Your search resulted in 3554 documents. Displaying 25 entries per page.
Domestic wood preservation - Remedial treatments in Australia
1978 - IRG/WP 3128
Domestic construction in Australia relies heavily upon timber. Because of availability, local conditions and building practices, the timbers and other materials employed vary considerably between the States. In recent years, the timber floor has given way to 'raft construction' (concrete slab-on-ground). Not surprisingly, there is a tendency in each State to use local timbers for...
J Beesley, H Greaves
NMR T1 relaxation time as a non-destructive method for the study of decay in wood
1992 - IRG/WP 92-2406
The NMR spectroscopic technique of measuring the T1 spin-lattice relaxation times has been investigated for its potential in the detection of microbial decay in wood. The T1 NMR analyses were carried out on samples of Scots pine and European beech that had been exposed to decay and non-decay fungi representing each of the important groups colonising wood. Decay in the test material was also assess...
P W McCormack, A E G Cass, R J Murphy
Screening wood preservatives: Comparison of the soil block, agar block and agar plate tests
1993 - IRG/WP 93-20001
Several test procedures have been developed over the years to screen potential biocides for their value as wood preservatives. Each test has inherent advantages and disadvantages. In this paper the relative merits of the soil block, agar block and agar plate tests are compared. Eight commercially available biocides encompassing inorganic and organic systems were tested against four basidiomycete d...
K J Archer, D D Nicholas, T Schultz
Biological control of wood decay fungi. - Part II. Effects of exogenous nitrogen on effectiveness
2000 - IRG/WP 00-10360
The effects of nitrogen (urea and ammonium nitrate) on the ability of Trichoderma harzianum to inhibit the enzyme capabilities and decay capacities of Trametes versicolor and Gloeophyllum trabeum were investigated using a small wood sandwich decay test. The biocontrol fungus generally had a greater effect on the brown rot fungus, confirming previous reports. Nitrogen produced inconsistent effects ...
E A Canessa, J J Morrell
Resistance of two commercial cement-bonded rubberwood particle composites to decay and termites
2000 - IRG/WP 00-10338
Two types of cement-bonded rubberwood (Hevea brasiliensis) particle composites (tradenames: Cemboard and Primaflex in Malaysia), were evaluated for termite resistance (prevalent termite: Coptotermes curvignathus) in the field, and decay resistance (test white rot fungi: Schizophyllum commune and Pycnoporus sanguineus; test brown rot fungus: Gloeophyllum trabeum; test soft rot fungi: Phialophora fa...
A A H Wong
Extracellular mucilage (ECM) in wood decay basidiomycetes
2002 - IRG/WP 02-10439
The ability of wood decay basidiomycetes to produce extracellular mucilage (ECM) and its relationship with total biomass production is being investigated. Growth and ECM production by the brown-rot fungus Gloeophyllum trabeum (FPRL 108 N) and the white-rot fungus Coriolus versicolor (CTB 863 A) was assessed in liquid culture under different conditions and in the presence of the fungicide cyprocona...
D Vesentini, D J Dickinson, R J Murphy
Evidence for actinomycete degradation of wood cell walls
1990 - IRG/WP 1444
Several unique patterns of degradation occurring in wood cell walls have been observed in wooden stakes inserted in unsterile soil in the laboratory. Some of the patterns have also been observed in coniferous wood taken from forest floors. All the observed attack types occur within wood cell walls, mainly within the S2 layer. Attack is characterised by channels of varying diameter or small fusifor...
T Nilsson, G F Daniel, S L Bardage
Eradication of wood decay fungi by means of radio frequency
1998 - IRG/WP 98-10292
High frequency electromagnetic fields i.e. radio frequency (RF) are used in wood industry for heating, gluing and bending of wood and are also appropriate for eradicating of wood decay fungi and insects. We investigated the effects of RF exposure on wood samples which were in vitro infected by Coniophora puteana, Gloeophyllum trabeum and Lentinus lepideus. For each fungus, the lethal temperature a...
F Pohleven, J Resnik, A Kobe
Bending properties of wood after its decay with Coniophora puteana and subsequent modification with selected chemicals
1999 - IRG/WP 99-40146
Mechanical properties of wood are often decreased due to decay processes caused by biotic and/or abiotic factors. Damaged wooden elements (e.g. historical structures) can be reinforced by more methods, including their modification with convenient chemicals. This paper presents influences of selected chemicals on basic bending properties (modulus of elasticity - MOE, modulus of rupture - MOR) of so...
L Reinprecht, S Varinska
Analysis of volatile organic compounds (VOC's) from Trichoderma spp.: effect of media composition on VOC production and level of inhibition of wood decay fungi
1997 - IRG/WP 97-10207
Production of volatile organic compounds (VOC's) by two Trichoderma isolates grown on either malt extract or minimal media was examined and statistically assessed to identify which VOC's were predominantly produced on each of the two media types. The VOC's were captured onto chromatographic absorbent from above the cultures of the fungi before being analysed by integrate...
A Bruce, R E Wheatley, C Hackett, A Kundzewicz
Stability, performance and distribution of propiconazole (R 49362) in acceleratedly aged wood
1991 - IRG/WP 3647
The permanency of propiconazole (R 49362 - WOCOSENÔ technical - Janssen Pharmaceutica) in wood was examined in an 18 month storage test, an evaporative ageing study (EN 73), a volatilization stress experiment, and water-leaching studies (EN 84). The biological efficacy against two brown rot fungi: Coniophora puteana BAM Ebw. 15 and Gloeophyllum trabeum BAM Ebw. 109 was assessed according to the E...
A R Valcke, M Stevens
Comparison of the in-ground performance of pigment emulsified creosote (PEC) and high temperature creosote (HTC)
2000 - IRG/WP 00-30217
A long-term field trial was conducted in Australia to compare the in-ground performance of two oil-borne preservative formulations, conventional high temperature creosote (HTC) and a modified creosote formulation, pigment emulsified creosote (PEC). Three retentions (50, 100 and 200 kg/m³) were targeted for each formulation. An additional retention of PEC formulation (308 kg/m³), which contained ...
J W Creffield, H Greaves, N Chew, N K Nguyen
Environmentally benign wood preservatives based on organic biocide antioxidant combinations: A brief review of laboratory and field exposure results and discussion of a proposed mechanism
2004 - IRG/WP 04-30335
The combination of various organic biocides with commercial antioxidants generally increased the biocides’ efficacy 2-3 fold against wood-destroying fungi in short-term laboratory decay tests, and some positive results have been obtained after 2-4 years of outdoor exposure. The two antioxidants principally examined, propyl gallate and butylated hydroxytoluene, are low cost and, since both are f...
T Schultz, D D Nicholas, W Henry, C Pittman, D Wipf, B Goodell
The potential application of rapid gas-chromatographic assay of microbial respiration to the monitoring of wood decay in field trial situations
1983 - IRG/WP 2196
Gas chromatographic detection of microbial activity (C02 production) within stakes in a field trial situation would appear to provide a sensitive, non-destructive and relatively rapid method for the quantitative assessment of preservative treatments. Most consistent results were obtained when stakes were removed from the soil, washed, saturated with water and incubated in sealed PVC tubes at 25°C...
M A Line
Preservation of wood composites with zinc borate
1995 - IRG/WP 95-30074
Inorganic borates such as boric acid, borax, disodium octaborate tetrahydrate, and zinc borate can be incorporated into wood composites such as waferboard to impart decay and insect resistance to the final product. Zinc borate is especially well suited for this application due to its efficacy and leach resistance. The paper summarizes the work performed to date in this area. The effects on strengt...
P E Laks, M J Manning
Stake test with ammoniacal copper in combination with different agents started in 1962
1997 - IRG/WP 97-30130
In 1962 a stake test was started with ammoniacal copper in combination with chromium, arsenic, pentachlorophenol, boron, salicylic acid, benzoic acid, sorbic acid, pyridine and tannin. Different concentrations of the copper component were used as well as the added agents. For each concentration and test site, ten stakes of Pinus sylvestris L. sapwood were treated. The stakes were set out at two te...
B Häger, Ö Bergman
Restrictions on the use of chlorosilanes as potential wood preservatives
1985 - IRG/WP 3345
The biological protection of wood by chemical modification with different types of chlorosilanes has been investigated. The impregnation of wood has been carried out by means of liquid phase and vapor phase treatments using pure silane and silane-solvent systems. The biological efficacy against wood rotting fungi, molds and staining fungi was determined in a number of screening trials, subsequentl...
M Stevens
EPR observation of Mn(II) in decayed wood
2002 - IRG/WP 02-10443
Preliminary Electron Paramagnetic Resonance (EPR) studies of copper/chromium (CC) treated spruce wood, subjected to laboratory soil decay test showed increased intensities of Mn(II) EPR signal in partially decayed specimens. Several reasons might be responsible for this phenomenon: Mn(II) could originate from the wood after being released from the typical ligand binding, from reduction of other Mn...
M Petric, M Humar, P Kalan, F Pohleven, U Schoknecht, M Šentjurc
Detection of increased metal cations after wood decay using Chromeazurol-S
1997 - IRG/WP 97-20112
Chromeazurol-S (CAS) is a dye used for the spectrophotometric determination of metals, mainly aluminum (Al), berillium (Be) and copper (Cu). CAS has been widely used for determining the penetration of copper containing preservatives like CCA (AWPA A3-96). Additional uses include: i) detection of utility pole decay (Esyln, 1979), ii) a chemical spot test for aluminum in wood (Kukachka and Miller, 1...
F Green III, U Srinivasan, R B Miller
Field study: Wood degradation pattern in buildings and utility poles in tropical climates of Nigeria
1992 - IRG/WP 92-1521
The paper is the result of five years field study of wood degradation patterns in three ecological forest zones (Guinea Savannah, Tropical rain forest and mangrove forest zones, respectively). It involved 800 residential buildings and 700 electric overhead transmission poles. The methodology used was a modified Eslyn (6) test. A high rate of Ascomycetes and Basidiomycetes attack especially on the ...
E O Onuorah
Possible durability transfer from durable to non durable wood species. The study case of teak wood
2001 - IRG/WP 01-10392
Teakwood is well known for its excellent natural durability, mostly due to its high proportion of extracts. Amongst these extracts, quinones, and more precisely some naphtoquinones (such as lapachol) and anthraquinones (such as tectoquinone) appear to play a crucial role in the resistance to wood decay organisms. At a laboratory scale, sawdust from malaysian teak heartwood has been extracted under...
M-F Thévenon, C Roussel, J-P Haluk
A study of fungal biodeterioration in unseasoned, packaged hem-fir lumber
1978 - IRG/WP 2116
This study was undertaken to determine the extent of biodeterioration that could occur within British Columbia (BC) prior to the export of packaged Canadian Lumber Standard Hem-Fir (Tsuga heterophylla, Abies amabilis and small amounts of Abies grandis). By examining the anti-stain treatments received by the lumber and identifying and characterizing the organisms responsible for the biodeterioratio...
P W Perrin, A J Cserjesi
Resistance of acrylic paints on wood against growth of the rot fungus Dacrymyces stillatus
1990 - IRG/WP 2345
In the last few years the presence of the rot fungus Dacrymyces stillatus has been repeatedly confirmed in external wood panels, particularly from wood painted with water based paints. A laboratory method for testing of the fungal resistance of paint films on wood has been developed.This method has been used to test the efficacy of the fungicides Parmetol DF 18 and Parmetol HF 25 against attack by...
J Bjurman
Method of embedding and staining of wood after biological testing to support the identification of decay type
1998 - IRG/WP 98-20131
A method for preparing wood for microscopic analysis after decay testing is described, with special regard to a novel fast simultaneous staining, which helps to identify different types of decay. The novel staining process is explained as well as the embedding of heavily decayed samples in polyethylene glycol (PEG) and picking up of sections by transparent adhesive tape. Special feature of the int...
A O Rapp
Occurrence and importance of various types of fungal and bacterial decay in CCA-treated horticultural pine posts in New Zealand
1984 - IRG/WP 1234
A detailed microscopical examination has been carried out on samples taken from CCA-treated pine posts exposed in horticultural soils. The following decay types were observed: white rot, brown rot, soft rot, tunnelling bacteria, cavitation bacteria, and bacterial erosion. The occurrence and importance of the various decay types between different regions, and plots within a specific region, varied ...
T Nilsson