Your search resulted in 269 documents. Displaying 25 entries per page.
New methods for estimating the volume of shipworm tunnels supported by image analysis
2020 - IRG/WP 20-20668
In marine environment, the main threat for wood is the bioerosion by woodborers, both peracarid crustaceans (such as gribbles Limnoria and pincher scuds Chelura) and bivalve molluscs (shipworms, Teredinidae).
The damage caused by gribbles on wood structure is surficial and easy identifiable, whereas the damage caused by shipworms is internal, therefore not evident, inducing unexpected crashes wit...
I Guarneri, M Sigovini, E Keppel, D Tagliapietra
Monitoring of wood preservatives exposed to weathering: Extraction and analysis methods of organic biocides from treated wood and collected rain runoff
2020 - IRG/WP 20-30753
Weathering is the cause of numerous damages for outdoor joineries. Protection of wood using a preservative treatment covered with a coating is a process widely used to limit these damages. However, biocides from preservative treated wood are prone to degradation and leaching, having a direct influence on the joinery service life. This document deals with extraction and analytical methods for bioci...
O Ouali, K Le Ménach, E Raphalen, L Podgorski, S Legay, H Budzinski
Comprehensive protection of timber in seawater
2020 - IRG/WP 20-10970
The hazard of wood in seawater can be divided into two areas: Below the water level, shipworm (Teredo navalis) and gribble (Limnoria lignorum) can attack non-resistant or insufficiently protected wood; above the water level, there is a risk by wood-destroying fungi and, to a lesser extent, insects. In a national project funded by the Deutsche Bundesstiftung Umwelt (DBU, German Federal Environmenta...
E Melcher, J Müller, T Huckfeldt
Plasma treatment of wood - a review of 15 years of research in Göttingen
2021 - IRG/WP 21-40913
Wood is an important renewable resource and can be found omnipresent in everyday life. Its natural properties offer numerous advantages regarding physical, mechanical but also aesthetic aspects, but also challenges that one has to address with various modification methods.
Driven by the desire to promote the use of promising new technologies using plasmas, there has been a close research network ...
P Sauerbier, R Köhler, G Avramidis, W Viöl, H Militz
Discrimination of five commercial wood preservatives by handheld near-infrared spectrometers and Multivariate Data Analysis
2022 - IRG/WP 22-20686
Nowadays, the recycling potential of wood waste is still limited, because of a lack of reliable lack of a reliable and fast device allowing the discrimination of preservative-treated wood that contains organic or/and inorganic contaminants. The purpose of this study was to set up a methodology, based on a SCiO low-cost handheld NIR spectrometer, and multivariate data analysis (MDA). Spectra was ob...
M Rubini, P Dulucq, B Charrier
Analysis of wooden shingles after seven years of exposure
2022 - IRG/WP 22-20690
Wood is a traditional roofing material in the Alpine regions. In the 17th century, wooden roofing was typically used on more important buildings. Still, today it is predominately used on huts and houses in the hilly regions of northern and north-western Slovenia. Because wooden roofing is expensive, we investigated the possibility of extending the service life of the roofing through impregnation a...
M Humar, B Lesar, D Kržišnik, E Keržič, B Jemec
Green approach in wood mineralization for improvement of fire properties
2022 - IRG/WP 22-30769
Various treatments have been developed in order to improve fire properties of wood. Because the use of some flame retardants can release toxic compounds in the event of a fire, leading to poisoning or even death of people from smoke inhalation, the use of no-toxic and more ecologically acceptable flame retardants is preferable. Mineralization of wood with the incorporation of carbonates has proven...
A Pondelak, R Repič, L Škrlep, N Knez, F Knez, A S Škapin
Effect of nano-particle characteristics and concentration on UV protection of timber: A field exposure test
2022 - IRG/WP 22-40941
Wood has a well-known susceptibility to ultra-violet light degradation, leading to premature replacement. A variety of products have been developed to protect against this damage, but most provide less than 12 months of protection and must be regularly reapplied. Developing improved coatings would help reduce wood losses and reduce maintenance costs. Nano-particles have a variety of attractive pro...
T Yi, J J Morrell
A Comparison of Cross-Laminated Timber (CLT) Floor Panels using Finite Element Analysis and Experimental Fire Testing
2022 - IRG/WP 22-40955
Cross-laminated timber (CLT) is a relatively new timber product and has gained popularity in North America and Europe as a construction material. As a sustainable engineered timber product, CLT offers many advantages over solid wood, concrete, or steel construction. However, the use of timber in medium to high rise buildings is often avoided mainly due to its combustible nature. In this paper, a n...
M Yasir, A Macilwraith, K Ruane
Unlocking the potential of tropical fast-growing hardwood species
2023 - IRG/WP 23-11010
Social forestry or community managed forestry practices have been promoted as an inclusive way to mitigate climate change through the framework of the UNFCCC scheme of the Reduce Emission Deforestation and forest Degradation (REDD+) programme. Fast growing wood species are one of the least tapped social forestry commodities in Southeast Asia, and they have the potential to be upscaled to meet the ...
S Fauziyyah, R Wimmer, C Brischke
Metabolite analysis of fungal COS degradation and phylogenetic investigation of COSase genes
2023 - IRG/WP 23-11018
Fungi are the major species causing microbial deterioration that reduces the commercial value of wood, such as wood decay and surface contamination, so it is important to accumulate knowledge on the physiology of fungi in order to develop countermeasures against these problems. Most physiological studies of fungi that have been reported have concerned the metabolism of carbohydrates as a source of...
R Iizuka, S Hattori, I Ohtsu, D Hibbett, Y Katayama, M Yoshida
Analytical retentions of active ingredients in H2F treated framing over a 12-year period
2023 - IRG/WP 23-20702
The H2F hazard class in Australia was developed to treat internal framing timber with a surface application of an insecticide, to control mainly termites. Two of the actives approved in AS 1604.1-2010 (and subsequent revisions) for this hazard class are bifenthrin and imidacloprid. The penetration zone of both actives is 0 – 2 mm from the wood surface.
Radiata pine sapwood framing timber wa...
A Siraa
Simulations of microclimates for wood-decaying fungi in the built environment using environmental analysis
2023 - IRG/WP 23-20703
Simulations of fungal decay risk were run on two similar building geometries exposed to typical annual climate conditions of two different geographical locations, Brunswick (Germany) and Cairns (Australia). The simulations were conducted to capture the effect of wind-driven rain and solar irradiation exposure over nodes of the common building geometry. The moisture content and temperature variatio...
P B van Niekerk, J Niklewski, S H Hosseini, B N Marais, I Frimannslund, T Kringlebotn Thiis, C Brischke
Influence of weathering of wood surfaces before and after treatment with iron(II) sulphate
2023 - IRG/WP 23-30786
Outdoor wood is exposed to various factors that cause the wood to grey or age. The ageing processes can vary greatly depending on the exposure. Parts of the wood that are not exposed to external factors, e.g. under the eaves, are less exposed and the ageing process is therefore slower. This can be accelerated by solutions based on iron ions. In this way, the wood greys quickly and evenly. However,...
B Lesar, M Humar, F Osvald
Investigating wood anatomical factors influencing the treatability of refractory southern pine- an imaging approach
2023 - IRG/WP 23-40975
Southern pine sapwood is non-durable, and preservative treatment is necessary to protect it against biological degradation. According to AS 1604.1 2021, timber products must have their sapwood fully treated with preservatives for various applications and hazard classes. However, there is a growing industry concern over the refractory sections of sapwood, which are untreated pockets of wood that do...
M Shirmohammadi, M R Karbaschi, B Hassan, W Leggate
Multi-scale Experimental Study on Self-sustained Smouldering of CCA-treated Timber Poles
2023 - IRG/WP 23-40988
While it is accepted that appropriate treatment with chromated copper arsenate (CCA) will extend the design life of wood markedly, there are concerns regarding the effect of treatment on fire performance. Smouldering combustion in CCA-treated timber infrastructure can self-sustain, destroying the timber elements, as the chromium and copper present in the CCA can act as catalysts of the smouldering...
W Wu, L Yerman, J J Morrell, F Wiesner
Assessment of historical pilings from Lisbon
2024 - IRG/WP 24-41004
The renovation and rebuilding of areas in Lisbon has led to work on buildings constructed in the Pombaline downtown district. These buildings were constructed on wooden pilings, as a means of stabilising unstable soils and transfer the loads from buildings to soils with adequate bearing capacity. These methods also increased the resilience of the reconstruction works to future possible earthquakes...
D Jones, S Duarte, J A J Huber, L Nunes
Changes in decay risk of wood in ground contact over Europe, from analysis of historic climate conditions
2024 - IRG/WP 24-41008
Changing climate conditions will affect global temperature and precipitation patterns, shifting some geographical areas into states that are more suitable for fungal wood decay. Climate normals, which are taken over a 30-year period, capture vast spatial and temporal variations in these conditions and comparing these can show changes over time. Importantly, being able to identify locations that ha...
P B van Niekerk, B N Marais, G Alfredsen, C Brischke
Analysis and performance of spruce alternative species and discarded wood for windows production
2024 - IRG/WP 24-50386
Climate change is having a significant impact on European forestry, particularly on the softwood species used for window frames. This study investigates potential replacement tree species for spruce (Picea abies), the predominant material for window frames. We evaluate Douglas fir (Pseudotsuga menziesii), Scots pine (Pinus sylvestris), thermally modified poplar (Populus nigra) and discarded silver...
B Lesar, J Levanič, M Humar, A Treu