Your search resulted in 112 documents. Displaying 25 entries per page.
The effect of acetylation on physical properties of beech (Fagus orientalis) and Alder (Alnus subcordata) wood
2016 - IRG/WP 16-40759
In this study the effect of acetylation on physical properties such as water absorption, volumetric swelling and anti-shrink efficiency (ASE) of beech and alder were investigated. After 24 hours soaking in acetic anhydride, in order to achieving two surface of weight gains, acetylated samples were heated in oven at 120 0C for 90 and 360 minutes. Then water absorption and dimensional stability in...
M Akhtari, M Arefkhani
Effect of different concentration of furfurylation on physical properties and decay resistance of Paulownia wood
2016 - IRG/WP 16-40762
The furfurylation process is an extensively investigated wood modification process. Penetration of Furfuryl alcohol molecules into the wood cell wall results in a permanent swelling. In the present study, different concentrations effect of furfuryl alcohol monomer on physico-biological properties such as water uptake, dimensional stability and decay resistance of wood polymer made by fast-growing ...
M Ghorbani, H Asghari
Evaluation of Particulate Materials as a Physical Barrier against Termites under Floor of Experiment House
2017 - IRG/WP 17-10900
In Japan, the damages by the subterranean termites (Coptotermes formosanus and Reticulitermes speratus) are more common. Recently the more attention is paid to the less- or non-chemical methods for termite control. As a non-chemical treatment, physical barriers using particles such as gravels were investigated in terms of environmental safety, cost effectiveness, and duration of performance, and t...
Y Yanase, Y Fujiwara, Y Fujii, T Mori, T Yoshimura, S Doi
Evaluation of surface cracks on wood – physical assessment versus subjective sensation
2017 - IRG/WP 17-20617
In the presented studies from the University of Goettingen (Study I) and the University of Hannover (Study II), the assessment of cracks with different methods and their acceptance in general as well as depending on different target groups are investigated. The aim was to determine which factors are relevant for a crack evaluation and which visual impression of a wooden surface is tolerable for co...
A Gellerich, C Brischke, L Emmerich, L Meyer-Veltrup, P Kaudewitz
Durability of energy efficient wooden buildings: a building physical point of view
2017 - IRG/WP 17-40812
The drive for more energy efficient and sustainable buildings resulted in an increased popularity of wooden buildings, even in countries with a masonry tradition. Often guidelines and prescriptions then are copied from other countries. Different climatic boundary conditions and tradition of finishing, though, do require different moisture tolerance criteria. This is clearly the case for water vapo...
S Roels, J Langmans
Mechanical, Physical and Biological Properties of Sandwich Biocomposites Panels manufactured from Food Packaging Waste
2017 - IRG/WP 17-40791
Recently, recycling of Tetra Pak® packaging material has attracted many attention, particularly in composite industries. In this work, novel biocomposites sandwich structures were manufactured using TetraPak waste materials as core component and various kind of natural and artificial woven fabrics as skin elements. Mechanical, physical and biological performances of the developed composite panels...
A S O Mohareb, A H Hassanin, K Candelier, M F Thévenon, A Kilic, Z Candan
Effect of Heat Treatment on Physical and Mechanical Properties of Oriental Beech Wood (Fagus orientalis L.)
2021 - IRG/WP 21-40923
The present study aims to investigate the influence of heat treatment on physical and mechanical properties of Oriental beech wood (Fagus orientalis Lipsky.). Samples were exposed to temperature levels of 130˚C, 160˚C, and 190˚C for 3, 6, and 9 h. Selected physical and mechanical properties including compression strength parallel to grain, compression strength perpendicular to grain, bending st...
M D Ghalehno, D Chu, B N Sheshkal, M Humar, M Bahmani
Evaluation of the physical properties of heat-treated native Peruvian woods for their application as coverings in buildings located in in arid, semi-warm and humid climates
2022 - IRG/WP 22-40943
Wood is a material that has properties suitable for its use in construction: as a structural component, cladding or decorative element, however, it is necessary to have knowledge of its physical, mechanical and thermal properties in order to have a logical criterion when applying it. It is known that wood has hygroscopic properties, so it tends to absorb the relative humidity of the natural enviro...
K Ayala Castro, A Loayza Argüelles, V J Pilco Mamani
Barriers of polyglycol/borate treated wood prevent termite attack to untreated wood above them in 10-year field tests
2024 - IRG/WP 24-20709
As a pioneer in wood protection and borate research Terry Amburgey, a lifetime member of the IRG, had many projects where borates were used in subsequently commercially very successful applications. This paper is one of the initial research projects that lead to polyglycol borates being used as a standalone treatment to protect against termites in new homes which has now been well proven over the ...
K W Ragon, J D Lloyd, T L Amburgey
Effects of phosphoric acid and diammonium phosphate treatments on the physical and fire-retardant properties of five selected Nigerian wood species
2024 - IRG/WP 24-20713
Wooden products in buildings are major sources of fuel for fire outbreaks. Effects of phosphoric acid and diammonium phosphate treatments on the physical and fire-retardant properties of wood species commonly used in buildings were evaluated. The timber species utilized in this study were sourced from the sawmill sector located in Akure, Nigeria, encompassing Brachystegia laurentii, Khaya ivorensi...
J Owoyemi, T O Akinwamide, O M Ibrahim, E A Iyiola
Physical, durability and chemical characterization of Gmelina arborea (Roxb.) wood treated with lactic acid
2024 - IRG/WP 24-30803
The increase in demand for durable wood has drawn attention to the use of fast-grown plantation species across the globe. Chemical modification was used to treat Gmelina arborea wood with lactic acid for property enhancement. The treated samples were obtained from two different ages of 15 and 10 years and sawn into (20 x 20 x 60) mm and (20 x 20 x 20) mm for physical, durability and chemical chara...
T O Akinwamide, J M Owoyemib, E A Iyiolac
Assessment of hydrophobic properties of acetylated and furfurylated Korean wood species
2024 - IRG/WP 24-30812
To increase the utilization of Korean wood species, the hydrophobic properties of the most commonly used wood species in Korea were compared according to wood modification. Pinus densiflora (sapwood and heartwood) and Larix kaempferi (heartwood) were selected as test wood species, and Pinus radiata (sapwood) was selected as the control wood species. The wood modification was performed by acetylati...
S-M Yoon, Y-S Choi, H-M Lee, Y Park, W-J Hwang, S-K Jang