Your search resulted in 1025 documents. Displaying 25 entries per page.
Development of procedures for sampling, testing, and classification to determine the biological durability of wood and wood products
2020 - IRG/WP 20-20676
This paper informs about a research project, which deals with several shortcomings and a lack of clarity within EN 350:2016. The project started in January 2020, will run for 3 years, and is operated by the Institute of Wood Technology Dresden (IHD) and the University of Goettingen (UGOE).
Determination and classification of durability of wood and wood products against wood-destroying organisms ...
W Scheiding, K Jacobs, S Bollmus, C Brischke
Monitoring uptake and penetration of pesticides during impregnation of pine (Pinus sylvestris) and spruce (Picea abies) wood with bio-based microemulsion gel formulations
2020 - IRG/WP 20-30756
Even in dry state wood is susceptible to biological degradation. Preservation against biological decay in exposed conditions is conventionally achieved by impregnating the wood with pesticides applied at professional and industrial levels. Impregnation of wood with preservatives is a complex process that involves wood macro- and microstructure, and the physical characteristics of woods. Here we fo...
D Messaoudi, K Ruel, J-P Joseleau
Assessing the risk of marine borer attack of the timber trestles and decay of timber above the intertidal zone of the Barmouth Viaduct
2021 - IRG/WP 21-10974
The Barmouth Viaduct is a Grade II* listed structure which carries the single track of the Dovey Junction to Pwllheli line and footway over the Mawddach estuary. It is in a marine environment where timber below the high tide mark is at most risk in Use Class 5 and all timber above in Use Class 3.2, permanently exposed to the risk of wetting. The structure consists of a timber trestle viaduct of ...
J R Williams
Validating a short-term laboratory method to assess the resistance of timber to biodegradation by marine wood-borers
2021 - IRG/WP 21-10975
Novel approaches to protecting wood in coastal and marine environments are needed as the use of traditional broad-spectrum biocides are now restricted. Wood is widely utilised in marine environments where it can be rapidly degraded by wood-boring organisms, causing billions of dollars of damage per annum. Biocidal compounds such as CCA and creosote have been popular treatments for timber products ...
L S Martin, J R Shipway, G P Malyon, S M Cragg
Estimation of residual compressive strength on cross laminated timber with biodeterioration damage
2021 - IRG/WP 21-40918
CLT is susceptible to biodeterioration such as fungal decay and termite attack during long-term use for buildings. It is necessary to know the residual strength performance of biodegraded CLT for estimating future performance and aging of CLT. In this study, compression tests of CLT damaged by brown rot fungi and termites were conducted to clarify the relationship between residual strength and mas...
R Inoue, T Mori, K Kambara, W Ohmura
Preliminary investigation for preservation method of CLT using non-pressure treatment
2021 - IRG/WP 21-40919
Cross-laminated Timber (CLT) is increasingly being used in residential and non-residential construction around the world, and some of these areas are at high risk of biodeterioration. Addition to moisture management of construction, preservative treatment of CLT may be needed to prevent decay and termite attack in the area. Pressure treatment being most reliable, is not feasible due to the large d...
T Miyauchi, Y Ohashi, J Miyazaki, R Takanashi, H Shibui, S Isaji, T Shigeyama, Y Sugai, A Yamamoto, T Hramiishi, T Mori, H Matsunaga
Treatability of South African-grown Eucalyptus grandis with water-borne copper azole and disodium octaborate tetrahydrate wood preservatives
2021 - IRG/WP 21-40920
This study investigated the treatability of the sapwood and heartwood of sawn Eucalyptus grandis with copper-azole (CuAz) and disodium octaborate tetrahydrate (DOT) water-borne preservatives towards improving its durability for enhanced use in structural solid wood applications. The results obtained showed that, at a moisture content of 12 ± 1%, sawn E. grandis sapwood can be impregnated to a mea...
A A Alade, Z Naghizadeh, C B Wessels
Carbon footprint of a cross laminated timber building – Torvbraten school case study
2021 - IRG/WP 21-50366
Torvbråten school is a public school in Asker, Norway, that has reached many sustainability goals. The school was the second in Norway to have Nordic Swan Ecolabel and has a 60 % reduction in carbon footprint compared to the reference benchmark. The building is made of cross laminated timber (CLT) and extensive wood use in general. From a wood protection viewpoint, will this sustainability sustai...
L G F Tellnes, J K Naess, M R Hanssen, P-O Flate
Efficiency of three resin fractions from Aucoumea Klaineana Pierre, Canarium schweinfurthii Engl and Dacryodes edulis (G. Don) H. J. Lam from Gabon combined with Tebuconazole as wood preservatives
2022 - IRG/WP 22-10998
Pure resins from Aucoumea Klaineana, Canarium schweinfurthii and Dacryodes edulis were harvested and then hydro-distilled to obtain essential oils and purified resins fractions. Due to the potential leaching and volatility hazards of the compounds that constitute these fractions, resins and essential oils were combined with tebuconazole to produce both antifungal and anti-termite wood preservative...
W F Bedounguindzi, K Candelier, P Edou Engonga, S Dumarcay, M-F Thevenon, P Gerardin
Evaluation of ecotoxicological effects of different coniferous wood treatments on two marine bioindicator species
2022 - IRG/WP 22-10999
Coniferous wood panels (Picea abies) were treated with two concentrations of copper-based impregnating agent to increase its durability in marine and brackish environment. In order to assess the environmental compatibility of the treatments a laboratory experiment was conducted with two marine invertebrate species: bivalve Mytilus galloprovincialis and a gastropod Steromphala albida. The bioindica...
T Marčeta, N Nesto, I Guarneri, D Tagliapietra, V Moschino
Application of an Ultrasound-based Instrument to Evaluate Condition of Drywood Termite Infested Timber Components
2022 - IRG/WP 22-11000
The characteristics of ultrasound waves propagation from non-destructive ultrasound-based instrument on drywood termite infested wooden components were investigated. Features of wave propagation such as time-of-flight, velocity, and peak energy on three orthogonal wooden plane (longitudinal, radial, and transversal) were studied. The wooden components used on this study came from a traditional woo...
S Fauziyyah, L Karlinasari, D Nandika, R Wimmer
Evaluation of Decay Resistance of Copper-based Preservatives Treated-Wood exposed to different field test sites in Korea
2022 - IRG/WP 22-20679
In Korea, preservative treated wood is required to have a stamp on the surface which contains information such as wood species, use categories, and the company that treated the wood. Such stamping is necessary to safely and appropriately use the treated wood. Since majority of treated wood is being used outdoor environment, the treated wood must have efficacy against wood decay fungi or termite. I...
W-J Hwang, S-M Yoon, Y Park, Y-S Choi, H-M Lee, J-W Kim
Discrimination of five commercial wood preservatives by handheld near-infrared spectrometers and Multivariate Data Analysis
2022 - IRG/WP 22-20686
Nowadays, the recycling potential of wood waste is still limited, because of a lack of reliable lack of a reliable and fast device allowing the discrimination of preservative-treated wood that contains organic or/and inorganic contaminants. The purpose of this study was to set up a methodology, based on a SCiO low-cost handheld NIR spectrometer, and multivariate data analysis (MDA). Spectra was ob...
M Rubini, P Dulucq, B Charrier
Using satellite-retrieved soil moisture data to model the decay risk of in-ground timber
2022 - IRG/WP 22-20689
Satellite-derived soil moisture data from the Soil Moisture Active Passive (SMAP) was extracted for a 9 x 9 km point grid over Europe. The data was then used as input to a dose-response wood decay model based on terrestrial microcosm (TMC) tests. The resulting hazard map plotted dose as an indicator of in-ground wood decay based on differences in annual temperature and soil moisture characteristic...
P B van Niekerk, M Schönauer, B N Marais, C Brischke
Analysis of wooden shingles after seven years of exposure
2022 - IRG/WP 22-20690
Wood is a traditional roofing material in the Alpine regions. In the 17th century, wooden roofing was typically used on more important buildings. Still, today it is predominately used on huts and houses in the hilly regions of northern and north-western Slovenia. Because wooden roofing is expensive, we investigated the possibility of extending the service life of the roofing through impregnation a...
M Humar, B Lesar, D Kržišnik, E Keržič, B Jemec
Comparative study on the efficacy of biobased wood preservative over conventional wood preservatives against fungi and termites
2022 - IRG/WP 22-30761
The current focus of wood preservation research is on developing wood preservatives from natural and environmentally compatible compounds for industrial application. Liquefaction of wood is one of the promising approaches to utilize woody waste where the wood powder is converted into a chemically active liquid with the help of a liquefying agent like phenol, cresol, plant-based solvent as CNSL and...
A Kumar, A John, B N Hazarika
Post-layup protection of mass timber elements in above ground protected exposures: 2-year results
2022 - IRG/WP 22-30766
Mass timber has seen increased use as a building material for low and mid-rise construction in recent decades. The durability of mass timber elements has not been fully examined and the effects of wood destroying organisms on this these materials merits attention. The effectiveness of currently labeled soil termiticides and passively applied biocides at post-construction or as remedial agents need...
M E Mankowski, T G Shelton, G T Kirker, J J Morrell
Effect of nano-particle characteristics and concentration on UV protection of timber: A field exposure test
2022 - IRG/WP 22-40941
Wood has a well-known susceptibility to ultra-violet light degradation, leading to premature replacement. A variety of products have been developed to protect against this damage, but most provide less than 12 months of protection and must be regularly reapplied. Developing improved coatings would help reduce wood losses and reduce maintenance costs. Nano-particles have a variety of attractive pro...
T Yi, J J Morrell
Utilization of Pressure Treated Lumber in Cross Laminated Timber Manufacture and its Impact on Bondline
2022 - IRG/WP 22-40953
Mass timber building construction is increasing dramatically across North America which presents challenges to these structures not seen in Northern Europe. Large parts of the United States harbor termites and existing mass timber building technologies that rely solely on moisture exclusion to increase durability are insufficient in these areas. The successful expansion of mass timber construction...
G Presley, C Wainscott, J Valenti, S Noble
A Comparison of Cross-Laminated Timber (CLT) Floor Panels using Finite Element Analysis and Experimental Fire Testing
2022 - IRG/WP 22-40955
Cross-laminated timber (CLT) is a relatively new timber product and has gained popularity in North America and Europe as a construction material. As a sustainable engineered timber product, CLT offers many advantages over solid wood, concrete, or steel construction. However, the use of timber in medium to high rise buildings is often avoided mainly due to its combustible nature. In this paper, a n...
M Yasir, A Macilwraith, K Ruane
The influence of climate changes on Central European forests with an emphasis on Slovenia
2022 - IRG/WP 22-50368
When forests are managed sustainably, they play an essential role in protecting climate and biodiversity. They protect soils and water resources, provide livelihoods, and contribute to the well-being of rural and urban communities. European forests are multifunctional and provide a range of ecosystem services. These include the production of renewable materials that can replace materials with a la...
J Gričar, L Krajnc, M Westergren, S Rus, H Kraigher
Sustainable wood products development in a bio-refinery perspective: case studies in French Guiana
2022 - IRG/WP 22-50370
French Guiana, by its belonging to the Amazon region and the Guiana shield, has very specific environmental and social characteristics in the French regional ensemble. In this context, it is thus necessary to find how to reconcile the economic development of the territory, the conservation of biodiversity and the recognition of local knowledge and practices. Bringing together multidisciplinary ski...
E Houël, N Amusant, J Passelande, J Bossu, R Lehnebach, E Wozniak
Make do and mend: Re-using timber in Smithfield Market
2022 - IRG/WP 22-50371
Historic buildings are part of our built environment. They are a record of how construction and use of materials have evolved and provide excellent opportunities for regeneration of urban areas. Moreover, re-using these buildings and as much of the material within, contributes to the Green Revolution.
Currently, there is tremendous growth in green construction and as Bob Dylan once said, “the t...
J R Williams
A novel method for assessing radial variation in termite resistance of timber
2023 - IRG/WP 23-11005
Australia has many timbers whose heartwood is highly resistant to fungal and termite attack; however, changing public policies have resulted in restricted access to many native forests where these species are found. Plantations of these same species are expected to replace these resources, but there are questions concerning whether timber from these trees will have the same resistance as the nati...
S Kleinschmidt, R McGavin
They might be boring: pests of timber-in-service deserve more attention
2023 - IRG/WP 23-11007
Insects affecting timber-in-service, particularly bostrichid borers and termites, are among the most frequently intercepted organisms at international and national borders, associated with wood packaging, wooden furniture and artefacts, and timber and timber products. There are more than 25 non-native insect species in the Bostrichidae, Ptinidae, Cerambycidae and Kalotermitidae, and at least 12 no...
H F Nahrung, F Tovar, A Carnegie