Your search resulted in 661 documents. Displaying 25 entries per page.
Remedial wood preservative efficacy of BORA-CARE against the Formosan subterranean termite and eastern subterranean termite (Isoptera: Rhinotermitidae)
1991 - IRG/WP 1504
When a spruce board (3.8 cm x 8.8 cm x 2.4 m) was surface-sprayed with BORA-CARETM solution (containing 23% disodium octaborate tetrahydrate) and stored in an air-conditioned room (24 ± 2°C and 60 ± 5% RH) for eight months, ca. 40% of the wood (measured by the cross section surface proportion) contained borates at the rate of >2,500 ppm BAE (boric acid equivalent). In a choice bioassay, term...
N-Y Su, R H Scheffrahn
Fungicidal properties of wood tar being a side product of pyrolysis of previously treated wood with preservatives
2004 - IRG/WP 04-30340
The objective of the paper was to estimate the limit of the fungicidal value of wood tar being a product of pyrolysis of wood previously treated with creosote oil or salt preservative of the CCB type. The effectiveness of wood tar in wood protection against fungi causing brown rot and soft rot was compared to the effectiveness of creosote oil (type WEI-B). Wood was impregnated with alcohol solutio...
B Mazela, M Kielczewski, W Grzeskowiak
Fixation of CCA preservatives in cocos-, oil- and rattan-palm
1986 - IRG/WP 3371
In previous tests with jubaea-palm almost no fixation of a CCA-preservative Type B could be achieved, consequently, further leaching tests were carried out with samples of 1 cocos-, 1 oil- and 2 rattan-palms from Malaysia. A good fixation of chromium and copper took place in cocos-palm after 4 weeks storage at 28°C. Nevertheless the fixation was slower than in pine-wood and demanded an elevated t...
H Willeitner, K Brandt
BG- an easiest preservative paste and its effective diffusibility in timbers for indoors and outdoors uses
2001 - IRG/WP 01-30253
After application of a newly formulated paste "BG-1" on all surfaces of air-dried lumbers, the boron have been found diffused completely in permeable and impermeable hardwoods at the rate of 12 mm radial thickness per week. The new paste may be a solution to protect lumbers being used or to be used under cover where timber is susceptible to termite and borer attack. The new cost effective paste wa...
A K Lahiry
The efficacy of polymer/preservative treatments in soil-bed exposure
1992 - IRG/WP 92-3729
Southern pine was treated with CCA, CCB, sodium borax/boric acid, or disodiumoctaborate, alone or in combination with an acrylic polymer system containing a water repellent. Treated samples were subjected to an unsterile soil burial test. The addition of polymer reduced the weight loss in borontreated samples at the lower retentions but not at the higher retention. Results with borates indicate th...
R J Murphy, H M Barnes, S M Gray
Soft rot decay in CCA treated eucalypts in Queensland - A comment
1986 - IRG/WP 1301
A survey has been completed concerned with the distribution and severity of groundline soft rot decay in the CCA treated sapwood of eucalypt poles in Queensland. The survey encountered some 1000 poles of which 55% were slightly, 28% moderately and 17% severely decayed. Soft rot decay was more severe in urban than rural locations. Embedment of poles in concrete resulted in severe soft rot. No signi...
L E Leightley
Mobility of zinc borate wood composite preservative
1997 - IRG/WP 97-30153
Zinc borate (ZB) is being used as an antifungal and insecticidal wood preservative for flake/strand-based composites. Data is reported on the laboratory and field leaching behavior of ZB when contained in apen flake composites. In general, the performance results correlate with leaching hazard. Although the boron in ZB is more resistant to depletion than in sodium borates, the ZB boron will deplet...
P E Laks, M J Manning
Effectiveness of wood preservatives by IUFRO's method
1984 - IRG/WP 3305
Pinus elliottii and Eucalyptus saligna stakes treated with 4.9; 6.9; 9.6 and 13.5 kg/m³ of CCA-A, CCA-C and CCB and with 30-50; 60-80; 90-110 and 120-140 kg/m³ of Benzotar and CNSL (cashew-nut shell liquid) were exposed in seven test sites in Sao Paulo State, Brazil. After 4 years it was concluded that the mean useful life of untreated Pinus elliottii stakes was 8 months and of untreated Eucalyp...
G A C Lopez, E S Lepage, O B Neto
Preliminary testing of an improvised wood preservative mixture applied against dry wood beetles
1986 - IRG/WP 1308
An improvised wood preservative mixture was preliminarily tested in situ against some dry wood beetles which had infested structural timbers in a semi-finished building. The results obtained should encourage further research towards mobilizing/improvising locally available resources in the face of scarce standard wood preservatives, against the background of a dilemma in wood utilization in the de...
M O Akanbi, E M Bayode, A A Alabi, J Gbadebo
Special seminar on screening techniques for potential wood preservative chemicals
1978 - IRG/WP 2113
This paper continues following issues:
I. SCREENING INSECTICIDES
1) R W Berry (BRE/PRL, UK): Screen testing of insecticides for use in remedial wood preservatives.
2) D J Cross (FRI, New Zealand): Rapid screening of contact insecticides for use on forest products.
3) C R Coggins; A Forsyth; A E Glaser (Rentokil, UK): Experience in the use of indicative screening techniques for termiticides.
...
Anonymous
Treatment of rubberwood (Hevea brasiliensis)
1997 - IRG/WP 97-40081
In this study treatability of rubberwood, timber from rubber trees (Hevea brasiliensis) was investigated by using both pressure and non-pressure methods. Samples with 4 cm by 4 cm cross section were sawn from the logs which were harvested from a plantation located in Batu Pahat, Johor, Malaysia. Full-cell and cold soaking methods were employed using Copper Chrome Arsenate (CCA) for the experiments...
S Hiziroglu
Influence of preservative treatment on the glueing of the members of glued laminated frames and effectiveness with respect to newly hatched larvae of the house longhorn beetl
1971 - IRG/WP 203 E
The object of the work is to check the general properties of a glued laminated beam after treatment of the members composing it by means of commercial insecticidal and fungicidal formulations in clear solvent under the most common conditions of manufacture. The species used have been spruce, redwood and Douglas fir in planed boards of 80 cm long, 14 cm wide and 20 mm thickness at about 12% moistur...
J Guillemain-Thévenot
Influence of different treatment parameters on penetration, retention and bleeding of creosote
2003 - IRG/WP 03-40255
Creosote is an extensively used preservative for transmission poles and sleepers. The purpose of this research was to investigate the treatment parameters necessary to achieve full sapwood penetration and minimum required retention and to avoid bleeding of creosote. It was carried out as a part of the European research project WOODPOLE. Transmission poles of Scots pine (Pinus sylvestris L.) previo...
Ö Bergman
Effect of species, retention and conditioning temperature on copper stabilization and leaching for ACQ-D
2004 - IRG/WP 04-30342
The time to stabilization or equalization of the copper component of ACQ-D was highly dependent on treating solution concentration (preservative retention) and post treatment temperature. Stabilization was rapid for low preservative retentions but extended times were needed for wood treated with higher concentration solutions. The extent of stabilization was also concentration dependent with a h...
Y T Ung, P A Cooper
Preservative treatment of wood-based composites with a mixture formulation of IPBC-silafluofen using supercritical carbon dioxide as a carrier gas
2003 - IRG/WP 03-40251
Wood-based composites treated with a mixture formulation of a fungicide, 3-iodo-2-propynyl butylcarbamate (IPBC) and a termiticide, silafluofen using supercritical carbon dioxide (SC-CO2) as a carrier solvent were tested for their resistance to decay and termite attack in the laboratory. The treatment solution was prepared by mixing both biocides (IPBC 10 + silafluofen 1) with a co-solvent, ethano...
K Tsunoda, M Muin
Optimisation of an analytical method for the determination of total fluoride in preservative-contaminated soils using water steam distillation and an ion-selective electrode
1999 - IRG/WP 99-20153
This paper describes a simple modified procedure for the quantitative fluoride determination of different origin in a soil matrix using a water steam distillation and an ion-selective electrode. Distillation methods generally require a preliminary preparation step like fusing. The modified method presented here is based on the direct distillation of fluoride so that no further sample preparation i...
E Melcher
Studies of the mechanism of chromated-copper preservative. Fixation using electron spin resonance
1992 - IRG/WP 92-3701
Two softwoods and one hardwood species were treated with chromium trioxide, copper sulphate, chromated-copper wood preservative (CCA). The treated wood samples were analyzed during fixation by electron spin resonance (ESR). ESR spectra indicated that more than one Cr(V) species was generated from Cr(VI) soon after CCA treatment. The Cr(V) signal became strong within increased several hours followe...
K Yamamoto, J N R Ruddick
The quantitative determination of N-cyclohexyl-diazeniumdioxide (HDO) containing compounds in treated wood using TD-GC-MS
2001 - IRG/WP 01-20223
Last year we presented the paper (IRG/WP/00-20201) "Determination of N-cyclohexyl-diazeniumdioxide (HDO) containing compounds in treated wood using GC-MS". Based on the intensive discussion at the meeting, the first experiences made with the calibration of the system for this application will be reported. For the quantitative determination of N-cyclohexyl-diazeniumdioxide in treated wood, milled m...
P Jüngel, J Wittenzellner, E Melcher
EPA’s Current Views on Heavy-Duty Wood Preservative Regulation
2003 - IRG/WP 03-50206
This paper describes the current EPA system for regulating pesticides and wood preservatives. In particular it focuses on the voluntary phase-out of CCA for residential uses after December 30, 2003, which was agreed between the CCA manufacturers and EPA. Even though the EPA reached an agreement with industry to phase out CCA for residential uses, EPA is continuing the most rigorous risk assessmen...
F T Sanders
Efficacy of waterborne copper naphthenate as preservative for northern hardwood species
1995 - IRG/WP 95-30091
Northern red oak (Quercus rubra) and red maple (Acer rubrum) cubes pressure treated with waterborne formulation of copper naphthenate were evaluated for resistance to attack by brown fungi Gloeophyllum trabeum (Pers. ex Fr.) Murr. (Madison 617 ATCC 11539) and Poria placenta (Fr.) Cooke (Madison 698, ATCC 11538), white rot fungi Trametes versicolor (L. ex Fr.) Pilat (R-105 from Jeff Morrell), Irpex...
D P Kamdem, R Fair, M H Freeman
Chromated copper arsenate preservative treatment of hardwoods. Part 2: leaching performance of seven North American hardwoods
1997 - IRG/WP 97-30132
Seven North American hardwood species were treated with 2% CCA-C solution and fixed at temperatures of 21°C and 50°C and conditions of high relative humidity (95%) as described in Part 1 of this presentation. Red pine (Pinus resinosa) was included as a softwood for comparison. Adequately fixed wood blocks (99.9% chromium fixation) were exposed to leaching tests according to AWPA E11-87 test. Par...
T Stevanovic-Janezic, P A Cooper, Y T Ung
Effect of species composition of preservative-treated Douglas fir plywood on its decay resistance
1978 - IRG/WP 2114
Plywood is now commonly used for constructional purposes in environmental situations where decay by wood-destroying fungi can be a considerable risk. However there seems to be a lack of understanding of the relative durability of plywood, both untreated and when treated with wood preservatives. Part of the reason for this situation has been the difficulty of carrying out laboratory decay tests on ...
R S Smith, P Balcaen
Fouling organisms as indicators of the environmental impact of marine preservative-treated wood
1995 - IRG/WP 95-50063
This study evaluates the use of fouling organisms (epibiota) to assess the environmental impact of preservative treated wood. This paper presents initial findings from treated panels exposed for 6 months at Sagres, Algarve, Portugal. Panels were treated with CCA, two copper-containing quaternary ammonium (ACQ) formulations and creosote, with nominal retentions from 10 to 40 kg/m³ (creosote 25 pcf...
R M Albuquerque, S M Cragg
Marine performance of preservative treated Southern pine panels. - Part 1: Exposure in Newport, Oregon
2000 - IRG/WP 00-10368
The ability of selected wood preservative to protect southern pine sapwood against marine borer attack was evaluated over a 6 year period in Yaquina Bay, Oregon. The site exposed the wood to potential attack by both Teredo navalis and Limnoria spp. Both creosote and CCA provided excellent protection at moderate retentions, while ACQ produced slight differences in performance depending on the coppe...
R G Rhatigan, J J Morrell, A R Zahora
Methods for improving preservative penetration into wood: a review
2002 - IRG/WP 02-40227
Pressure treatment technologies have been available since the mid-1830's, but the processes used for wood treatment are still largely unable to overcome the fundamental limitations of flow through semi-permeable pit membranes. Instead, methods have arisen that attempt to improve treatability of the wood including incising, compression rolling, through boring, or radial drilling. Other a...
J J Morrell, P I Morris