treatment solvent for wood preservation – results from decay and termite studies
2013 - IRG/WP 13-30611
Non-aqueous solvents have a long history in the treatment of wood products in various parts of the world. The most familiar solvent treatment is the ‘light organic solvent preservative’ (LOSP) treatment based on low density solvents such as white sprit. Until recently white spirit was the only non-aqueous solvent approved for use in wood preservation in New Zealand. Australia also permitted...
A Siraa, P Lobb, C Molloy
State of progress of utilisation of supramolecular gels for formulations of water-soluble wood preservation salts
2013 - IRG/WP 13-30630
This article is a compilation of the work done so far concerning the utilization of supramolecular hydrogels, built on low-molecular-weight amphiphilic molecules and containing boron salts conferring fungicidal properties. Mixing boron with thermoreversible hydrogels allows the formation of a supra molecular network incorporating boron and important amount of water upon gelification of the solutio...
F Obounou Akong, P Gérardin, M-F Thévenon, C Gérardin-Charbonnier
Bio-based thermoset resins for bonding and eco-friendly preservation in the wood industry
2013 - IRG/WP 13-40650
Yellow dextrins and tannins were used in wood adhesives formulation to substitute resins based on formaldehyde. Several formulations were carried out in alkaline aqueous media by varying the weight fraction of two compounds from 10% to 30%. The cross-linking was performed using epichlorohydrin as a reticulant agent. Rheological behaviours and initial adhesion of three liquid formulations, before r...
C Motillon, A Allal, A Visse, F Charrier, B Charrier, A Baldé
Bibliographical study: Decontamination of wood and soils polluted by pesticides used in wood preservation: focus on Bioremediation methods using microbes
2013 - IRG/WP 13-50292
The purpose of this bibliographical study was to seek out the existence of projects (past, present, or future) on soil decontamination in wood treatment plants. Indeed, such polluted soils may contain dioxins and various types of furans. The aim was to find out whether there existed one or more methods bringing into play biodegradation techniques using, for example, species of fungi, yeasts, bacte...
Zaremski, L Gastonguay, C Zaremski, S Morel, J Beauchene
Durability and Wood Protection for Historic Covered Bridges in the United States
2014 - IRG/WP 14-10829
A majority of the covered wooden bridges in United States were built in the mid -1800’s. These structures represent a unique cultural and technological heritage from that era. Over time, these bridges have been deteriorated by microorganisms and insects or damaged by acts of vandalism and arson. The National Historic Covered Bridge Preservation (NHCBP) Program sponsored by the Federal Highway Ad...
V W Yang, C A Clausen
In vitro fungicidal activity of Tunisian essences extracts against Coriolus versicolor and Coniophora puteana
2014 - IRG/WP 14-20544
Bark of six Tunisian species including cork oak (Quercus suber L.), eucalyptus camaldulensis, alder (Alnus glutinosa), Aleppo pine (Pinus halepensis), nut pine (Pinus pinea) and Chelfi pomegranates (Punica granatum) were tested against two rot-fungi: Coriolus Versicolor (for leafy trees) and Coniophora Puteana (for conifers) according to an adaptation of the European guidelines (NF EN 113, 1986). ...
L Lajnef, N Ayed, B Charrier
Coconut shell pyrolytic oil as wood protectant against biodeterioration
2014 - IRG/WP 14-30648
Extensive research on various plant and microbial extracts has been conducted as an alternative to using synthetic or inorganic chemicals for wood protection. Development of effective and low environmental impact products and technologies for wood protection is imperative. In the present study, the efficacy of coconut shell pyrolytic oil as a wood protectant is analysed in terms of its antifungal,...
K S Shiny, O K Remadevi
CreoSub – New protection technology to substitute creosote in railway sleepers, timber bridges, and utility poles
2014 - IRG/WP 14-30644
Creosote oil is one of the oldest industrially used wood preservatives. Due to its toxic profile, the European Commission has restricted the use of creosote specific applications, but it is highly controversial within the European Commission. Its approval for use after 2018 is very questionable and may depend on derived research results until then, i.e., the viability of alternatives developed to ...
U Hundhausen, K-C Mahnert, A Gellerich, H Militz
The potential of 2D NIR imaging for wood protection research
2015 - IRG/WP 15-20566
Investigating wood and wood-based materials using infrared spectroscopy has since long been explored. Recently, image-based systems have been developed that are used in food and pharmaceutical industries for rapid screening. Such hyperspectral cameras are able to collect spatial and spectral information simultaneously, resulting in a volume with a spectral profile for each pixel of the image. We p...
J Van den Bulcke, N Defoirdt, W Li, J Van Acker
Factors Affecting Performance of Preserved Wood Decking Against Decay Fungi
2015 - IRG/WP 15-30663
Decking is the largest market for residential preserved wood in the United States. Preserved decking must be resistant to colonization by decay fungi initiating from spores, and occasionally from mycelia due to elevated soil levels or adjacent untreated wood. The most vulnerable parts of a preserved wood deck are untreated, or under-treated, wood that becomes exposed by field cuts and checking. Fi...
R Stirling, P I Morris
Cultural heritage – research into innovative solutions and methods for historic wood conservation
2016 - IRG/WP 16-10874
Nowadays, interdisciplinary knowledge, tools and techniques are increasingly used to protect and conserve monuments representing our cultural heritage. This is of great importance especially in case of conservation and restoration of wooden historic artefacts which, as a result of physical, chemical and biological corrosion, have lost their technical, aesthetic and decorative properties. If those ...
M Broda, B Mazela
Enhancing wood properties through bio-based and non-biocidal co-polyesters
2016 - IRG/WP 16-40740
The commonly used wood preservation treatments are nowadays facing huge environmental issues, as well as increasing public concern. As regards those concerns, legislation tends to regulate the use of biocidal preservation chemicals.
Thus, it does appear crucial to provide alternatives to the use of biocides to allow different outdoor uses of wood such as for, posts, decking, and cladding or even ...
C L’Hostis, M-F Thévenon, E Fredon, P Gérardin
Evaluation of Commercially Available Polyurethane Resin to Develop Non-biocidal Wood Preservation Treatments
2016 - IRG/WP 16-40751
Evaluation of commercially available polyurethane (PU1 and PU2 and polyisocyanate (PNCO) to develop non-biocidal wood preservation treatments have been conducted. A simple method by vacuum impregnation of these resins into beech wood (Fagus sylvatica L) and pine wood (Pinus sylvestris L.) samples followed by varied curing process at ambient temperature, 103oC, and 200oC have been performed. Based ...
M Mubarok, Y Sudo Hadi, J Suryana, I W Darmawan, F Simon, S Dumarcay, C Gérardin, P Gérardin
New Standards for Approval of Modified Wood within the Nordic Wood Preservation Council (NWPC)
2017 - IRG/WP 17-20624
In the Nordic countries, there is a long tradition for quality labelling of preservative treated wood. Until now the labelling has been restricted to pine and other easy to treat wood species, but with the introduction of a new set of standards it is now possible to obtain the Nordic Wood Preservation Council’s (NWPC) quality labelling also for modified wood.
In this paper, we will introduce th...
N Morsing, E Engelund Thybring, M Klamer
Copolymers of tannin extracts as wood protection agents
2017 - IRG/WP 17-30709
Wouldn´t be a dream to preserve wood with the substances which the nature already synthesizes for protecting itself? The idea we would like to pursue is simple: Increase the concentration of these substances, the tannins, trying to fix them properly in wood. It appears easy but it is not. Sensibility against leaching, fungal decay and weathering were observed. In this paper new flavonoid co-polym...
G Tondi, L Sommerauer, A Oberle, A Petutschnigg, M-F Thevenon
Hibernation or spring awakening? – The research on wood durability and protection in marine environment
2018 - IRG/WP 18-10929
Wooden structures in marine applications are exposed to severe degradation conditions caused by mechanical loads and wood degrading organisms. The present paper presents the use of wood in marine environments in Europe from a wood protection perspective and gives an overview over relevant research topics. It compiles the most relevant literature with an emphasis on new wood protection methods and ...
A Treu, K Zimmer, C Brischke, E Larnøy, L R Gobakken, F Aloui, S M Cragg, P-O Flæte, M Humar, M Westin
The anatomical determination of wood samples found in the “Fürstengräber” from Lübsow (Poland)
2018 - IRG/WP 18-10930
The paper presents the results of anatomical research identifying three wooden fragments from the “Princes Graves” (“Fürstengräber”) in Lübsow, Poland. The research demonstrates that the wooden fragments are typical of wood harvested from European forests.
The physicals conclusions are important for the research of Jan Schuster, from the University of Lodz, Institute of Archeology, Pol...
J Schuster, W Unger, T L Woods
Transfer of research results on the performance of wood and wood-based composites in outdoor applications into praxis
2018 - IRG/WP 18-20634
Forest-based industries have the potential to become an engine for a sustainable and competitive bioeconomy in Danube region. To reach this goal FORESDA projects was proposed. Main aim of respective project is transforming the traditional forest-based areas into innovative, modern and sustainable manufacturing areas; develop innovation-friendly ecosystems aiming to significantly improving and reco...
B Lesar, J Gričar, D Kržišnik, M Humar
Resistance of modified wood to termite attack assessed in laboratory and field testing: A review of internal research
2018 - IRG/WP 18-40824
Within the past decades, new wood modification technologies have been investigated in order to improve certain wood characteristics and enable the use of timber products for outdoor applications. Some of these non-biocidal technologies have been developed and commercialized recently. Thus, various material properties were studied intensively and shown to be improved. To a great extent, previous re...
L Emmerich, P Gascón-Garrido, H Militz
Wood-Plastic Composites preservation against fire: Nanofillers as fire retardant alternative
2018 - IRG/WP 18-40843
The purpose of this study is to improve fire resistance of Wood-Plastic Composites (WPCs) by adding inorganic nanofillers. Indeed, the main components of WPC, namely wood and polymer are both flammable materials despite the fact that WPCs are used in the field of construction. The effect of nanofillers on fire retardancy of Wood-High density polyethylene Composites was studied with three nanofille...
D Ben Ammar, A Koubaa, S Migneault, H Bouafif
Termite species associated with processed wood in South America
2018 - IRG/WP 18-10934
Termites as an eusocial insect group play an important role in the decomposition of organic matter of cellulose origin and in the modification and quality of soils. Some species are xylophagous, and therefore are considered an important urban pest due to their ability to attack not only wooden building structures but also synthetic materials such as PVC, polyethylene or polyurethane, causing great...
C Jorge, M Ibáñez
Declaring life cycle inventory of toxicity related emissions in environmental product declarations of preservative treated wood products
2018 - IRG/WP 18-50339
Life cycle assessment (LCA) including impacts on toxicity for preservative treated wood has been shown to have large uncertainties. With the growing demand for verified LCA in environmental product declarations (EPD), the need for reliable data is crucial for realistic assessment of wood products. Uncertainty is caused by several issues such as service life prediction, leaching rates and calculati...
L G F Tellnes, C Askham, P-O Flæte, M Klamer
An overview of The Wood Preservation Industry in South Africa
2018 - IRG/WP 18-50343
South Africa boasts a total land area of 1,22 million km2 or 122 million hectares of which approximately 1% is cultivated with commercial plantation forests. The species planted are exotic species i.e. pine, eucalyptus and wattle. The commercial forests supply raw material to a diverse forestry sector and industries including Paper and Pulp, Sawmilling, Mining Timber, Poles, Charcoal, Wood chemic...
Bruce Breedt