Your search resulted in 3832 documents. Displaying 25 entries per page.
Formation of biofinishes on outdoor exposed wood; the impact of wood-oil combination and geographical location
2016 - IRG/WP 16-10864
Growth of dark moulds enables the use of a decorative and protective biofinish for wood, showing advantages compared to traditional wood-coatings in terms of sustainability and self-repair. Based on the formation of a uniform mould covering on oil treated wood during outdoor exposure, the utilisation of a biofinish is in development. Basic information is lacking on the correlation between exposure...
E J van Nieuwenhuijzen, L Ross Gobakken, M F Sailer, R A Samson, O C G Adan
Wood Natural durability study source of biomolecules: case of Dicorynia guianensis Amsh. heartwood
2016 - IRG/WP 16-10871
The chemical investigations of Dicorynia Guianensis heartwood led to the isolation of four new indole alkaloids for the first time in this plant Compound (1) identified as spiroindolone 2’,3’,4’,9’ -tetrahydrospiro [indoline-3,1’pyrido[ 3,4-b]-indol ]- 2- one, and compound (3) described as nitrone 1-methyl-4,9 -dihydro-3H-pyrido [3, 4-b] indole 2 – oxide and were isolated for the first...
J-B Say Anouhe, A A Adima, F B Niamké, D Stien, B Kassi Amian, D Virieux, J-L Pirate,S Kati-Coulibaly, N Amusant
Fungal decay of archaeological waterlogged oak timber: role of the mineral content
2016 - IRG/WP 16-10873
In service, wood foundation poles are subjected to water level fluctuation in soil. While wood is saturated by water only bacterial decay occurs. When oxygen content increases and moisture content decreases, severe fungal attack may occur. To evaluate the long term fungal durability of wood foundation pole in the context of service, 300 years waterlogged archaeological wood poles were used. The oa...
A Besserer, M Letellier, E Fredon, Q Kleindienst, M-L Antoine, C Perrin, J Lallemand, C Rose, M-C Trouy
Cultural heritage – research into innovative solutions and methods for historic wood conservation
2016 - IRG/WP 16-10874
Nowadays, interdisciplinary knowledge, tools and techniques are increasingly used to protect and conserve monuments representing our cultural heritage. This is of great importance especially in case of conservation and restoration of wooden historic artefacts which, as a result of physical, chemical and biological corrosion, have lost their technical, aesthetic and decorative properties. If those ...
M Broda, B Mazela
Global survey on durability variation – on the effect of the reference species
2016 - IRG/WP 16-20573
Climate change due to anthropogenic emissions is the largest environmental challenge of our time. Forest-based value chains play an important role in reducing the accumulation of CO2 in the atmosphere. Maximizing the use of wood to tackle climate change requires improved understanding of the service life of timber products. This information can best be obtained from field testing and while there i...
R Stirling, G Alfredsen, C Brischke, I De Windt, L P Francis, E Frühwald Hansson, M Humar, J Jermer, M Klamer, M Kutnik, P Laks, I Le Bayon, S Metsä-Kortelainen, L Meyer-Veltrup, P I Morris, J Norton, T Singh, J Van Acker, J Van den Bulcke, T M Venås, H Viitanen, A H H Wong
CCA Treated Wood, Will It Last 100 Years?
2016 - IRG/WP 16-20575
Copper, chrome and arsenate (CCA) treated wood has a very successful history of use in New Zealand, for at least 60 years. In many parts of the world, CCA has been used for timber treatment since the mid-1930s. In this report, data are presented on the performance of CCA treated pine stakes and poles. Results from ground contact durability tests at Scion and other overseas test performance data su...
T Singh, D Page
Weather degradation of thin wood samples
2016 - IRG/WP 16-20578
Untreated wooden surfaces degrade when exposed to varying doses of natural weathering. In this study, thin wood samples were studied for weathering effects with the aim of modeling the degradation utilizing Near-infrared hyperspectral imaging. Several sets of samples were exposed outdoors for time intervals from 0 to 21 days, and one set of samples was exposed to UV-radiation in a laboratory chamb...
I Burud, K A Smeland, K Hovde Liland, T K Thiis, J Sandak, A Sandak, L Ross Gobakken
Bundle tests - Simple alternatives to standard above ground field test methods
2016 - IRG/WP 16-20581
Within this study we applied different new above ground test set ups to untreated Norway spruce (Picea abies Karst.) and Scots pine sapwood (Pinus sylvestris L.) which are frequently used as reference or control species in wood durability field tests. The overall aim of this study was to find a simple alternative method to the few standardized above ground field test methods, such as the L-joint a...
C Brischke, L Meyer-Veltrup
Commercial Timbers of Kenya
2016 - IRG/WP 16-10876
The global timber trade has for years been too familiar with an assortment of available African timbers, reputed for their appearance in terms of colour, grain, pattern and durability. African forests are fast disappearing through over-exploitation as a result of demand for agricultural land. Kenya, the home of some of these valuable hardwoods, has been similarly affected, with its forest land cov...
R Venkatasamy
Release of Copper from Pressure Treated Wood
2016 - IRG/WP 16-20584
Micronized copper based wood preservatives including micronized copper quat (MCQ) and micronized copper azole (MCA) have been introduced commercially to the North American market since 2006 as alternatives to alkaline copper quat (ACQ) or soluble copper azole (CA) preservatives. Unlike ACQ or CA, MCQ and MCA use dispersed particulate copper particles rather than soluble ionic copper to make treat...
Jun Zhang, J Horton
Simulation of surface climate and mould growth on wooden façades
2016 - IRG/WP 16-20585
The weathering of wooden surfaces is normally caused by mould growth, lignin deterioration and leaching of extractives. For well insulated buildings, the effect of the interior climate on the outer surface is small and sometimes negligible. This paper describes simple models for surface temperature and moisture conditions on a wooden façade that can further be used to model weather degradation an...
T K Thiis, I Burud, D Kraniotis, L Ross Gobakken
Characterization of waste from Pinus radiata generated during industrial thermal-treatment
2016 - IRG/WP 16-20586
The thermal-treatment is an established chemical-free process to modify wood, improving the durability and physical properties of wood through its service life. During the hydro-thermolysis several reactions from wood components occur, releasing volatile and non-volatile compounds from wood to the chamber. Once the process is accomplished, solid residues agglomerate below the wood load and gaseous...
R Herrera, D Thomas da Silva, R Llano-Ponte, J Labidi
Expert versus multi-sensor evaluation of wood samples after short term weathering
2016 - IRG/WP 16-20587
Understanding the influence of weathering factors and the material degradation mechanisms are fundamental for modelling the weathering process of wood. The goal of this work was to investigate the combined effect of time and exposure on the physical-chemical mechanisms of wood weathering. Four exposure directions (North, South, East and West) were investigated. Experimental tests were performed fo...
A Sandak, J Sandak, I Burud, L Ross Gobakken, M Noël
Preparation of Calibration Standards for the Analysis of Pentachlorophenol in Treated Wood by X-ray Fluorescence
2016 - IRG/WP 16-20591
The primary purpose of this project was to develop a method for preparing calibration standards that can be used by the wood treating industry to calibrate X-ray fluorescence instrumentation. Calibration standards of penta/P9-oil in southern yellow pine that cover the retention range of 0.2 to 0.9 pcf (0.6 to 1.9 %) were successfully prepared. A detailed procedure for mixing penta in treating sol...
L L Ingram Jr, H M Barnes, R Shmulsky, D Jeremic
Durability of a willow/plastic composite mat
2016 - IRG/WP 16-20592
Developing uses for wood wastes could enhance utilization of low value renewable materials while creating opportunities for rural development. Small diameter willow stems have little use in China, but they could be combined with high density polyethylene to create wood plastic composite mats for decorative applications. These mats could be used in exterior, above ground exposures, but would still ...
Li Yan, Haiyan Duan, Beizhan Quan, J Cappellazzi, J J Morrell
Distribution and penetration of the tung oil in wood studied by high-resolution magnetic resonance imaging
2016 - IRG/WP 16-20593
Water repellents as environment-friendly treatments are gaining their popularity as non-biocidal solutions for wood protection. One of the most important water repellents for wood besides waxes and organosilicon compounds are drying oils. Tung oil is one of the best performing oil. However, tung oil, similarly as other oils, does not penetrate deeply into wood, due to its high viscosity. In order...
M Žlahtič, U Mikac, I Serša, M Merela, M Humar
Evaluation of field test data
2016 - IRG/WP 16-20594
The resistance against fungal decay and insect attack of wood can be highly variable, between boards and even within boards. The variability in durability is not always an issue, but for high demanding applications information about its reliability is required. This comprises the variability of outdoor performance. Durability testing in laboratory and outdoor exposures can provide a good basis to ...
F Bongers, C Brischke, J Van den Bulcke, W Gard, I De Windt, H Militz
Moisture monitoring in WW2 partisan hospital Franja
2016 - IRG/WP 16-20596
Material climate of wood used for construction of WW2 Partisan hospital Franja was monitored for approximately one year. Partisan hospital is located in the bottom of tiny gorge Pasice in Slovenia. Hence, wood moisture content on eight respective location and wood temperature was determined twice per day with Scanntronik equipment Gigamodul and Thermofox. The results clearly showed that despite of...
M Humar, N Thaler, B Lesar, A Žagar
Engineering for Rural and Civil Development. Uni Performance of wood exterior structures above ground contact in Spain built with softwood species. The situation of cases in northern Spain
2016 - IRG/WP 16-20597
Across Europe is very common to find exterior structures build in sawn and glue-laminated wood. Most of these exterior structures used softwood wood species such as fir, spruce, larch and pine. In Spain wood exterior structures, as for example bridges, became more and more popular since eighties, when sawn and glue-laminated wood were utilized for building exterior wooden structures in overall Spa...
D Lorenzo, J Fernández-Golfín, M Touza
Insight in moisture dynamics of wood treated with organosilicon compounds
2016 - IRG/WP 16-20598
The SILEX project “Improving sustainability of construction materials using innovative Silicon based treatment” is a Life+ project with reference LIFE+11 ENV/BE/1046 and started in April 2013. This project intends to demonstrate that a new class of compounds can be used for wood treatment for an extended service life combined with enhanced new testing methodology. The project aims at demonstra...
J Van Acker, J Van den Bulcke, I De Windt, S Colpaert, S De Rocker, S Salvati, J-P Lecomte
Effects of fungal exposure on air and liquid permeability of nanosilver- and nanozincoxide-impregnated Paulownia wood
2016 - IRG/WP 16-30680
Effects of aqueous dispersion of silver and zinc-oxide nano-particles on air and liquid permeability of Paulownia wood exposed to T. versicolor were studied in the present research project. Specimens were also heat-treated at 100 and 150°C and compared with the control specimens. Permeability values were measured when the moisture content of the specimens was 12%. Results showed significant incre...
H R Taghiyari, A Kalantari, M Ghorbani Kookandeh, F Bavaneghi, M Akhtari
A non-VOC approach of solvent-based wood preservatives for remedial treatment
2016 - IRG/WP 16-30681
Solvent-based wood preservatives are the workhorses in the field of remedial treatment. Due to new European regulations on the indoor air quality there is an increasing pressure on the VOC-content on these solvent-based product types. The transfer of these European regulations into national law is left up to each European member state and handled in different ways. E.g. France has introduced a VO...
M Pallaske, S Hellkamp, P Jüngel
Accelerated Weathering Performance of Impregnated Wood Samples Coated with Zinc by Means of Plasma-Assisted Particle Deposition
2016 - IRG/WP 16-30682
Many different methods are currently applied for wood protection against outdoor conditions. The most important of these is the process of impregnation with liquid substances. However, this kind of wood preservatives cannot provide a long-term protection of wooden surfaces. Weathering-resistant surfaces can be obtained by applying UV absorbing agents. In this study, the influence of zinc particles...
A Can, H Sivrikaya
Effect of the Storage Time of Logs in Anti-Stain Treatment Effectiveness
2016 - IRG/WP 16-30683
Storage of green lumber, for 7 months, operationally treated with anti-stain products, depending on the storage time of the logs (10, 20 and 30 days) post harvesting allows to affirm that with increasing storage time of the logs, occurs a progressive increase in intensity, severity and types of fungi present in the logs. It is further noted, a significant increase in the percentage of sawn lumber ...
M A Peredo, C Barria
Anti-Fungal Activity on Some Wood extracts as a Wood Protectant
2016 - IRG/WP 16-30684
In this study, six different wood barks were used, where obtained bark extracts were blended with potato-agar in order to investigate their antifungal properties. To determine the inhibition effectiveness of extractives, two different fungi; Coniophera puteana and Trametes versicolor were selected. Fungal activity was carefully observed for the duration of seven days. Following biological testing,...
Ö Özgenç, S Durmaz