Your search resulted in 680 documents. Displaying 25 entries per page.
Durability of acetylated Radiata pine: Laboratory tests and performance in practice
2020 - IRG/WP 20-40899
Wood acetylation is an established process to enhance biological durability and dimensional stability of lower valuable wood species without the use of biocides. Acetylated Radiata pine (ACCOYA® wood) has been on the market for more than 10 years now, starting in 2007.
Numerous lab tests have confirmed the high durability of acetylated Radiata pine. Here, additional data with four Radiata pine ...
K Jacobs, W Scheiding, B Weiß
Enhancing the durability of low durability Eucalyptus plantation species: a review of strategies
2020 - IRG/WP 20-40910
Eucalyptus species native to Australia have shown excellent growth rates, good physical properties and resistance to diseases. As a result, they are widely planted globally for a variety of uses. One negative aspect of many of these faster growing species is that they have a high percentage of low durability heartwood that resists preservative treatment. In Australia, large plantations of these sp...
K C Wood, J J Morrell, W Leggate
Wood protection with cement – Part 1: Coating matters and durability of cement coated wood
2020 - IRG/WP 20-40911
The use of wood in geotechnical applications has seen renewed interest. However, concerns related to the durability and service life of wood in ground contact applications remain. Wood has the potential to substitute commonly used steel and concrete in the geotechnical engineering sector, but solutions to extending the service life and maintenance intervals require long-lasting wood protection sys...
S Hirschmüller, B Marais, C Brischke, A Krey, J Bösing
Experience Experience from over 20 years of field trials of resin treated wood – Marine borer resistance of MMF and DMDHEU modified wood
2021 - IRG/WP 21-10976
In 1999 a field test of Scots pine treated with MMF (Methylated Melamine Formaldehyde) resin and acetylated Scots pine post treated with MMF resin was started. Six years later a commissioned full NWPC test for BASF of Belmadur® (DMDHEU resin treated wood) was started at the same site.
The testing, according to European Standard EN 275, was done in a bay by Kristineberg Marine Research Station o...
M Westin, P Larsson Brelid, A O Rapp, J Habicht
Studies on the material resistance and moisture dynamics of Douglas fir and Sitka spruce from Slovenia
2021 - IRG/WP 21-20677
Wood in outdoor applications is subject to various decomposition factors. Wood degradation can be prevented by construction details, biocide protection of wood, wood modification, or selection of naturally durable wood species. Unfortunately, the majority of timber species in Europe do not have naturally durable wood. Imported tree species represent a new pool from which we can draw wood species w...
M Humar, B Lesar, D Krzisnik, E Kerzic, R Brus
Mechanical and biological durability properties against soft-rot and subterranean termite in the field (grave-yard test) of beech wood impregnated with different derivatives of glycerol or polyglycerol and maleic anhydride followed by thermal modification in an opened or in a closed system
2021 - IRG/WP 21-40917
This paper presents mechanical and biological durability properties in soil beg test (soft-rot test) and field test (grave-yard test) against subterranean termite of the wood modified with an aqueous vinylic derivative of glycerol/polyglycerol or maleic anhydride cured in an opened or in a closed system. Wood modification was performed through impregnation of European beech (Fagus sylvatica) with ...
M Mubarok, H Militz, S Dumarcay, I W Darmawan, Y S Hadi, P Gerardin
Treatability of South African-grown Eucalyptus grandis with water-borne copper azole and disodium octaborate tetrahydrate wood preservatives
2021 - IRG/WP 21-40920
This study investigated the treatability of the sapwood and heartwood of sawn Eucalyptus grandis with copper-azole (CuAz) and disodium octaborate tetrahydrate (DOT) water-borne preservatives towards improving its durability for enhanced use in structural solid wood applications. The results obtained showed that, at a moisture content of 12 ± 1%, sawn E. grandis sapwood can be impregnated to a mea...
A A Alade, Z Naghizadeh, C B Wessels
Assessing the Performance of Wood-based Materials Exposed to Termite Risk – A New Experimental Approach
2022 - IRG/WP 22-10989
Termites are able to degrade a large number of building materials including wood, wood-based panels, biobased insulation, and polymers. The risk for a material of being degraded by termites depends on its composition, on its accessibility, and also on the behavior and the biology of the termite species considered. Within the EU project Click Design, we investigated the durability, under laboratory...
M Kutnik, I Paulmier, C Brunet, D Ansard, M Montibus
The effect of sapwood and heartwood differences on durability of short rotation teak wood
2022 - IRG/WP 22-10991
Short rotation teak has been developed to overcome the limited supply of long rotation teak. The aim of this study was to investigate the effect of sapwood and heartwood differences on durability of short rotation teak. The following basic properties were studied: extractive content, dimensional stability (volumetric swelling and water uptake), decay resistance, and termite resistance. The result...
R Martha, M Mubarok, F O Akong, B George, C Gérardin, S Dumarçay, I S Rahayu, I Batubara, W Darmawan, P Gérardin
Natural durability and moisture dynamics of commercially important European wood species after weathering
2022 - IRG/WP 22-10992
Wood is a frequently used material. Timbers’ mechanical properties, particularly its favourable strength-to-mass ratio, make them suitable for many uses. Current environmental awareness has led to its renewed importance as a building material. However, wood is susceptible to decay that severely affect its outdoor performance. This study investigated how weathering affects the natural durability ...
E Keržič, M Humar
Performance of wood exterior structures above ground in Spain. Performance and durability of a shelter of spruce in a shopping centre after 20 years
2022 - IRG/WP 22-20680
Across Europe is very common to find wood exterior structures mainly build in sawn and glue-laminated wood. Most of these exterior wood structures use softwood wood species such as: fir, spruce, pine or douglas. In Spain exterior wood structures, became more and more popular since nineties, when sawn and glue-laminated wood were utilized for building exterior wood structures in overall Spain. In m...
D Lorenzo, A Lozano, M Alonso, J Fernández-Golfín, M Touza, J Benito
Discrimination of five commercial wood preservatives by handheld near-infrared spectrometers and Multivariate Data Analysis
2022 - IRG/WP 22-20686
Nowadays, the recycling potential of wood waste is still limited, because of a lack of reliable lack of a reliable and fast device allowing the discrimination of preservative-treated wood that contains organic or/and inorganic contaminants. The purpose of this study was to set up a methodology, based on a SCiO low-cost handheld NIR spectrometer, and multivariate data analysis (MDA). Spectra was ob...
M Rubini, P Dulucq, B Charrier
Using satellite-retrieved soil moisture data to model the decay risk of in-ground timber
2022 - IRG/WP 22-20689
Satellite-derived soil moisture data from the Soil Moisture Active Passive (SMAP) was extracted for a 9 x 9 km point grid over Europe. The data was then used as input to a dose-response wood decay model based on terrestrial microcosm (TMC) tests. The resulting hazard map plotted dose as an indicator of in-ground wood decay based on differences in annual temperature and soil moisture characteristic...
P B van Niekerk, M Schönauer, B N Marais, C Brischke
Post-layup protection of mass timber elements in above ground protected exposures: 2-year results
2022 - IRG/WP 22-30766
Mass timber has seen increased use as a building material for low and mid-rise construction in recent decades. The durability of mass timber elements has not been fully examined and the effects of wood destroying organisms on this these materials merits attention. The effectiveness of currently labeled soil termiticides and passively applied biocides at post-construction or as remedial agents need...
M E Mankowski, T G Shelton, G T Kirker, J J Morrell
Above-Ground Termite Resistance of Naturally Durable Species in Ontario and Mississippi
2022 - IRG/WP 22-30767
A collaborative above-ground protected termite field test was initiated by FPInnovations and the USDA Forest Service at sites in Ontario and Mississippi. The aims of the experiment were to compare the rate of attack in protected, above-ground exposures by the subterranean termite species, Reticulitermes flavipes, between northern (Ontario) and southern (Mississippi) test sites and to generate perf...
R Stirling, M Mankowski
Copper Naphthenate – A Data and Capability Update
2022 - IRG/WP 22-30771
The efficacy of copper naphthenate against wood decay fungi and wood destroying organisms has been well documented from international field tests as well as decades of commercial service. The use of copper naphthenate has been dramatically expanded due to its proven performance, non-restricted use, minimal environmental impact, and superior end of life options. Extensive demand and interest has al...
J-W Kim, J D Lloyd
Effect of nanoparticle impregnation on the biological durability of wood
2022 - IRG/WP 22-30772
This study evaluated the efficacy of five different nanoparticles (zinc-oxide, zinc-borate, silver, copper-oxide, copper-borate) applied with different concentrations against the brown rot Coniophora puteana and the white rot Coriolus versicolor. The generally effective nanoparticle treatments were the combinations containing borate in its chemical structure. However, only zinc-oxide and silver na...
M Bak, R Németh
A novel wood preservation technology improving durability and water-related properties
2022 - IRG/WP 22-40926
A newly developed silicone oil (Archroma Management GmbH, Switzerland) was tested for wood modification purposes. Scots pine sapwood was treated with aqueous solutions of this silicone oil and showed a penetration of the modification agent into the wood cell wall. Both, biological durability and moisture-related properties, experienced significant improvements by the modification. Besides, the mod...
L Emmerich, H Militz, M Vila
Durability against fungal decay of sorbitol and citric acid (SorCA) modified wood
2022 - IRG/WP 22-40928
Most European-grown wood species are susceptible to biological degradation, specifically, they suffer from a poor resistance against wood-destroying fungi. Therefore, prior to outdoor exposure, wood has to be treated either by applying a protective coating on its surface or by full-volume impregnation with antifungal chemicals. However, due to environmental and health concerns, the most frequently...
K Kurkowiak, L Emmerich, H Militz
Environmentally Friendly Wood Modification based on Tannin-Furfuryl alcohol - Effect on stabilisation, mechanical properties and decay durability
2022 - IRG/WP 22-40929
Furfurylation is a well-known wood modification technology. This paper studied the effect of tannin addition on the wood furfurylation. Three kinds of dicarboxylic acids, adipic acid, succinic acid, and tartaric acid, as well as glyoxal as a comparing agent, were used to catalyse the polymerisation of furanic or tannin-furanic solutions during wood modification. Impregnation of furanic or tannin-f...
M Mubarok, E Azadeh, F O Akong, S Dumarçay, A Pizzi, C Charbonnier-Gérardin, P Gérardin
Evaluation of the physical properties of heat-treated native Peruvian woods for their application as coverings in buildings located in in arid, semi-warm and humid climates
2022 - IRG/WP 22-40943
Wood is a material that has properties suitable for its use in construction: as a structural component, cladding or decorative element, however, it is necessary to have knowledge of its physical, mechanical and thermal properties in order to have a logical criterion when applying it. It is known that wood has hygroscopic properties, so it tends to absorb the relative humidity of the natural enviro...
K Ayala Castro, A Loayza Argüelles, V J Pilco Mamani
Effect of densification of Eucalyptus nitens and E. obliqua on moisture uptake, swelling, decay resistance, and fire performance
2022 - IRG/WP 22-40946
Some Australian Eucalyptus species that are abundantly available have low natural durability and poor resistance to fire. These same species are also extremely difficult to treat with preservatives or fire retardants using conventional pressure treatment methods due to a large proportion of refractory heartwood. The aim of this research was to understand whether thermo-mechanical densification had...
B Hassan, J J Morrell, F Wiesner, W Wu, B Belleville, K C Wood
Improving wood durability by mineralisation and thermal modification
2022 - IRG/WP 22-40948
A significant increase in the fungal durability of wood was achieved by using a modification procedure combining two environmentally friendly methods: thermal modification and mineralisation. It offers an ecological alternative to other biocidal treatments. European beech (Fagus sylvatica) and Norway spruce (Picea abies) were selected as model wood species and exposed to four different fungi: Gloe...
R Repič, A Pondelak, D Kržišnik, M Humar, A S Škapin
Durability of thermotreated Pinus sylvestris and Eucalyptus nitens against wood decay organisms
2022 - IRG/WP 22-40949
One of the alternative treatments to avoid the application of biocides is thermal modification of wood, which increases the durability of wood against attack by wood decay organisms. The durability of Pinus sylvestris and Eucalyptus nitens thermotreated at 180 and 212 ºC, was studied. The results show that thermotreatment against wood decay fungi in P. sylvestris is slightly more effective than i...
M T Troya, S M Santos, L Robertson, N Pérez-Molina, V Baños, A Dieste
Durability of thermally modified western hemlock lumber against wood decay fungi
2022 - IRG/WP 22-40954
The chemical modification of wood is gaining popularity as a treatment to increase wood durability in the United States. Further standardization and testing of thermally modified North American species is needed to optimize the production of thermally modified products from regionally available resources. This work measures the impact of thermal modification of western hemlock lumber durability ag...
G Presley, J Cappellazzi, I Eastin