Your search resulted in 3181 documents. Displaying 25 entries per page.
Investigation of some technical properties of heat-treated wood
2003 - IRG/WP 03-40266
The objective of this study was to investigate some technical properties of heat-treated wood.
Wood heat-treated according to a process intended for wood in above-ground end-uses (European hazard class 3) was subject to the following:
· A delamination test according to EN 391 with glulam beams made of heat-treated pine (Pinus sylvestris) and spruce (Picea abies) laminations, assembled with PR...
C Bengtsson, J Jermer, A Clang, B Ek-Olausson
Exterior wood stains
1980 - IRG/WP 3135
Experience has shown that conventional paints cannot now be relied upon to provide a complete seal against water entry, that in practice water can often circumvent the film and that the paint, far from serving to keep water out will seal it in. Moreover present-day paints are often subject to localised and premature failure out of doors and consequently entail high maintenance costs. Problems of w...
E R Miller
The resistance of wood coated with different solvent-borne paints against colonisation by decay fungi
2009 - IRG/WP 09-40468
This paper examines different solvent-borne paints characteristics and their decay resistance when applied on pine wood surface. It was determined by the standard ENV 839 procedure. The part of samples were subjected to accelerated ageing according to the EN 84 standard. The discussed commercial paint systems were typical stains or penetrating oil-based products, with or without biocides....
B Mazela, P Hochmańska
The Effect of Soil on the pH of Untreated Southern Pine in Ground Contact
2010 - IRG/WP 10-10742
Untreated southern yellow pine samples were subjected to three soils that had been amended to provide acidic, neutral and alkaline conditions. Wood pH was measured prior to, and then one, two, four and eight weeks after being placed in the soil to determine the effect of soil pH on wood pH....
C Vidrine, C Schauwecker, L Jin, A F Preston
Status of Wood Protection in Slovenia
2010 - IRG/WP 10-40491
Status of wood protection in Slovenia is described in this document. The most important factors that influence use of wood in our country are outlined. Furthermore, there are companies that formulate wood preservatives, their products and wood impregnation facilities are listed as well....
M Humar
Situation of Wood Protection in Spain
2010 - IRG/WP 10-40511
This paper shows the actual situation of Spanish Wood Protection. In the evolution of this sector over the last years, three factors have been very important: the increase of the use of wood for both structural and decorative uses in construction, the development of the Technical Building Code, and the transposition and implantation of the Directive of Biocides to Spain in October 2002....
B J Duval, J M Solis, T de Troya, M J Prieto
Vapour boron treatment of wood based panels: Further studies on mechanical properties
1993 - IRG/WP 93-30028
Samples of medium density fibreboard, chipboard and oriented strandboard were treated to two retentions of boric acid by vapour phase methods. The results of short term mechanical tests on this material were discussed by Hashim et al. (1992). The present paper discusses results with long term studies on bending and impact resistance with panel types. Long term tests of impact resistance showed no ...
R Hashim, R J Murphy, D J Dickinson, J Dinwoodie
How to keep coated wood structures sufficiently dry to avoid damage caused by rot
1991 - IRG/WP 2376
During the last ten years, a new type of problems with wood rot has emerged in Scandinavia. Thousands of houses have been damaged by wood rot attaching to the exterior wood panel. This paper provides an overview of finished and ongoing work in order to identify the cause of these problems. In field tests, the moisture conditions were measured in panels coated with different paint systems. The infl...
S Hjort
Treatability and retainability of two important bamboo species - borak and jawa of Bangladesh
2002 - IRG/WP 02-40248
Preservative treatment has been carried out with five different concentrations, i.e. 3%, 4%, 5%, 6% and 7% and durations, i.e. 2 days, 4 days, 6 days, 8 days and 10 days, at different moisture content, i.e. green and air-dry, and different direction of penetration, i.e. radial and both radial and cross-section for jawa and borak. It has been observed that retention of CCB is always higher in jawa ...
M N Islam, A K Lahiry, M O Hannan
Safer alternative reagents for colour differentiation of heartwood and sapwood
1994 - IRG/WP 94-20028
Benzidine and dimethyl yellow reagents have been used for distinguishing heartwood from sapwood in the Pinaceae and Araucariacae families, and in Eucalypt species. Both have been classified as carcinogenic by European and United States authoritites, yet the need for effective heartwood/sapwood differentiation remains, not only in the laboratory but also out in the timber processing chain. Safer al...
A Zosars, M J Kennedy
Fungal resistance of smoke-dried Cryptomeria japonica wood
1998 - IRG/WP 98-40118
Performance of smoke dried wood on fungal resistance was studied. The maximum temperature of the smoke seasoning was 80-90°C in the drying room and 70-80°C within the wood for 6 days during the treatment for 15 days. Decay resistance of smoke-dried Cryptomeria japonica wood was evaluated using a brown rot fungus, Tyromyces palustris. Weight losses of untreated wood, smoke-dried wood, and smoke-d...
K Yamamoto, I Momohara, T Nishimura
Building With Wood an strategic action in Spain
2010 - IRG/WP 10-40530
This paper explains the objectives and results of the “Building with Wood” project, mainly at Spanish level. As far as the wood preservation field is concerned, the present abstract also informs about the main goals of the project in this matter....
M Conde García, J I Fernández-Golfín Seco, J Galván Rodríguez
A new model for wetting and drying of wood end-grain – with implications for durability and service-life
2011 - IRG/WP 11-20477
New experimental data for wetting and drying of wood end-grain, Sandberg (2009), imply that traditional models for moisture transport are not at all applicable. A new model is developed to consider the phenomenological behaviour of water transport in and out of end-grain, using the pore water pressure and sorption scanning properties. Modelling results are compared to experimental results and the ...
L-O Nilsson, K Sandberg
The Effect of Soil pH on the pH of Treated Southern Pine in Ground Contact after 12 Months
2011 - IRG/WP 11-50281
Southern pine samples treated with soluble and particulate copper solutions were subjected to three soils that had been amended to provide acidic, neutral and alkaline conditions. Wood pH was measured prior to, and after 6 and 12 months after being placed in the soil to determine the effect of soil pH on wood pH....
L Jin, C Schauwecker, C Vidrine, P Walcheski, A Preston
Biological resistance of phenol-resin treated wood
1990 - IRG/WP 3602
Biological resistance of PF (phenol formaldehyde resin) - treated wood has been tested in relation to the resin properties, wood species and biological factors. When tested using water-soluble PF (mol. wt. 170), ca. 10% RI (resin impregnation) was enough to suppress the decay of Japanese cedar (Cryptomeria japonica) and western hemlock (Tsuga heterophylla) blocks exposed to Tyromyces palustris (br...
M Takahashi, Y Imamura
The use of ESR spectroscopy to assess the photostabilising effects of wood preservatives
2000 - IRG/WP 00-20186
The degradation of wood surfaces exposed to UV light which leads to poor performance of clear coatings is understood to be due to delignification via a mechanism involving free radicals. Certain wood preservatives most notably CCA are able to photostabilise wood and therefore they may reduce the concentration of free radicals formed when treated wood is exposed to ultraviolet light. As a first ste...
S Schmid, R D Webster, P D Evans
Treating Eucalyptus tereticornis wood with boron: Optimizing treatment conditions
2005 - IRG/WP 05-40309
Even though Eucalyptus tereticornis wood is suitable for small timber purposes, being non-durable, it needs to be treated with preservative chemicals. As it is a heavy, hard and difficult to treat species, the possibility of using diffusible boron compounds was investigated. The present study explored the effect of impregnation conditions such as treatment schedule, concentration of treatment solu...
T K Dhamodaran, R Gnanaharan
Wood Preservation India; Current Scenario
2013 - IRG/WP 13-40630
This short note describes the present status of wood preservation research and its industrial application. Although good performing formulations have been developed by Indian research laboratories, industry has not tried to derive benefits from this development. Many unknown products are flooding the market for brush on applications with little benefit as the products have not been standardized....
S Kumar
Programme. The 45th Annual Meeting of The International Research Group in Wood Protection
2014 - IRG/WP 14-60361
IRG Secretariat
Programme. The 46th Annual meeting of the International Research Group on Wood Protection (IRG46)
2015 - IRG/WP 15-60379
IRG Secretariat
An Open Letter to Proponents of CLT/Massive Timber
2016 - IRG/WP 16-40755
We present an Open Letter that discusses the need to address the potential for biodeterioration in CLT/Massive timber structure. We invite members to review and sign the document. We also welcome suggestions for potential recipients....
A Taylor, J Lloyd, T Shelton
Programme. The 47th Annual Meeting of The International Research Group in Wood Protection
2016 - IRG/WP 16-60398
IRG Secretariat
On the Influence of Wood Destroying Fungi on the Feeding Intensity of Termites
2017 - IRG/WP 17-10893
The baiting and feeding stimulating effect of wood attacked by fungal isolates of the species Coniophora, Lentinus, Poria and Gloeophyllum on termites Reticulitermes santonensis is examined. There are significant relationships between the activity of fungal isolates and the feeding behaviour of termites. The most active isolates can be used for increase the attractiveness of wood to wood-destroyin...
W Unger, T L Woods
Influence of a dipping preservative treatment on the performance of wood finished with waterborne coatings
1998 - IRG/WP 98-40121
Within a larger European research project on the performance of joinery finished with waterborne coatings, the influence of a water based dipping preservative treatment was studied in several ways. Six different waterborne coatings were tested with and without a preservative underneath the coating. The performance was tested on pine sapwood and spruce panels in a 2-year outdoor weathering trial on...
M De Meijer, J Creemers, W Cobben, P Ahola
Feasibility of microwave disinfestation of wood
1995 - IRG/WP 95-40051
Microwaves have proved to be an effective means to disinfest worm-eaten woods. The use of microwave electromagnetic energy to increase the woodworm temperature to a lethal level presents several advantages with respect to other conventional techniques, such as liquid pesticides and gas chambers. In particular, there is not contamination of the treated wood and of the environment: stray electromagn...
D Andreuccetti, M Bini, A Ignesti, A Gambetta, R Olmi