Your search resulted in 1355 documents. Displaying 25 entries per page.
Performance of Oriented Strandboard, Medium Density Fiberboard, Plywood, and Particleboard Treated with Tebuconazole in Supercritical Carbon Dioxide
2005 - IRG/WP 05-30364
The performance of oriented strandboard (OSB), medium density fiberboard (MDF), particleboard and plywood treated with tebuconazole using supercritical carbon dioxide was investigated over a 48 month exposure under harsh above ground conditions in Hilo, Hawaii. Samples treated to low retentions (<0.20 kg/m3) tended to experience decay at rates that were only slightly lower than those found wit...
J J Morrell, M N Acda, A R Zahora
Performance of Borate-Treated Wood Against Reticulitermes flavipes in Above-Ground Protected Conditions
2003 - IRG/WP 03-30309
Termites cause economically significant damage in Canada only in a few localized areas. However, one of those is in Canada’s largest city, Toronto, Ontario. In 1996, a test was set up of borate-treated lumber above ground, protected from rain but exposed to subterranean termites (Reticulitermes flavipes) in Kincardine Ontario. The material included western hemlock and amabilis fir lumber trea...
P I Morris, J K Grace, K Tsunoda, A Byrne
Hardwood Field Experiment: Progress Report 1977-1986
1986 - IRG/WP 3391
The international hardwood field experiment was planned in l976 and set up in same 30 different sites around the world. The test stakes include 4 reference species common to each site and in most cases at least 2 species of local importance. It was hoped that a picture of performance of a range of economically important species would be built up and at the same time provide vital background inform...
D J Dickinson, S M Gray
The new method of detecting decay in poles
1984 - IRG/WP 2229
In 1982 the Swedish Telecoms Administration in corporation with the Swedish Dog Training Centre started to investigate the possibility of using dogs for detecting decay in poles. At present two German Sheppheards and two Labrador Retrievers are in operation and the results have up to now well fulfilled our expectations. The following results have been obtained: 1.) The dogs can with high reliabili...
A Ammer, B Svedberg
Effect of compression wood on leaching of chromium, copper, and arsenic from CCA-C treated red pine (Pinus resinosa Ait.)
2000 - IRG/WP 00-30232
In this study, the effect of compression wood formation on the release rate of chromium, copper, and arsenic elements from red pine (Pinus resinosa Ait) was investigated. Wood blocks from red pine containing compression and normal wood portions were treated with a 1.0% CCA-C solution and were then allowed to fix at 23 ± ??2°C (74 ± 4°F) for 0, 6, 24, 48, 96, 192, and 336 hours. After each fixa...
S N Kartal, S T Lebow
Industrial fixation of chromium based wood preservatives
1990 - IRG/WP 3630
Fixation is an abstract and non-defined process. Nevertheless it is a specified requirement in most impregnation standards. The impregnation industry is facing increased pressure to deliver fixed products and to increase the safety of the handling of impregnated products. Industrial fixation of impregnated wood can be obtained by using different methods. The purpose of the process is to transform ...
T Christensen
International standards - can we make them simple? Stage 2: Reflection arising from the discussion at IRG 27
1996 - IRG/WP 96-20103
For the purpose of the ISO FAST TRACK project on preventive wood protection and durability, one shall refer to the 3 following stages:
Hazards: (for wood in service), a review of biological agencies defining the scope;
Exposure: a review of local, geographical parameters influencing the virulence of biological agencies towards wood in service (i.e climate indexes);
Risks: as a combination of ha...
G Ozanne
A diffusion and reaction model for the leaching of Cr-VI from unfixed CCA-treated wood
2001 - IRG/WP 01-50169
A physical model applicable to the leaching of any substance undergoing a first-order fixation reaction with wood is presented. Using this model and a laboratory leaching experiment with small wood samples immersed in water, the radial and tangential diffusion coefficients and the reaction rate constants of Cr-VI in unfixed CCA-treated red pine (Pinus resinosa Ait.) are measured. Reaction rate con...
L Waldron, P A Cooper
Proceedings from the wood preservation symposium "The Challenge - Safety and Environment" 19-20 February 1990, Cannes, France
1990 - IRG/WP 3600
Contains the List of Participants and the following 29 Documents (IRG/WP/3562-3590):
Canadian code of good practices - Recommendations for design and operation of wood preservation facilities. (IRG/WP/3582)
Current models used by the European health authorities to evaluate the vililization of active ingredients from treated wood used inside dwellings. (IRG/WP/3565)
Creosote and cancer. (IRG/WP/...
Anonymous
Preservative technique of three commercially important timber species –
Sissoo (Dalbergia sissoo), Akasmoni (Acacia auriculiformis) and Ghoraneem (Melia azedarach) of Bangladesh
2005 - IRG/WP 05-40299
Wood is renewable resource and is widely used as construction material in rural and urban areas of Bangladesh. Dalbergia sissoo, Acacia auriculiformis and Melia azedarach, locally known as Sissoo, Akasmoni and Ghoraneem respectively are three important timber species of Bangladesh. These are used for different purposes normally without preservative treatment. Heartwood of Sissoo, Akasmoni and Ghor...
M R Bulbul, M O Hannan, P K Sarker, A A Mahafuz, G N M Ilias
Remediation of wood treatment sites in Finland
1999 - IRG/WP 99-50139
Finnish legislation in connection with soil contamination are firstly waste management legislation and secondly public health legislation and water legislation. There is no separate legislation concerning soil protection or remediation. The Ministry of the Environment has published a proposal for official contaminant guideline values to be used both as criteria for contamination and clean-up targe...
S Salonen
Biological and physical properties of phenolic-resin treated wood before and after natural weathering
1999 - IRG/WP 99-40132
Biological and physical properties of phenolic resin-treated particleboards, which were made from fast growing tress and agrowaste as raw materials, were evaluated before and after natural weathering in tropical climate. The particles were sprayed with a mixture of a low molecular weight phenol-formaldehyde resin (5.0, 7.5 and 10% loading) and the adhesive phenol resin (8% loading). Results with l...
S Yusuf, Y Sudiyani, H Kajita, Y Imamura, M Takahashi
Kerfing and center-boring reduce checking in CCA-treated slash pine posts
1997 - IRG/WP 97-40082
Single and double kerfing, center-boring and incising were applied to green, peeled, slash pine posts. Posts were air dried for ten weeks and assessed for the number of surface drying checks greater than 1.0 mm in width. Posts were then pressure treated with a chromated-copper-arsenate (CCA-C) preservative and exposed outdoors in a horizontal position. The number of surface weathering checks in th...
P D Evans, R Wingate-Hill, R B Cunningham
Preservative treatment of green timber by soaking in ammoniacal copper borate
1984 - IRG/WP 3292
Freshly sawn boards of radiata pine sapwood were preservative treated by soaking in ammoniacal copper borate. Optimum schedules were obtained by partially seasoning the boards for one week prior to treatment. This aided the absorption of preservative and reduced the required soaking time to approximately 2 hours. Complete boron penetration was obtained after one week of block storage under cover a...
P Vinden, A J McQuire
Development of software to automate the quantification of checking occurring in preservative treated wood exposed to weathering
2001 - IRG/WP 01-20228
Surface checking often disfigures the appearance of wood treated with water-borne preservatives and treatments designed to reduce such checking have been receiving increasing attention. Progress in this area has however been slowed by the lack of a method of rapidly and accurately quantifying checking at treated wood surfaces. A software package has therefore been developed which identifies, measu...
A G Christy, P D Evans
Microdistribution of Copper in Copper-Ethanolamine (Cu-EA) Treated Southern Yellow Pine (Pinus spp.) related to density distribution
2004 - IRG/WP 04-40270
The relationship between copper absorption and density distribution in wood cell walls was investigated in this study. The density distribution on layer level was obtained from two approaches: (1) calculation by using data obtained from literature; (2) microdistribution of carbon and oxygen atoms in the wood cell. The microdistribution of carbon and oxygen in untreated southern yellow pine (Pinus ...
Jinzhen Cao, D P Kamdem, E Pasek
Mechanical properties of CCA-treated southern pine after post-treatment kiln drying
1989 - IRG/WP 3543
This report reviews current research dealing with the effects of waterborne preservative treatment and redrying on the mechanical properties of wood. In general, waterborne preservative treatments reduce average mechanical properties. This effect is exaggerated when treated wood is kiln-dried after treatment, especially at elevated temperatures. For lumber, recently completed research at the Missi...
H M Barnes, J E Winandy
Thermotolerant moulds on timber during kiln drying
1980 - IRG/WP 1109
In recent years a special disease named the wood trimmer's disease has been observed with increasing frequency among saw mill workers. Particularly workers in the trimming department have been affected. The medical symptoms are usually high fever, ague headache, pain in muscles and joints. It was shown that the disease was of immunologic nature and caused by over-exposure to spores from m...
B Henningsson
Environmental aspects of wood preservation
1987 - IRG/WP 3406
The preservation industry employs a wide range of chemicals and processes to provide timber commodities capable of resisting biodeterioration and degradation. The public often perceives the chemicals as health hazards and treatment plants as potential threats to the environment. This paper attempts to place in proper perspective the value of wood preservation. It discusses aspects of health and sa...
H Greaves
Evaluation of impact of CCA-treated wood on the marine environment
1995 - IRG/WP 95-50040-15
This paper reviews the literature relating to the potential of CCA-treated wood to affect the marine environment and outlines the compounds required for a model which could be used to predict the environemental impact of maritime construction using such timber. Marine pilings require high loadings of CCA to provide protection from marine borers. Though loadings of 32-48 kg/m³ provide long-term pr...
R M Albuquerque, S M Cragg
The use of the Sentricon Termite Colony Elimination System for controlling termites in difficult control sites in Northern California
2000 - IRG/WP 00-10361
Some termite elimination trials in Northern California with the Sentricon Termite Colony Elimination System are presented - one of a large establish-ment, one of a single family residence with a long history of termite damage, one with a single family residence where other chemical treatments had repeatedly failed, and one single family residence in which the termites had not reached the house but...
D H Kistner, R J Sbragia
Evaluation of fluid distribution in pressure treated wood in different flow directions
2004 - IRG/WP 04-40281
Among different methods, polymerization technique was chosen to study distribution of fluid through cell types in treated wood. Red maple wood specimens with the size of 2 by 2 by 4 cm (radial, tangential and longitudinal, respectively) were prepared. Styrene monomer was used as the fluid for impregnation; because its physical properties such as surface tension, specific gravity and viscosity fall...
A Omidvar, M H Schneider
The Disposal of CCA-Treated Wood in Simulated Landfills: Potential Impacts
2003 - IRG/WP 03-50198
Landfills are typically where CCA-treated wood is currently disposed, and will likely continue to be the primary form of management in the future. It has been shown that arsenic, copper and chromium leach from CCA-treated wood in certain situations; however, the impact of the disposal of CCA-treated wood on landfill leachate is currently unknown. The objective of this research is to examine the po...
J Jambeck, T G Townsend, H M Solo-Gabriele
IRG/COIPM INTERNATIONAL MARINE TEST - to determine the effect of timber substrate on the effectiveness of water-borne salt preservatives in sea-water. Progress Report 11: Report of fourth inspection (3 years) in Italy
1981 - IRG/WP 471
The wood samples of Alstonia scholaris, Fagus sylvatica, Pinus sylvestris were submerged in the sea at Follonica, Italy, in Apri1 1977. Follonica, latitude 42°55' North and longitude 10°45' East, is situated on the Tyrrhenian coast. The recorded temperature varies from 13°C td 25°C, salinity 37- 38%. and pH about 8. The inspections were carried out after 6 months (10/1977), 1...
A Gambetta, E Orlandi
Wood preservation in Iran
1984 - IRG/WP 3270
The report sketches the history of the use of wood in Iran to the establishment of the country's national forest service and gives some figures for Iran's timber needs by the year 2000. Progress in wood preservation has been slow, although items such as railway sleepers and poles have been pressure treated since the first pressure impregnation plant was erected in 1932. Today the...
P Niloufari, R Cockcroft