Your search resulted in 3055 documents. Displaying 25 entries per page.
Wood Preservation India; Current Scenario
2013 - IRG/WP 13-40630
This short note describes the present status of wood preservation research and its industrial application. Although good performing formulations have been developed by Indian research laboratories, industry has not tried to derive benefits from this development. Many unknown products are flooding the market for brush on applications with little benefit as the products have not been standardized....
S Kumar
Investigation of some technical properties of heat-treated wood
2003 - IRG/WP 03-40266
The objective of this study was to investigate some technical properties of heat-treated wood.
Wood heat-treated according to a process intended for wood in above-ground end-uses (European hazard class 3) was subject to the following:
· A delamination test according to EN 391 with glulam beams made of heat-treated pine (Pinus sylvestris) and spruce (Picea abies) laminations, assembled with PR...
C Bengtsson, J Jermer, A Clang, B Ek-Olausson
Exterior wood stains
1980 - IRG/WP 3135
Experience has shown that conventional paints cannot now be relied upon to provide a complete seal against water entry, that in practice water can often circumvent the film and that the paint, far from serving to keep water out will seal it in. Moreover present-day paints are often subject to localised and premature failure out of doors and consequently entail high maintenance costs. Problems of w...
E R Miller
Vapour boron treatment of wood based panels: Further studies on mechanical properties
1993 - IRG/WP 93-30028
Samples of medium density fibreboard, chipboard and oriented strandboard were treated to two retentions of boric acid by vapour phase methods. The results of short term mechanical tests on this material were discussed by Hashim et al. (1992). The present paper discusses results with long term studies on bending and impact resistance with panel types. Long term tests of impact resistance showed no ...
R Hashim, R J Murphy, D J Dickinson, J Dinwoodie
How to keep coated wood structures sufficiently dry to avoid damage caused by rot
1991 - IRG/WP 2376
During the last ten years, a new type of problems with wood rot has emerged in Scandinavia. Thousands of houses have been damaged by wood rot attaching to the exterior wood panel. This paper provides an overview of finished and ongoing work in order to identify the cause of these problems. In field tests, the moisture conditions were measured in panels coated with different paint systems. The infl...
S Hjort
Programme. The 45th Annual Meeting of The International Research Group in Wood Protection
2014 - IRG/WP 14-60361
IRG Secretariat
Programme. The 46th Annual meeting of the International Research Group on Wood Protection (IRG46)
2015 - IRG/WP 15-60379
IRG Secretariat
An Open Letter to Proponents of CLT/Massive Timber
2016 - IRG/WP 16-40755
We present an Open Letter that discusses the need to address the potential for biodeterioration in CLT/Massive timber structure. We invite members to review and sign the document. We also welcome suggestions for potential recipients....
A Taylor, J Lloyd, T Shelton
Programme. The 47th Annual Meeting of The International Research Group in Wood Protection
2016 - IRG/WP 16-60398
IRG Secretariat
Fungal resistance of smoke-dried Cryptomeria japonica wood
1998 - IRG/WP 98-40118
Performance of smoke dried wood on fungal resistance was studied. The maximum temperature of the smoke seasoning was 80-90°C in the drying room and 70-80°C within the wood for 6 days during the treatment for 15 days. Decay resistance of smoke-dried Cryptomeria japonica wood was evaluated using a brown rot fungus, Tyromyces palustris. Weight losses of untreated wood, smoke-dried wood, and smoke-d...
K Yamamoto, I Momohara, T Nishimura
Biological resistance of phenol-resin treated wood
1990 - IRG/WP 3602
Biological resistance of PF (phenol formaldehyde resin) - treated wood has been tested in relation to the resin properties, wood species and biological factors. When tested using water-soluble PF (mol. wt. 170), ca. 10% RI (resin impregnation) was enough to suppress the decay of Japanese cedar (Cryptomeria japonica) and western hemlock (Tsuga heterophylla) blocks exposed to Tyromyces palustris (br...
M Takahashi, Y Imamura
The use of ESR spectroscopy to assess the photostabilising effects of wood preservatives
2000 - IRG/WP 00-20186
The degradation of wood surfaces exposed to UV light which leads to poor performance of clear coatings is understood to be due to delignification via a mechanism involving free radicals. Certain wood preservatives most notably CCA are able to photostabilise wood and therefore they may reduce the concentration of free radicals formed when treated wood is exposed to ultraviolet light. As a first ste...
S Schmid, R D Webster, P D Evans
Treating Eucalyptus tereticornis wood with boron: Optimizing treatment conditions
2005 - IRG/WP 05-40309
Even though Eucalyptus tereticornis wood is suitable for small timber purposes, being non-durable, it needs to be treated with preservative chemicals. As it is a heavy, hard and difficult to treat species, the possibility of using diffusible boron compounds was investigated. The present study explored the effect of impregnation conditions such as treatment schedule, concentration of treatment solu...
T K Dhamodaran, R Gnanaharan
On the Influence of Wood Destroying Fungi on the Feeding Intensity of Termites
2017 - IRG/WP 17-10893
The baiting and feeding stimulating effect of wood attacked by fungal isolates of the species Coniophora, Lentinus, Poria and Gloeophyllum on termites Reticulitermes santonensis is examined. There are significant relationships between the activity of fungal isolates and the feeding behaviour of termites. The most active isolates can be used for increase the attractiveness of wood to wood-destroyin...
W Unger, T L Woods
Encapsulated Active Ingredients for Wood Preservation
2017 - IRG/WP 17-30717
Encapsulated organic fungicides and termiticides have been examined for use as wood preservatives in vacuum pressure treatment of wood. Encapsulation of active ingredients was found to improve wood penetration behaviour and reduces leaching as well as biodegradation of the active ingredients compared to industrial standard formulations....
E Oenem-Siakou, R Möller, R Craciun, J Wittenzellner, J Habicht
Influence of a dipping preservative treatment on the performance of wood finished with waterborne coatings
1998 - IRG/WP 98-40121
Within a larger European research project on the performance of joinery finished with waterborne coatings, the influence of a water based dipping preservative treatment was studied in several ways. Six different waterborne coatings were tested with and without a preservative underneath the coating. The performance was tested on pine sapwood and spruce panels in a 2-year outdoor weathering trial on...
M De Meijer, J Creemers, W Cobben, P Ahola
Feasibility of microwave disinfestation of wood
1995 - IRG/WP 95-40051
Microwaves have proved to be an effective means to disinfest worm-eaten woods. The use of microwave electromagnetic energy to increase the woodworm temperature to a lethal level presents several advantages with respect to other conventional techniques, such as liquid pesticides and gas chambers. In particular, there is not contamination of the treated wood and of the environment: stray electromagn...
D Andreuccetti, M Bini, A Ignesti, A Gambetta, R Olmi
Ultrastructural aspects of bacterial attacks on an archaeological wood
1993 - IRG/WP 93-10007
Transmission electron microscopy of wood from a Chinese ship submerged in the mud for over 900 years showed bacteria to be the main factor for its deterioration. The micromorphology of degraded wood cell walls was similar to that observed during the attacks of wood by erosion bacteria. Other bacterial forms, previously considered lo be scavenging bacteria, were also abundant in degraded areas of t...
Yoon Soo Kim, A P Singh
Testing a diffusion and reaction model for the leaching of CCA components from unfixed CCA-treated wood
2002 - IRG/WP 02-50193
A previously described physical model applicable to the leaching of any substance undergoing a first-order fixation reaction with wood is applied to the leaching of CCA components from unfixed wood. Using this model and laboratory leaching experiments with small wood samples immersed in water, the diffusion coefficients and reaction rate constant of Cr6+, total Cr, Cu and As in unfixed CCA-treated...
L Waldron, P A Cooper
Radio frequency heating times for sterilization radiata pine solid piles
2017 - IRG/WP 17-40815
In this work was sterilized wood packaging material of radiata pine, stacked as solid piles without stickers, for determining the heating times using radiofrequency treatment. The experiments were performed in a radio frequency semi-industrial equipment. The results showed that the radio frequency heating times increases with wood volume and that radio frequency treatments were faster than convent...
H Esquivel, V Sepúlveda, J Torres, L Salvo, R A Ananías
The IRG48 Scientific Conference on Wood Protection - Poster abstracts
2017 - IRG/WP 17-60414
IRG Secretariat
Programme. IRG48 Scientific Conference on Wood Protection, 4-8 June 2017
2017 - IRG/WP 17-60415
IRG Secretariat
Feasibility of AE (Acoustic Emission) monitoring for the detection of the activities of wood-destroying insects
1992 - IRG/WP 92-2416
The feasibility of acoustic emission (AE) as a nondestructive testing method for the detection of the wood destroying insects was investigated. AEs were detected from the wood specimens under feeding attack of sugi bark borers or powder-post beetles. However, the feasible monitoring area of an AE sensor is influenced by the attenuation of AE amplitude, so that this could be a problem in the practi...
Y Fujii, Y Imamura, E Shibata, M Noguchi
Aspergillus fumigatus Fresenius resistance to chemical preservatives in piles of pine and birch wood chips
1981 - IRG/WP 1146
Investigation has been carried out on the communities of fungi developing in birch and Scots Pine chip piles in the Ostroleka Pulp and Paper Mill in the North-East of Poland The species composition or fungal communities and their development in a dozen of chip piles during storage was investigated. Untreated and chemically treated birch and pine wood chips were investigated. In all samples the gre...
M H Zielinski
Leachability of borate-modified oriented strandboard: A comparison of zinc and calcium borate
2002 - IRG/WP 02-40232
The leachability of boron in zinc and calcium borate-modified oriented strandboard (OSB) was investigated in this study. The leaching experiments were conducted by exposing edge-sealed OSB samples under running water for 8, 24, 72, and 216 hours. The results were compared with those from the unleached controls. Boron leaching of the modified OSB occurred upon the initial water exposure, and the le...
S Lee, Q Wu