Your search resulted in 816 documents. Displaying 25 entries per page.
The impact of pre-drying on treatment level variations of esterified solid wood analysed by X-ray densitometry
2023 - IRG/WP 23-40977
Wood modification requires homogenous treatment levels within the wood matrix to prevent insufficiently treated areas being subject to biodeterioration. Esterification of wood by citric acid and sorbitol can show differences in density caused by uneven chemical distribution during the curing phase and can be detected by x-ray densitometry. This study used density profiling to investigate the influ...
A Treu, S O Amiandamhem, E Larnoy
Effects of preservative impregnations on wettability and surface free energy properties of Eucalyptus grandis wood
2023 - IRG/WP 23-40978
Wettability and surface free energy (SFE) are crucial parameters for evaluating the adhesion thermodynamics of solid surfaces. Hence, this study investigated the effects of copper azole (CA) and disodium octaborate tetrahydrate (DOT) preservative impregnations on Eucalyptus grandis wood wettability and SFE. Wettability was determined in terms of contact angles with polar (water) and non-polar (dii...
A A Alade, C B Wessels, H Stolze, H Militz
CIOL Wood - towards industrial scale production
2023 - IRG/WP 23-40980
CIOL® is a new, low cost, non-toxic wood modification system, needed to replace traditional and non-sustainable alternatives with great potential. It’s important to find sustainable, environmentally friendly replacements to heavy metals and biocides. In the new European Bauhaus, Ursula Von der Leyen, president of the European commission, talks about how new living environment should be beautifu...
E Larnøy, J Biørnstad
Short-term absorption of water and coatings on thermally modified blue-stained spruce wood
2023 - IRG/WP 23-40984
The importance of wood has been increasing in the last decades. Among conifers, predominantly spruce (Picea abies) wood is often used in building constructions in Europe. Namely for construction and facades of buildings, decking and fences. Due to the increased public concerns about biocides, alternative techniques for protection, such as thermal modification and protection by construction, are ga...
R Hasanagic, M Bahmani, M Humar, L Fathi, L Cai
Properties of thermal modified wood of Pinus pinaster and Pinus radiata from Galicia, Spain
2023 - IRG/WP 23-40985
This article provides the results of a research about the properties of thermal modified wood of maritime pine (Pinus pinaster Ait.), radiata pine (Pinus radiata D.Don) and Scots pine (Pinus sylvestris L.) from Galicia, Spain, thermal treated in the industrial vacuum-heat autoclave plant of FINSA group in Galicia, Spain. These three pine wood species are used in different solid products but due th...
D Lorenzo, J Benito, J Arancón, J Crespo
Bio-inspired wood protection, modification and functionalization
2023 - IRG/WP 23-40989
Wood is a versatile, natural, and environmentally friendly resource that has attracted attention as a material for sustainable building for many years. Recent advances in materials research have delivered several innovative solutions for the construction sector. However, intrinsic properties of wood affects its operational durability, which is still a limiting factor in many applications and envir...
A Sandak, K Butina Ogorelec, F Poohphajai, A Gubenšek, R Herrera Diaz, O Gordobil
Modification of wood by fast pyrolysis bio-oil – the NewWave project concept for bio-based wood treatment
2023 - IRG/WP 23-40990
The NewWave project aims to contribute to building a circular economy by introducing sustainable raw materials in different manufacturing lines, replacing toxic chemicals and lowering the environmental footprint of the products. The raw materials are obtained from the thermochemical fractionation of biomass. This process converts biomass residues by fast pyrolysis into Fast Pyrolysis Bio-Oil (FPBO...
A Sandak, J Sandak, F Poohphajai, R Herrera Diaz, A Gubenšek, K Butina Ogorelec, L Kiezebrink, K J Swager, H Heeres, B van de Beld
Effect of incised pattern on flexural strength of CLT
2023 - IRG/WP 23-40993
As a study aimed at developing preservation methods suitable for CLT, investigations have been carried out using “deep penetration treatment”. This treatment method was originally developed as a treatment method for sawn lumber and glulam used as sill members. In the treatment, materials are incised using specially designed blades and immediately sprayed with an oil-based wood preservative. Th...
T Mori, R Takanashi, T Miyauchi, Y Ohashi, S Isaji
Optimization of furfurylic alcohol/tannin ratio to improve the performance of biosourced thermoset resins for wood protection
2023 - IRG/WP 23-40994
This study concerns the chemical modification of wood with different ratios of tannin and furfuryl alcohol (FA) in the presence of maleic acid as catalyst. Tannins were used not only as cross-linking agents, but also as co-monomers to improve wood durability, while reducing the amount of FA used. Different aqueous formulations were prepared containing decreasing amount of FA (from 45.45% to 0%) an...
E Azadeh, A Pizzi, P Gérardin, C Gérardin-Charbonnier
Studies on the treatability of selected pine species and corresponding efficacies of a new non-biocidal treatment
2024 - IRG/WP 24-20721
Wood decay caused by fungi may reduce the service life of wood in outdoor applications. Since moisture conditions in wood occur as one of the most crucial parameters for fungal decay, chemical modifications, which affect the latter, may increase the resistance of wood against such organisms. Usually, pine sapwood is easier to chemically treat than heartwood, as the former generally shows good perm...
T R da Silva Lins, L Emmerich, H Militz, P H Gonzales de Cademartoni, R J Klizke, M Pereira da Rocha
The potential of Wacapou (Vouacapoua americana) extracts to develop new biobased protective solutions for white woods
2024 - IRG/WP 24-20724
The valorisation of Amazonian wood residues into active chemical compounds could be an eco-friendly, cost effective and valuable way to develop wood preservatives formulations in order to enhance the decay and termite resistances of low durable wood species, by impregnation processes. Wacapou (Vouacapoua spp., Fabaceae) is a well-known Guianese wood species for its use in local wood construction ...
E Kieny, K Candelier, L Milhe, Y Estevez, C Sophie, R Lehnebach, J Damay, D Florez, E Hoël, M-F Thevenon, J Bossu
Properties of thermal modified wood of Pinus pinaster, Pinus radiata and Pinus sylvestris from Galicia, Spain
2024 - IRG/WP 24-30800
This paper provides the results of a research about the properties of thermal modified wood of maritime pine (Pinus pinaster Ait.), radiata pine (Pinus radiata D. Don) and Scots pine (Pinus sylvestris L.) from Galicia, Spain, thermal treated in the industrial vacuum-heat autoclave plant of FINSA group in Galicia, Spain. These three pine wood species are used in different solid products but due the...
D Lorenzo, J Benito, J Arancon, J Crespo
Preliminary investigation of the durability and performance of 1,3-dimethylol-4,5-dihydroxyethylene urea (DMDHEU) treated aspen strandboard
2024 - IRG/WP 24-30804
Wood modification technologies are growing in popularity because of their potential to improve wood properties by permanent covalent chemical modifications rather than chemical impregnation. These features can be utilized in wood composites to help improve dimensional stability and composite resistance to fungal decay. In this study, 1,3-dimethylol-4,5-dihydroxyethylene urea (DMDHEU) was used to m...
S Johnson, F Kamke, G Presley
Citric acid and sorbitol treatment: A comparative study of Canadian and Norwegian species
2024 - IRG/WP 24-30806
Dimensional instability can reduce the competitiveness of wood in exterior applications such as cladding and decking. The objective of this work was to evaluate the dimensional stability of permeable and refractory softwoods from Europe and North America modified via a sorbitol and citric acid treatment. White spruce and Norwegian spruce, refractory species, and jack pine and Scots pine, relativel...
D Schorr, Erik Larnøy, R Stirling, G Boivin
Assessment of hydrophobic properties of acetylated and furfurylated Korean wood species
2024 - IRG/WP 24-30812
To increase the utilization of Korean wood species, the hydrophobic properties of the most commonly used wood species in Korea were compared according to wood modification. Pinus densiflora (sapwood and heartwood) and Larix kaempferi (heartwood) were selected as test wood species, and Pinus radiata (sapwood) was selected as the control wood species. The wood modification was performed by acetylati...
S-M Yoon, Y-S Choi, H-M Lee, Y Park, W-J Hwang, S-K Jang
Bio-based thermal insulation panels – a way of cascading utilization of post-consumer wood
2024 - IRG/WP 24-50388
Cascading wood utilization is critical to fulfilling a circular economy frame in the wood industry. The work's aim was to apply wood dust from plywood production to the production of innovative bio-based thermal insulation panels. Trametes hirsute fungus was used as a composite binder, and then a composite structure and thermal insulation properties, water absorbability, and strength properties of...
W Perdoch, A Szelag