Your search resulted in 1773 documents. Displaying 25 entries per page.
Durability of thermally modified western hemlock lumber against wood decay fungi
2022 - IRG/WP 22-40954
The chemical modification of wood is gaining popularity as a treatment to increase wood durability in the United States. Further standardization and testing of thermally modified North American species is needed to optimize the production of thermally modified products from regionally available resources. This work measures the impact of thermal modification of western hemlock lumber durability ag...
G Presley, J Cappellazzi, I Eastin
Biocomposites based on PVA, cellulose nanofibrils and tannic acid
2022 - IRG/WP 22-40957
Biocomposite films based on a polyvinyl alcohol (PVA) with the addition of cellulose nanofibrils (CNF) as a reinforcing component and with the addition of the biologically active tannic acid (TA) were prepared. The influence of different additions of CNF and TA in the polymer matrix PVA on the mechanical properties, improvement of hydrophobicity of the prepared films was studied. In all cases, the...
U Osolnik, V Vek, I Poljanšek, Poven
Novel bio-based tannin/furfurylic alcohol thermosets: application to wood preservation
2022 - IRG/WP 22-40959
This project is integrated within the overall context of sustainable development and targets the valorization the wood industry by-products such as polyphenolic extractives, and in particular tannins. The objective targets the use of the same polymer used for production of tannin-furanic foams, but here for wood preservation to avoid the utilization of biocides. The aims is to the design of copoly...
C Gérardin-Charbonnier, E Azadeh, A Pizzi, P Gerardin
Biological durability for novel composites manufactured from green materials
2022 - IRG/WP 22-40960
Flax and Jute fabrics were used as reinforcements with polyester resin to form composite skins while poplar particleboard was used as a core for making composite sandwich structures by applying vacuum assisted resin transfer molding (VARTM) technique. Mechanical, physical, and biological properties of these novel green composite sandwich structures were evaluated. The results showed that the propo...
A S O Mohareb, A H Hassanin, A A Badr, K T S Hassan, R Farag
Unlocking the potential of tropical fast-growing hardwood species
2023 - IRG/WP 23-11010
Social forestry or community managed forestry practices have been promoted as an inclusive way to mitigate climate change through the framework of the UNFCCC scheme of the Reduce Emission Deforestation and forest Degradation (REDD+) programme. Fast growing wood species are one of the least tapped social forestry commodities in Southeast Asia, and they have the potential to be upscaled to meet the ...
S Fauziyyah, R Wimmer, C Brischke
Assessment of the Material Durability and Structural Integrity of the Wooden Velodrome in Češča vas, Slovenia
2023 - IRG/WP 23-11012
Wood is a widely used material in the construction industry, and it has been utilized for thousands of years to create buildings and other structures. When wooden structures are designed, built, and maintained properly, they can be safe and long-lasting. Sports facilities, which provide athletes with a space to train, compete, and improve their abilities, are crucial in creating a strong and susta...
D Kržišnik, M Humar, B Lesar
Natural durability of 9 tropical species suitable for round wood timber building: fungi and termites laboratory screening tests
2023 - IRG/WP 23-11013
In numerous tropical forest species, wood properties are poorly described and wood is under-valorized. Especially very few is known about small diameter trees although they may be used, directly as round wood, in construction timber building. A selection of abundant species was done and characterization tests were performed to assess their usability as building material. The aim of this work was t...
M Leroy, K Candelier, J Damay, J Bossu, R Lehnebach, M-F Thevenon, J Beauchene, B Clair
Isolation of the microbiota from wood decay insects and some of their enzymatic activities
2023 - IRG/WP 23-11014
Wood decay organisms have the ability to degrade wood components (cellulose, hemicellulose and lignin) by enzymatic capacities, but these enzymes can belong to the proper organism, or to the associated microbiota. The identification of the microorganisms, as well as their role in the digestion of many substrates not always is very well known.
The wood decay insects produce big damages in wood str...
M T Troya, F Llinares, J Arranz, S Izpura-Luis, S M Santos, L Robertson
Field durability testing of wood above ground - Part 1: 15 years’ experience with the Bundle method
2023 - IRG/WP 23-20695
A ‘jack of all trades’ method for above-ground wood durability testing has been sought for decades, but until now no method has found its way into standardization. The method of choice shall be applicable for untreated and treated wood – ideally also for wood composites. It shall be reproducible, objective, fast, easy, and inexpensive. Finally, it shall provide high predictive power.
This s...
C Brischke, G Alfredsen, L Emmerich, M Humar, L Meyer-Veltrup
Field durability testing of wood above ground - Part 2: The full guideline of the Bundle method
2023 - IRG/WP 23-20696
To determine the biological durability of wood above ground, numerous approaches for test methods have been pursued and tried out in the field in the past. So far, no method has managed to find its way into a European standard. During the last 15 years, experience with the Bundle method has been gained. As described in Part 1 of this paper, the method is recommended as a suitable tool for determin...
C Brischke, G Alfredsen, L Emmerich, M Humar, L Meyer-Veltrup
Laboratory durability testing of preservative treated wood products – first attempts and observations
2023 - IRG/WP 23-20697
In the past, durability classes (DC) had been assigned to wood species, sometimes also to homogenously modified wood-based materials such as thermally modified wood. More recently, some standards allow for classifying the biological durability of chemically modified wood, preservative treated wood and wood composites. Even treated products may be subject to durability classification, but necessary...
C Brischke, M Sievert, M Schilling, S Bollmus
Sensitivity of copper indicators for detecting preservative penetration
2023 - IRG/WP 23-20701
Chrome azurol S (CAS), 1-(2-pyridylazo)-2-naphthol (PAN), and rubeanic acid (RA) are the three copper indicators currently used by the timber industry to assess preservative penetration. Although only the American Wood Protection Association (AWPA) standards specify indicator sensitivity, it is unclear how those limits were developed. The sensitivity of each copper indicator was determined in solu...
T Yi, J Norton, S Meldrum, J J Morrell
Geopolymer as a fixation method for tannin-based wood preservatives
2023 - IRG/WP 23-30774
This study aims to test if a second step impregnation with a geopolymer solution can fix Colatan GT10, a commercial extract rich in tannins, to wood, reducing their leaching and improving their performance as wood preservatives. Scots pine sapwood specimens of 40×10×5 mm3 were impregnated with Colatan GT10 tannin mix, geopolymer, and as combined treatment Colatan GT10 with subsequent geopolymer ...
Y M López-Gómez, A Barbero-López, A Haapala
A six-year ground proximity trial of TRU-CORE treatments at Innisfail, Queensland
2023 - IRG/WP 23-30775
This article describes an H3 (above ground outdoor) ground proximity field trial that compares the performance against decay fungi of TRU-CORE (also known as the Buffered Amine Oxide Enhancement System) Copper Quat (CQ) with CCA and commodity Alkaline Copper Quat (commodity-CQ) treatments, all in Pinus radiata. The retentions achieved reflected commercial practice, where higher mean retentions are...
L Cookson
Improvement of durability of Scots pine against termites by impregnation with citric acid and glycerol followed by in situ polyesterification
2023 - IRG/WP 23-30777
Scots pine (Pinus sylvestris) sapwood samples were impregnated with solution containing citric acid (CA) and glycerol (Gly) followed by heating 140 °C according to already described procedure (L'hostis et al. 2018). The resulting modified woods were then used to evaluate the effect of chemical modification on the durability against termites. Two kinds of experiments were conducted for this purpos...
M Mubarok, J Damay, E Masson, E Fredon, Y S Hadi, I W Darmawan, P Gerardin
Establishing the minimum effective penetration of wood preservatives in the refractory heartwood of E. nitens
2023 - IRG/WP 23-30780
Conventional pressure treatment of many Australian hardwoods results in little to no penetration of heartwood and a non-uniform envelope treatment of <5 mm surrounding a mostly untreated core. This is a major issue for many of the low durability plantation hardwood timbers that are grown in Tasmania, which contain high percentages of heartwood. Long term studies on softwoods such as spruce decking...
J R Vargas, J J Morrell, L Yermán, K C Wood
Reuse of discarded wood and alternative wood species to replace spruce in the development of wooden windows for complete disassembly – REWINNUSE
2023 - IRG/WP 23-30785
The REWINNUSE project focuses on the reuse of discarded wood and alternative wood species and on the development of wooden windows that can be easily disassembled into their basic components. In cooperation with the project partners (M Sora, the University of Ljubljana Biotechnical Faculty (BF), the Norwegian Institute of Bioeconomy - NIBIO and the Slovenian Forestry Institute (GIS)), the project ...
B Lesar, M Humar, J Levanič, A Treu, A Ugovšek, L Kramarič, B Štrakel, L Križnar, B Šubic, J Gričar
Performance of treated Malaysian semantang bamboo (Gigantochloa scortechinii) - field and laboratory durability evaluation
2023 - IRG/WP 23-30788
Field performance of sematan bamboo, Gigantochloa scortechinii was evaluated under the Malaysian tropical climate, along with laboratory evaluation to white-rot fungi and mold. Starch was removed from the bamboo by submerging the bamboo in the river for 6-8 weeks, kiln-dried and cut to 300 mm (L) round bamboo and 25 mm (W) x 50 mm (L) stripe for the field and laboratory test respectively. Bamboo w...
S Lipeh, T Khadiran, Z Jalaludin, M K Anwar U
Above Ground Proximity Decay Field Trial of Modified ACQ-A, Wolman® CA-B and Wolman® CA-C in Taiwan
2023 - IRG/WP 23-30793
An above ground proximity decay field trial was established at Chiayi county, Taiwan in July 2016. The purpose of this study was to generate local field performance data for Taiwan for Slash Pine treated with Wolman® CA-B, Wolman® CA-C and a modified ACQ-A product at AWPA UC3B actives retention. After 6 years of field trial, the efficacy of the wood preservative in preventing decay fungi and ter...
J-Y Gan
Biological durability and wood-water interactions of sorbitol and citric acid modified wood – Effects on the expected service life
2023 - IRG/WP 23-40960
A high level of research activities on sorbitol and citric acid (SorCA) modified wood has been recognized in Europe over the last few years. As this treatment is close to entering an industrial-scale production, it is of interest to investigate how such treated wood performs upon long-term outdoor exposure. Hence, in this study Scots pine (Pinus sylvestris L.) sapwood was modified with aqueous sol...
K Kurkowiak, L Emmerich, H Militz
Estimation of single shear strength performance of screw joints with decayed wood
2023 - IRG/WP 23-40968
In order to use existing wooden structures for a long term, it is necessary to evaluate appropriately the damage degree of bio-deterioration of the structural performance including the members and joint systems. As one for them, it is necessary to estimate more accurate the single shear strength performance of screw joints with decay. Therefore, we proposed the model considering the yield strength...
R Inoue, K Tanaka, T Mori
Investigating the fire properties of a composite material made of MDF-residues, citric acid and sorbitol
2023 - IRG/WP 23-40969
In times of climate change and a shortage of energy and raw materials, it has become apparent, that material reuse of wood in a cascade system can reduce the ecological impact of a material and be cost effective. A new composite material has been developed made from citric acid, sorbitol, water and waste MDF. Not only will there be a material reuse option for waste MDF but due to the small particl...
P T Lewandowski, W Perdoch, E Larnoy, H Militz
Optimization of furfurylic alcohol/tannin ratio to improve the performance of biosourced thermoset resins for wood protection
2023 - IRG/WP 23-40994
This study concerns the chemical modification of wood with different ratios of tannin and furfuryl alcohol (FA) in the presence of maleic acid as catalyst. Tannins were used not only as cross-linking agents, but also as co-monomers to improve wood durability, while reducing the amount of FA used. Different aqueous formulations were prepared containing decreasing amount of FA (from 45.45% to 0%) an...
E Azadeh, A Pizzi, P Gérardin, C Gérardin-Charbonnier
Fungicidal properties of black liquor from the waste MDF board digestion in terms of wood protection
2023 - IRG/WP 23-50379
The aim of the work was to determine the fungicidal properties of black liquor as a product of the chemical digestion of waste MDF board. The resistance of wood treated with black liquor from MDF waste pulping process was compared with the resistance of wood treated with black liquor from the pulping process of a by-product from agricultural production. The control material consisted of non-treate...
B Mazela, W Perdoch, A Szulc, I Sieminska
Utilising novel service life prediction methods for robust and precise Life-Cycle-Costing (LCC)
2023 - IRG/WP 23-50384
Life-Cycle-Costing (LCC) is one of the basic indicators for the assessment of sustainability and cost effectiveness in construction applications. Project WoodLCC was thus conceived to enable LCC through input from models for detailed service life planning of wooden components and buildings. The project is a continuation of the service life planning research conducted in Europe over the last three ...
P B van Niekerk, G Alfredsen, T Kalamees, R Modaresi, A Sandak, J Niklewski, C Brischke