Your search resulted in 323 documents. Displaying 25 entries per page.
Thermally modified timber treated with methacrylate
2018 - IRG/WP 18-40849
Thermally modified timber (TMT) from Scots pine sapwood similar to Thermo-D quality was impregnated with methacrylate resin by the hot-and-cold method and subsequently cured at elevated temperatures. The results showed that methacrylate resin could be used to reduce colouring of painted TMT wood during accelerated weathering probably by hindering the migration of extractives. The resin itself did ...
O Karlsson, O Myronycheva, DJones, D Elustondo, D Sandberg
Comparative performance of wood/wood-based claddings predicted by four hygrothermal simulation tools
2019 - IRG/WP 19-20646
A number of hygrothermal numerical simulation packages are available, either wholly or partially dedicated to heat, air and moisture transfer simulations of building materials and wall assemblies. The objective of this work was to compare the hygrothermal responses and the moisture performance of western red cedar and composite wood claddings of a wood frame wall as predicted by four hygrothermal ...
M Defo, M Lacasse, A Laouadi
Quantifying the effect of microclimatic parameters on the moisture-induced decay risk of wooden structures
2019 - IRG/WP 19-20649
Wood exposed outdoors is prone to fungal degradation. Besides its material-inherent resistance, numerous factors are impacting on its service life with both, climate and design having a major effect. In addition, topography, shading, wind barriers, and other local parameters have an effect on the microclimatic conditions at site and therefore need to be quantified for service life prediction of wo...
L Emmerich, C Brischke
Facile in-situ growth of Ag-TiO2 nanoparticles on polydopamine modified bamboo with excellent mildew-proofing
2019 - IRG/WP 19-30734
Bamboo with good mechanical properties, fast growth rate and low growth cost is one of very utilitarian structural material from forest resources only less important than wood. But it is especially easy to mildew during outdoor service resulting in appearance mould scattering and corrosion. In this work, a facile method was developed to increased mildew-proofinging capability of bamboo. Mussel-ins...
J Hu, Z Lu, G Liu, S Chang, Y Liu, X Li
Preservative Treatment of CLT: An Example at Shimojishima Airport
2019 - IRG/WP 19-30748
Cross laminated timber (CLT) is a relatively new construction method that allows multi-storey construction using solid wood instead of concrete or steel. It is a method favoured by progressive architects and recognized for its much lower environmental footprint. Wood is an excellent construction material and is a long-term carbon sink that also performs well in the event of earthquakes and fire....
J Lloyd, N Yamashita, A Taylor
Study on the ability of wood-destroying fungi to grow through chemically modified wood
2019 - IRG/WP 19-40858
Over the last decades, chemical wood modification technologies were developed to increase the resistance against attack by wood-destroying organisms without using biocides. Most of those technologies are based on an impregnation step initially. In most treated wood products, mainly by using solid wood in thicker dimensions as in posts, poles, sleepers, deckings etc. it is known that wood impregnat...
L Emmerich, S Strohbusch, C Brischke, S Bollmus, H Militz
Engineered wood constructions in Brazil: the challenge of protection against biodeterioration for market growth
2019 - IRG/WP 19-40878
This paper presents some thoughts about Brazilian wood constructions market regarding to biodeterioration and protection against biodeterioration, especially termites. Despite of being a forestry country, there is no tradition in wood engineered buildings and some prejudice must be overcome.
New companies are interested in this market and as a continental country, different problems regarding of...
L F T di Romagnano, S Brazolin, G A da Silva, G A C Lopez
Fungal colonisations in and on industrially manufactured acetylated glulam in UC 3
2020 - IRG/WP 20-40900
This poster paper describes one of the first cases where industrially acetylated glulam was colonized by wood-destroying fungi after less than 10 years of exposure in use class 3.2. Remarkable is that fruiting bodies of white as well as brown rot fungi were found on one and the same bench element. The first visible wood destroying fungi was the white rot fungus Schizophyllum commune followed by th...
J Müller, E Melcher, T Potsch
Assessing the risk of marine borer attack of the timber trestles and decay of timber above the intertidal zone of the Barmouth Viaduct
2021 - IRG/WP 21-10974
The Barmouth Viaduct is a Grade II* listed structure which carries the single track of the Dovey Junction to Pwllheli line and footway over the Mawddach estuary. It is in a marine environment where timber below the high tide mark is at most risk in Use Class 5 and all timber above in Use Class 3.2, permanently exposed to the risk of wetting. The structure consists of a timber trestle viaduct of ...
J R Williams
Effect of MVOC exposure on mycelial growth of wood rotting fungi
2021 - IRG/WP 21-10977
It is well known that wood rotting fungi produce microbial volatile organic compounds (MVOCs) as metabolites. In our previous studies, we have found that some MVOCs produced by wood rotting fungi are common to fungal species tested in the studies, while others are specific to each species. Furthermore, it has been also shown that each wood rotting fungi do not always produce the same type of MVOCs...
S Horikawa, R Konuma, M Yoshida
Dynamics of fungi colonization on the surface of Scots pine wood during natural weathering in different European climate zones
2022 - IRG/WP 22-10984
Wood The presence of fungi leads to biomaterial decay and/or changes in aesthetical appeal. The start of fungi colonization as well as the following growth on wood are primarily influenced by four factors: ambient temperature, moisture history of the object, access to oxygen, and intrinsic properties of the exposed wood, considered here as a source of nutrients for microorganisms. A prevalence of ...
F Poohphajai, O Myronycheva, O Karlsson, L Rautkari, J Sandak, A Sandak
In Vitro Growth of the Basidiomycetes Physisporinus vitreus strains in various conditions in comparison with some white rot fungi
2022 - IRG/WP 22-10987
The paper has preliminary test results to select Pysisporinus vitreus fungal strains for further experiments in a large research project on copper tolerance of P. vitreus by chemotropic test, choice test, and agar plate toxicity tests and determination of the effect of various ions on oxalic acid secretion by these white rot fungi. In the project, it is also aimed to run fungal decay tests to dete...
E E Soytürk, S N Kartal
Assessing the Performance of Wood-based Materials Exposed to Termite Risk – A New Experimental Approach
2022 - IRG/WP 22-10989
Termites are able to degrade a large number of building materials including wood, wood-based panels, biobased insulation, and polymers. The risk for a material of being degraded by termites depends on its composition, on its accessibility, and also on the behavior and the biology of the termite species considered. Within the EU project Click Design, we investigated the durability, under laboratory...
M Kutnik, I Paulmier, C Brunet, D Ansard, M Montibus
Using satellite-retrieved soil moisture data to model the decay risk of in-ground timber
2022 - IRG/WP 22-20689
Satellite-derived soil moisture data from the Soil Moisture Active Passive (SMAP) was extracted for a 9 x 9 km point grid over Europe. The data was then used as input to a dose-response wood decay model based on terrestrial microcosm (TMC) tests. The resulting hazard map plotted dose as an indicator of in-ground wood decay based on differences in annual temperature and soil moisture characteristic...
P B van Niekerk, M Schönauer, B N Marais, C Brischke
Biological assessment of bio-based phase change materials in wood for construction applications
2022 - IRG/WP 22-40935
Solid wood can serve multi-functionality for energy savings in buildings. The study reveals the results of bio-deterioration and degradation of solid Scots pine wood used to incorporate single or multicomponent fatty acid mixtures as bio-based phase change materials (BPCMs). The sapwood samples were impregnated with capric acid (CA), methyl palmitate (MP), lauryl alcohol (LA) and a mixture of coco...
S Palanti, A Temiz, G Köse Demirel, G Hekimoğlu, A Sari, M Nazari, J Gao, M Jebrane, T Schnabel, N Terziev
Effect of volatile organic compounds produced by wood rotting fungi on mycelial growth
2023 - IRG/WP 23-11023
Microorganisms such as fungi or bacteria produce volatile organic compounds (so-called MVOCs: Microbial Volatile Organic Compounds) as metabolites. Some MVOCs have been found to be biologically active, for example inhibition of spore germination, and when fungi of different species encounter each other, the MVOCs pattern change, suggesting that MVOCs play a role as a mediator for biological intera...
S Horikawa, R Konuma, M Yoshida
Accelerated surface mould testing for exterior wood treatment in Temperate, Tropical and Laboratory environments
2023 - IRG/WP 23-20699
Mould attack is a very common cause of discoloration on wooden surfaces and can subsequently promote development of wood decay by other organisms. Prevention of mould growth is relevant for both pigmented wood paints as well as more transparent systems with a high or low amount of binder. The use of commercial biocides has led to effective microbiological inhibition in many contexts, but the incre...
A Nazeri, J Stenbaek, T R Laursen, A H H Wong, B M Hasnul
Time-lapse evaluation of Aureobasidium pullulans growth on selected lignin derivatives and chitosan
2024 - IRG/WP 24-11032
Wood, often referred to as the “building material of the 21st century”, has gained recognition as an attractive alternative to several traditional building solutions. To enlarge the application of wood, several properties including biotic and abiotic degradation resistance need to be improved. Consequently, new solutions are available on the market that ensure expected properties and functiona...
Gubensek, F Poohphajai, A Tosic, K Butina Ogorelek, W Pajerski, A Cernosa, V Hribljan, A Sandak
Cellulose nanomaterials in growth media for wood decay fungi
2024 - IRG/WP 24-11035
Cellulose nanofibrils (CNFs) were investigated as a partial substitution for agar in growth media for wood decay fungi. Radial growth measurements of eight basidiomycete fungi were taken on solid growth media with and without CNFs. Additionally, fungal strain virulence was evaluated using the European CSN Standard EN 113-2 wood decay durability test. The inclusion of CNFs did not significantly aff...
K M Ohno, R A Arango, R Sabo, C M Clemons, G T Kirker, A B Bishell
Cellulose nanomaterials in growth media for wood decay fungi
2024 - IRG/WP 24-11035
Cellulose nanofibrils (CNFs) were investigated as a partial substitution for agar in growth media for wood decay fungi. Radial growth measurements of eight basidiomycete fungi were taken on solid growth media with and without CNFs. Additionally, fungal strain virulence was evaluated using the European CSN Standard EN 113-2 wood decay durability test. The inclusion of CNFs did not significantly aff...
K M Ohno, R A Arango, R Sabo, C M Clemons, G T Kirker, A B Bishell
Investigating moisture dynamics and fungal decay risk: integrating X-ray CT visualization and simulation benchmarks through a Fungal Control Unit
2024 - IRG/WP 24-11045
Wood is susceptible to fungal attack and over time the structural integrity can be compromised. This risk is of course strongly related to moisture dynamics, as moisture is needed for fungal growth. While existing methodologies, such as lab and field tests, provide valuable insights into wood decay, they often fall short in replicating real-life conditions, particularly within the intricacies of t...
J Van den Bulcke, J Van Acker, M Delbeke, A Blommaert, N Van Den Bossche, M Steeman, L De Ligne
Shelling of flat and profiled western larch deck-boards exposed to natural weathering
2024 - IRG/WP 24-40997
Shelling is a severe type of raised grain that occurs at the surface of deck-boards made from wood species that have growth rings with pronounced differences in density between earlywood and latewood, for example southern pine (Pinus spp.). Shelling is more severe in deck-boards fixed with their growth rings oriented pith-side-up (concave) rather than bark-side-up (convex). Far less is known about...
L H Leung, P D Evans
Changes in decay risk of wood in ground contact over Europe, from analysis of historic climate conditions
2024 - IRG/WP 24-41008
Changing climate conditions will affect global temperature and precipitation patterns, shifting some geographical areas into states that are more suitable for fungal wood decay. Climate normals, which are taken over a 30-year period, capture vast spatial and temporal variations in these conditions and comparing these can show changes over time. Importantly, being able to identify locations that ha...
P B van Niekerk, B N Marais, G Alfredsen, C Brischke