Your search resulted in 3495 documents. Displaying 25 entries per page.
Dutch work programme for environmental measures in wood preserving industry
1993 - IRG/WP 93-50001-30
Since the carly eighties, it has emerged that somewhat severe environmental problems exist in a significant number of wood-impregnating plants. Regular, structural emissions of such materials as hydrocarbons, and e.g. substances defined as requiring urgent attention, occur into the air, soil and water, including groundwater. This has been established by various investigations and an orientative in...
P Pasveer, H Militz, W J Homan
The colonisation and succession of fungi in wood
1980 - IRG/WP 1107
A study of the microbial ecology of small stakes of Pinus sylvestris and Betula pendula, both untreated, and treated with a 1% solution of CCA is in progress. Results are presented for the early stages, up to 18 months.Two new techniques were developed linked by the philosophy of objective assessment. Isolations were made from the wood in a pre-determined pattern and transferred to four selective ...
C P Clubbe
The potential for reuse of treated wood poles removed from service
1993 - IRG/WP 93-50001-18
Poles removed from service in Ontario and Quebec, Canada were characterized by age, wood species, preservative type, residual preservative, dimensions and condition. Based on this charactarization, the potential for reuse as round poles or posts, sawn posts, timbers and lumber, cedar roof shingles and firewood was assessed. A pilot study was conducted to evaluate the recovery and grade of lumber p...
P A Cooper
EPA’s Current Views on Heavy-Duty Wood Preservative Regulation
2003 - IRG/WP 03-50206
This paper describes the current EPA system for regulating pesticides and wood preservatives. In particular it focuses on the voluntary phase-out of CCA for residential uses after December 30, 2003, which was agreed between the CCA manufacturers and EPA. Even though the EPA reached an agreement with industry to phase out CCA for residential uses, EPA is continuing the most rigorous risk assessmen...
F T Sanders
Fire retardant treated wood and plywood: A comparative study
Part III. Combustion properties of treated wood and plywood
2002 - IRG/WP 02-40236
The fire retardant treated and untreated plywood and alder wood samples were prepared with the aim to investigate the effects of the way of treatment on the combustion properties. Alder wood was used for the preparation of plywood. Boric acid and borax were used as fire retardant. The plywood samples were impregnated by using three different methods; first group samples were impregnated by soaki...
S Çolak, A Temiz, Ü C Yildiz, G Çolakoglu
Decay evaluation of the effectiveness of a LOSP envelope treatment in eucalypt and meranti heartwoods for window joinery
1996 - IRG/WP 96-30099
The effectiveness and penetration in heartwood boards of an LOSP formulation containing TBTN was examined by determining decay resistance to the white-rot fungus Perenniporia tephropora. Boards, one metre long, of Eucalyptus regnans, Eucalyptus delegatensis, Eucalyptus obliqua and Eucalyptus sieberi were treated, along with boards of 'light' and 'dark' meranti. ...
L J Cookson, A Trajstman
The accelerated L-joint test method for determination of the out of ground natural durability
1998 - IRG/WP 98-20146
The accelerated L-joint test incorporates a moistening device and uses a close end water trap in an open joint connection with a laminated tenon member consisting of the perishable reference wood species scots pine sapwood and beech.
After one year of exposure it is possible to show a distinct identification of natural durability classes 4 and 5 against the more durable wood species. Both weight ...
J Van Acker, C Brauwers, M Stevens
Efficacy of waterborne copper naphthenate as preservative for northern hardwood species
1995 - IRG/WP 95-30091
Northern red oak (Quercus rubra) and red maple (Acer rubrum) cubes pressure treated with waterborne formulation of copper naphthenate were evaluated for resistance to attack by brown fungi Gloeophyllum trabeum (Pers. ex Fr.) Murr. (Madison 617 ATCC 11539) and Poria placenta (Fr.) Cooke (Madison 698, ATCC 11538), white rot fungi Trametes versicolor (L. ex Fr.) Pilat (R-105 from Jeff Morrell), Irpex...
D P Kamdem, R Fair, M H Freeman
Rubber wood for fishing canoe construction
2005 - IRG/WP 05-40319
The rubber tree (Hevea brasiliensis) is cultivated for its latex and the wood comes as a by-product from the rubber plantations. The highly perishable nature makes it unsuitable for boat building. The Central Institute of Fisheries Technology, Cochin conducted laboratory and field studies with chemical preservative treated rubber wood and found that the durability of the wood increased considerabl...
L Edwin, S N Thomas, B Meenakumari
Biosorption of metals for wood waste effluent clean up
1997 - IRG/WP 97-50090
The common filamentous fungi can sorb metal ions from aqueous solutions. The biosorption of metal ions like copper Cu2+, chromium Cr6+ and arsenic As5+ by dead fungal mycelia was investigated. Two industrial fermentation byproducts are tested: Mucor miehei and Aspergillus oryzae. The adsorption of metal ions depends on parameters such as chemical treatment of fungi before biosorption (acid or basi...
S Legay, G Labat
A study on the effectiveness of didecyldimethylammonium chloride to protect wood from attack by termites
1993 - IRG/WP 93-30009
A laboratory bioassay was conducted on the ability of didecyldimethylammonium chloride (DDAC) to protect Pinus radiata D.Don wood specimens from attack by two of Australia's most economically important species of subterranean termite, Mastotermes darwiniensis Froggatt and Coptotermes acinaciformis (Froggatt). Sapwood specimens of Pinus radiata, treated to achieve nominal retentions of 0.5...
J W Creffield
Effect of species composition of preservative-treated Douglas fir plywood on its decay resistance
1978 - IRG/WP 2114
Plywood is now commonly used for constructional purposes in environmental situations where decay by wood-destroying fungi can be a considerable risk. However there seems to be a lack of understanding of the relative durability of plywood, both untreated and when treated with wood preservatives. Part of the reason for this situation has been the difficulty of carrying out laboratory decay tests on ...
R S Smith, P Balcaen
Fouling organisms as indicators of the environmental impact of marine preservative-treated wood
1995 - IRG/WP 95-50063
This study evaluates the use of fouling organisms (epibiota) to assess the environmental impact of preservative treated wood. This paper presents initial findings from treated panels exposed for 6 months at Sagres, Algarve, Portugal. Panels were treated with CCA, two copper-containing quaternary ammonium (ACQ) formulations and creosote, with nominal retentions from 10 to 40 kg/m³ (creosote 25 pcf...
R M Albuquerque, S M Cragg
Isolation and identification of non-decay fungi affecting the performance of alkylammonium compounds
1993 - IRG/WP 93-10020
The isolation of DDAC tolerant fungi was carried out on lumber treated with a range of antisapstain chemicals containing DDAC as one of their active ingredients. The tolerant fungi were selected by using malt media spiked with DDAC (100 and 2500 ppm). Isolations were tentatively identified into a range of fungi commonly found associated with wood deterioration (i.e. Penicillium sp. and Trichoderma...
A K Doyle, J N R Ruddick
Ultrastructure of Prumnopitys ferruginea wood from a buried forest in New Zealand
1991 - IRG/WP 1489
The buried wood of Prumnopitys ferruginea, a New Zealand native tree, was examined by scanning and transmission electron microscopy to investigate the extent to which the wood had deteriorated and the cause of its deterioration. Examinations showed that some deterioration of wood had occurred. Microscopy revealed a decay pattern similar to that produced by cavitation bacteria. Lenticular cavities ...
A P Singh, T Nilsson, G F Daniel
Estimation of the impregnation degree of pine wood by the distribution analysis of active ions concentration in the cross-section
1999 - IRG/WP 99-20174
Samples in the form of pine wood rollers of diversified moisture content of ca. 50, 28 and 12% were impregnated with a water solution of the mixture type CCB with the use of the full-cell process. Moisture content was determined in individual layers from the girth to the pith. In the same way the concentrations of copper and chromium ions with the use of the spectrophotometric method and recalcula...
K Lutomski, B Mazela
Biological resistance of steam-compressed wood pretreated with boric compounds
1999 - IRG/WP 99-30190
Wood compression under heating is aimed to enhance dimensional stability and surface hardness. Preservative treatment with an appropriate chemical is additionally required for the protection of wood against biological agents under hazardous service conditions. Boron pretreatment of compressed wood was targeted to a mutual benefit of increasing biological resistance of compressed wood as boron was ...
M K Yalinkilic, W Dwianto, Y Imamura, K Tsunoda, M Takahashi
Methods for improving preservative penetration into wood: a review
2002 - IRG/WP 02-40227
Pressure treatment technologies have been available since the mid-1830's, but the processes used for wood treatment are still largely unable to overcome the fundamental limitations of flow through semi-permeable pit membranes. Instead, methods have arisen that attempt to improve treatability of the wood including incising, compression rolling, through boring, or radial drilling. Other a...
J J Morrell, P I Morris
Wood Preservation in the Federal Republic of Germany
1981 - IRG/WP 3157
The report gives some statistics about the forest products industries in the Federal Republic and a general review of the wood preservation industry. The trend in the use of wooden railway sleepers is decreasing, as is the use of poles. The sale of other pre-treated timber, mainly fence posts, palisades and domestic fences, is however slightly increasing. Apart from the use of pressure treatments ...
R Cockcroft, H Willeitner
Effect of wood species on colonization by an unknown wood boring organisms in marine waters
1995 - IRG/WP 95-10108
The effect of wood species on the initial settlement by surface fouling organisms in marine environments was investigated by exposing heartwood panels of Douglas-fir ((Mirb.) Franco), western redcedar (Donn.), and Oregon white oak (Dougl. ex. Hooke) in an estuary located on the coast of Oregon. The oak and western redcedar panels were sparsely colonized over the first 39 days of exposure, while th...
K S Rao, P F Schnieder, J J Morrell
Colonization of treated and untreated ponderosa pine exposed in Hilo, Hawaii
1995 - IRG/WP 95-20068
The rate of decay in above ground exposures is largely controlled by rainfall and temperature, factors which can be used to construct a climate index of decay hazard in above ground exposures. Developers of new biocide formulations have utilized this knowledge by establishing test sites in sub-tropical regions such as the Gulf Coast of the United States. More recently, field sites have been locate...
C M Freitag, J J Morrell, K J Archer
Arbeitsverfahren zum Herstellen und mikroskopischen Auswerten von Dünnschnitten aus Holz-Bohrkernen. [Working method for producing and evaluating microscopically thin cuts of bore samples]
1980 - IRG/WP 2133
Bore samples are important specimens; e.g. they are in use to investigate poles in service. On the basis of known methods of microtomy a technique is described which permits the production of longitudinal cuts from bore samples. For this purpose, the bore sample is glued onto a mounting; the surface of cut is coated with a polystyrene solution. The cut thus consolidated can be stained, drained, an...
S Cymorek
The lasting dehydration of wood treated by bifluorides worked up in Diffusec noticed by a continual drying of the wood
1999 - IRG/WP 99-30196
After an immersion of sound wood in a solution of Diffusec, in which a combination of acid potassium and ammonium bifluorides = FHF- in dissociated form is present, their potassium and ammonium fluoride ions together with the bifluoride ion = (FHF-) diffuse into the wood. They make use of the woodmoisture available as O-H-O bonds directly attached to the cellulose in the wood fibres to attract the...
H F M Nijman
The ecotoxicology assessment of wood preservatives and their active ingredients by means of germination tests using cress - A critical consideration
1999 - IRG/WP 99-50125
With putting the Biocidal Products Directive 98/08/EC (BPD) in place an environmental risk assessment for wood preservatives and impregnated timber is requested. To assess possible risks, suitable test methods are required, which reveal the ecotoxicological profile including environmental fate and behaviour of treated commodities. Germination and growth tests could contribute to the determination ...
P Jüngel, A O Rapp, E Melcher
Investigations into the biology of Meruliporia incrassata
2004 - IRG/WP 04-10508
The dry rot fungus Meruliporia incrassata (Berk. and Curt.) Murr. is a highly destructive brown rot wood decay fungus and is a significant pest of wooden structures. The fungus, know commonly as ‘Poria’, is characterized in culture by strand mycelium and skin-like surface mycelium. In structural environments it is found to produce prominent water conducting rhizomorphs, is a copious spore prod...
J Jellison, C Howell, B Goodell, S L Quarles