Your search resulted in 1043 documents. Displaying 25 entries per page.
Internal pressure development in Douglas fir lumber during pressure treatment
1997 - IRG/WP 97-40091
Preservative treatment of Douglas fir lumber to meet current industry standards poses a major challenge and a variety of methods have been developed to overcome these problems. One aspect for treatment improvement that has received less attention is the relative effect of treatment parameters on changes in pressure within the wood. Previous studies of spruce and radiata pine suggest that internal ...
P F Schneider, J J Morrell
Accidental mold/termite testing of high density fiberboard (HDF) treated with borates and N’N-naphthaloylhydroxylamine (NHA)
2003 - IRG/WP 03-10462
High density fibreboard (HDF) was made from beech and pine furnish (50:50) and treated with boric acid (0.1-3%), borax (0.1-3%) or N'-N-(1,8-naphthalyl) hydroxylamine (NHA) (0.1-1%) prior to gluing with urea formaldehyde (UF) resin in order to determine resistance to Eastern subterranean termites (Reticulitermes flavipes Kollar), the most economically important termite species in North Am...
S N Kartal, H H Burdsall Jr, F Green III
Performance of preservative-treated timber commodities in above-ground service tests
1995 - IRG/WP 95-20064
Service tests established by NZ FRI are of commodities where treatment has been undertaken in commercial plants and although such data as preservative uptake of individual items is recorded and sample analysis undertaken, material is usually "run-of-mill" for the commodity being treated. The NZ FRI Service Test database includes a wide range of preservative/species combinations in virtually all ab...
M E Hedley, D R Page
Major insects attacking timber used for building purposes and a practical approach for their control
1990 - IRG/WP 1449
Lignocellulosic materials like wood, bamboos, palmyra palms, reeds, leaves and grasses have been the oldest materials used by human beings. Although with the rapid pace of industrialisation, specially in several western countries, wood began to be replaced with alternative materials like cement, steel etc. yet its use has not vanished even in highly developed countries. Some of the reasons for thi...
V R Sonti, B Chatterjee
Protection for whole-of-house timbers from subterranean termites in Australia
2005 - IRG/WP 05-20315
A field study was designed to increase maximum protection of whole-of-house timbers against subterranean termites. Concrete slab and suspended floor simulated houses were constructed using untreated and treated (slow acting toxicants) timber frames. The treated and untreated timber structures within the simulated houses were exposed with or without soil chemical and/or physical barriers in the fie...
B M Ahmed, J R J French, P Vinden, P Blackwell, J Hann
Administration of wood preservative usage in New Zealand
1977 - IRG/WP 395
Principal administration of the preservative treatment of timber in New Zealand is by the Timber Preservation Authority (TPA). The TPA was established in 1955 by Act of Parliament and is under the jurisdiction of the Minister of Forests who appoints its members. Its field staff are Forest Service employees. The Authority comprises twelve members and includes representatives of timber trade associa...
M E Hedley
Investigation of copper fixation in timber by sodium nitrit
1992 - IRG/WP 92-3707
Solutions containing mixtures of water soluble copper salts and sodium nitrite have been shown to be capable of producing leach resistant copper treatments when impregnated into timber. A rapid leaching trial showed that copper fixation levels of 85-90% were possible which compared well with the fixation level obtained with conventional hexavelant chromium containing systems in the same test regim...
C Waldie, J A Cornfield
Treatment of wood by diffusion of salts
1976 - IRG/WP 368
A brief survey is given on the treatment of wood by diffusion of salts. The compounds used for this process, mainly boron and fluorine compounds, are mentioned and the factors influencing diffusion described. The main pre-condition is a high moisture content of the wood of above 40%. Fields of application are fresh roundwood, remedial treatment of poles and sleepers, preservation of posts and espe...
G Becker
Three-dimensional modeling of fumigant distribution in wood poles
1993 - IRG/WP 93-30025
The practice of using fumigants to control internal decay has been widely accepted in the United States and has shown to be effect in control internal decay in transmission poles and other large wood timbers. Mathematical models were developed to simulate the chloropicrin movement in utility poles after treatment. The simulation results indicated that treatment of utility poles, using either tradi...
Jing Liu, B Goodell
A new vacuum/pressure plant system
1988 - IRG/WP 3479
In the subtropical regions, the problem of wood supplying becomes more and more difficult to be solved. In that context, the Centre Technique Forestier Tropical had paid a particular attention to the valorization of products issued from plantations in dry zones of Africa. In these plantations, the products of clearings can be used as fencing, stakes or for traditional construction. However in thes...
C Dalois, R Schwartz, G R Y Déon
Recycling of impregnated timber: Part 1: Crushing, combustion plants, amount, costs and logistics
1999 - IRG/WP 99-50131
The object of the recycling research was to determine the technical and economical requirements of recycling of CCA-impregnated wood. The safest and most effective way is to crush impregnated timber in a stationary crushing plant where the reclaiming of dust is managed. The combustion techniques designed to burn solid Finnish combustible matter are applicable to burn crushed impregnated timber. Be...
T Syrjänen
Evaluation of the effectiveness of Tuff Brite C in the control of sapstain in laboratory and field tests
1992 - IRG/WP 92-3718
Since 1990, the anti-sapstain product Tuff Brite C (ASC 66898) has been evaluated internationally in laboratory and field tests, and has been commercially introduced in New Zealand. The product is an aqueous flowable formulation of chlorothalonil and carbendazim. Efficacy tests which have been carried out in New Zealand, Australia, USA, South Africa and Europe are described and summarized. Tuff Br...
T L Woods, C J Klaver
The effect of copper/chrome/arsenic (CCA) treated timber on soil fungi
1981 - IRG/WP 1131
The aim of this investigation was to study the effect of CCA treated wood on the microflora of soil with particular reference to copper tolerant soft rot fungi. The IRG collaborative field experiment was designed to monitor the performance of a range of preservative treated hardwoods with particular reference to soft rot in CCA treated timber (Dickinson 1976) and site 33 of this experiment was use...
R J Murphy, D J Dickinson
Multiple-Phase Pressure (MPP) Process: One-stage CCA treatment and accelerated fixation process. 4. MPP compared with other processes for achieving acceptable treatment of radiata pine heartwood
1998 - IRG/WP 98-40115
Although radiata pine sapwood is very amenable to preservative treatment, it is often difficult to achieve the required standard for heartwood treatment.
A preliminary investigation showed that to achieve the NZ Timber Preservation Council minimum penetration requirements for radiata pine heartwood using the Multiple-Phase Pressure (MPP) Process, a hydraulic pressure of at least 1250 kPa for 20 m...
K Nasheri, J A Drysdale, G Durbin, M E Hedley
Laboratory evaluation of water repellents as antisapstain treatment additives
1986 - IRG/WP 3382
Water repellent formulations consisting of five paraffin wax emulsions, three polyethylene wax emulsions, two polybutadiene resin emulsions, a polyester emulsion, and a ß-pinene polymer emulsion were subjected to water repellency tests on radiata pine sapwood. With one exception, the parafin wax emulsions were more effective water repellents than the alternative formulations and one of the paraff...
D V Plackett, C M Chittenden
The effect of synthetic pyrethroid insecticides on post-treatment emergence of Anobium punctatum
1992 - IRG/WP 92-1568
Data is presented from trials in which wood specimens, treated with a range of remedial insecticidal formulations, were aged in a roof void for 5 years and then tested for emergence of adult Anobium punctatum. The technique used followed that described in IRG/WP/2175. The results from formulations containing synthetic pyrethroids are compared with those from formulations containing the chlorinated...
R W Berry
Changes in some important mechanical and physical properties of untreated and treated mining timber after exposure to the conditions of a colliery
1996 - IRG/WP 96-20082
Each of salt treated and untreated mining timber (wedge) pairs with 5x15 cm² cross-section and 155 cm length prepared from Scots pine, Bornmüller's fir and oriental beech was cut in the small standard test specimens to determine changes in some important mechanical and physical properties, 13 month after exposure to the conditions of Kozlu Hard Coal Mines in the depth of 52 m. Thus, the...
A Bobat
Treatment groups and remedies for CCA treated hardwood and softwood poles
1999 - IRG/WP 99-40142
Different hardwood and softwood species from Bangladesh and Bhutan was investigated regarding density, green fiber stress, natural durability of heartwood and CCA treated sapwood, CCA treatability grades, sapwood thickness, and kiln-drying properties for long term use as electric poles. These properties along with the past service records for nineteen years, separated ten heardwood and five softwo...
A K Lahiry
Long-term preservation technology for a large-scale timber structure building in Japan
2001 - IRG/WP 01-40203
Several 1.000-year-old Buddhist temples and shrines built of wood are surviving in Nara, some areas of which are inscribed on the World Heritage List. These old buildings are indicative of excellent timber construction technology having existed in ancient Japan, though it is thought that such technology has not been handed down. This paper introduces one of large-scale wood buildings built in rece...
Y Iimura
Surface checking of CCA-treated radiata pine decking timber exposed to natural weathering
2000 - IRG/WP 00-40165
A field trial was established at four locations in Australia to assess the effect of CCA and CCA-wax treatment on the checking (cracking) of radiata pine decking timber exposed to natural weathering. Untreated decking timber and timber that had been pressure treated with water acted as controls. After 1 year's exposure the number and sizes of checks occurring in treated timber and control...
P D Evans, P J Beutel, C F Donnelly, R B Cunningham
Thickened boron treatment
1990 - IRG/WP 3632
Commercial trials with thickened boron preservatives "Diffusol™" indicate a number of advantages when compared to traditional methods of dip-boron preservative treatment. These include: (i) more even uptake and distribution of preservative on and within the timber; (ii) faster diffusion times; (iii) the treatment of gauged timber (though improved retention); (iv) saving in energy costs (heating ...
P Vinden, J A Drysdale, M Spence
The development of a new boron-based wood preservative
1995 - IRG/WP 95-30085
The paper describes a new boron based wood preservative for the treatment of green timber. The product offers many benefits over conventional boron diffusion treatment including: 1. high viscosity, high concentration formulation; 2. permits dip treatment of a wide range of sawn board and pole sizes at ambient temperatures; 3. permits full cross section diffusion of borates without block stacking a...
P Turner, D Conradie
Treatment of wood with boron esters
1995 - IRG/WP 95-30087
The treatment of wood and wood products with boron esters is reviewed. The physical and chemical characteristics of boron esters affecting the treatability of wood are discussed, in particular thermal decomposition and rates of hydrolysis. The uses and methods applying boron esters as wood preservatives include: (i) Solutions of boron esters for remedial and diffusible treatment of wood; (ii) soli...
J Romero, P Vinden, J A Drysdale
Gaseous preservative treatment of wood
1990 - IRG/WP 3631
A recent development in processing wood with a gaseous preservative means that dry, treated wood can be produced in under 30 hours with the benefits of product diversification, faster stock turnover and the ability to respond to short term demand. About 400,000 m³ of wood are treated each year in New Zealand with boron salts to protect from borer infestation. Traditionally this treatment is effec...
R Burton, A J Bergervoet, K Nasheri, P Vinden, D R Page
A new factory applied preservative treatment for joinery
2002 - IRG/WP 02-40246
Conventional pre-treatment processes involve the principle of applying preservatives to the external surfaces of wood to achieve the necessary penetration and retention of the chemicals although the heartwood remains difficult to treat.
The present development involves the production of internal reservoirs within new joinery components, which are subsequently filled with a specially developed g...
I M Robertson, W Beauford