Your search resulted in 3077 documents. Displaying 25 entries per page.
Some textile auxiliaries as wood protective agents
2007 - IRG/WP 07-30417
This study evaluated some textile auxiliaries applicable for wood protection. Commercial alkoxysilane quarternary ammonium formulation and fluorocarbon based water-oil repellent were tested for their ability to provide hydrophobicity and antifungal effect to solid wood samples. Scots pine (Pinus sylvestris L.) sapwood samples were impregnated with 25, 50 and 100 % concentrations of the above menti...
E Dizman, A Temiz, N Terziev, Ü C Yildiz
Silver – The Next Generation Wood Preservative
2007 - IRG/WP 07-30419
The successful introduction and commercial use of products designed to have controlled release of silver ion over long time periods prompted the Silver Research Consortium and the US Forest Products Laboratory to undertake research to see if silver could also be an effective wood preservative to be used in place of chromated copper arsenate (CCA) now prohibited for use in the United States and els...
J R Ellis, K Jayachandran, D Nicholas
Silver as a Wood Preservative Environmental Requirements and Concerns
2007 - IRG/WP 07-30420
The pesticide uses of silver and its compounds fall under the jurisdiction of the United States Environmental Protection Agency (USEPA) under the US Federal Insecticide Fungicide and Rodenticide Act. In addition, many other national and international organizations maintain close observance of the effects of silver in different environments. The US EPA has also issued a specific announcement that t...
J R Ellis
Microwave curing of furfuryl alcohol modified wood
2007 - IRG/WP 07-40371
Furfurylated wood has shown to have promising properties for a wood modification agent during the last years. In this paper, an alternative curing method for furfuryl alcohol modified pine sapwood by means of microwave radiation was investigated.
Different process parameters of microwave treatment such as output power, exposure time to microwave radiation, initial wood moisture content and evapor...
A Treu, E Larnøy, H Militz
Study of natural durability of Spanish Eucalyptus globulus wood
2007 - IRG/WP 07-10617
In some countries such as Australia, the wood of Eucalyptus globulus is recommended, due to its high durability, in risk situations where attack by organisms is likely to occur. In Galicia this species has been used for many decades for timber structures, which are still used. However, European Standard EN-350-2 places Eucalyptus globulus in the worst category of natural durability, a situation th...
D Lorenzo, M T Troya, M J Prieto, C Baso, M Touza
Chelator-Mediated Fenton Chemistry in Wood Degraded by Fungi
2007 - IRG/WP 07-10618
Wood specimens were colonized by individual isolates of brown rot, white rot, soft rot and blue (sap) stain fungi. Ethyl acetate extracts of the ground wood were analyzed for their iron-reducing capabilities using a ferrozine-based assay. Extracts from wood colonized by brown rot fungi showed a significantly greater iron-reducing capability than extracts from wood colonized by white rot fungi or n...
B Goodell, G Daniel, J Jellison, Yuhui Qian
Electrokinetic Accelerated Ingress of Boron After Surface Treatment of Wood
2007 - IRG/WP 07-40372
In this work electrokinetic acceleration of boron penetration after surface treatment is proposed in order to offer an alternative to the often low penetration rates based on diffusion. Electrodialytic experiments showed that boric acid could be transported as negatively charged complexes with tartaric acid in aqueous solutions at pH 4-5. Boric acid could not be transported when tartaric acid was ...
I V Christensen
The Current Situation Of Wood Poles Installed In Ilha Do Mel: A Wood Pole Biodegradation Diagnostic
2007 - IRG/WP 07-40373
Wood CCA and CCB poles installed in Ilha do Mel, an island of Parana State, Brazil, are failed earlier than expected: just five years after being installed many poles need to be replaced with financial implications for the State Energy Company – COPEL.
In an effort to answer what causes this failure, this work shows the deterioration diagnostic of Ilha do Mel’s poles. In fact, such poles have...
C C Borges, J C Moreschi
Marine Borer Resistance of Modified Wood - Results from Seven Years in Field
2007 - IRG/WP 07-40375
Wood modified by several methods has been tested for seven years in a marine field with high marine borer activity. Several wood modification methods were included, e.g. thermal modification (with different processes), acetylation, maleoylation, succinylation, furfurylation, treatment with methylated melamine resin and modification with reactive linseed oil derivative. Furthermore, some combinatio...
M Westin, A O Rapp, T Nilsson
Wood furfurylation process development. Part 1: Oscillating Pressure Method
2007 - IRG/WP 07-40376
Furfurylated wood (wood modified by furfuryl alcohol) has over the last years gained marked shares from both tropical wood and conventional preservative treated wood and this has, in turn, generated several research projects concerning process development. The impregnation of spruce is well known from literature to be a difficult task. Furthermore, the sapwood of Scandinavian-grown Scots pine is a...
E Larnøy, M Westin, B Källander, S Lande
Wood furfurylation process development. Part 2: Lowry impregnation trials
2007 - IRG/WP 07-40377
The objective was to evaluate whether Lowry-impregnation of Scots pine with FA100-mix, instead of the FA40-mix, would lead to similar or slightly higher WPGs and to investigate any potential changes in penetration pattern. The results indicate that the penetration was better, also penetrating the outer zone of the heartwood. Furthermore, it was possible to reduce the WPG-levels for pine down to 50...
M Westin, E Larnøy, S Lande
Protection of wood for above ground application through modification with a fatty acid modified N-methylol/paraffin formulation
2007 - IRG/WP 07-40378
Hydrophobic chemical modification can be regarded as an alternative approach to conventional wood preservation using biocides in order to protect wood in hazard class 3 according the European Standard EN 335-1.
A formulation containing fatty acid modified N-methylol/paraffin and an aluminium salt catalyst was used to change the material properties of wood in order to protect wood from fungal dec...
Nguyen Hong Minh, H Militz, C Mai
Micro- and hydro-sandblasting for wood and wood coatings
2007 - IRG/WP 07-40380
Exterior wood coatings are getting increasingly durable and often more film forming. As a result they become difficult to renovate. Conventional renovation techniques (chemical or thermal stripping, sanding) are demanding techniques which take a long time to implement. Therefore renovation techniques are requested which are easier to use and which ensure that the wood surface is suitable for a re-...
L Podgorski, V Georges, P Svane
Furfurylated wood – withdrawal load for fasteners
2007 - IRG/WP 07-40381
The withdrawal load for hot dip galvanized nails and chromated decking screws in furfurylated Baltic redwood (Pinus sylvestris) with a Weight Percent Gain (WPG) of approximately 40 % was measured according to DIN 1052.
The average withdrawal loads were 60-100 % higher for the nails and approximately 20 % higher for the screws in the furfurylated wood compared to untreated wood.
The results ind...
J Jermer, A Clang
Use of Moisture Meters with Treated Wood
2007 - IRG/WP 07-40382
Drying wood treated with waterborne preservatives after treatment to near outdoor EMC conditions improves its physical performance characteristics. This is primarily due to the reduced checking, splitting and warping which can occur when wet wood, particularly if restrained from shrinking by being nailed or otherwise fastened, shrinks in use. Monitoring of the drying process, rate, and end point...
W B Smith, Hwan Myeong Yeo, C Stark, B Morey, C Tascioglu, P Schneider, D Herdman, M Freeman
Reduction of Environmental Toxicity Through Eco-friendly Wood Biopreservative
2007 - IRG/WP 07-50243
Many chemicals are used today to enhance the durability of wood and wood-derived products that are very important in our life. Such chemicals are copper, chromium, arsenate, zinc, etc. Though these preservatives are useful to protect wood from biodeterioration, but environmental toxicity is also related with them. The present study is to investigate the fungitoxic activities of Dalbergia sissoo le...
A Humayan Kabir, M Firoz Alam
Wood Protection by Commercial Silver Formulations against Eastern Subterranean Termites
2007 - IRG/WP 07-30422
The scope of this paper is to compare commercial formulations of aqueous products containing silver for their ability to prevent termite damage by Eastern subterranean termites in a no-choice laboratory test. Five commercial products were tested in order to explore a broad range of formulation and silver forms: colloidal, ionic and nano-particles. Southern pine wood blocks were dip treated in each...
F Green III, R A Arango
Influence of ethanolamine on lignin depolymerization and copper leaching from treated Norway spruce and beech wood
2007 - IRG/WP 07-30423
Copper-ethanolamine based wood preservatives are replacing several classical copper-chromium based solutions, due to foreseen ban of chromium. Fixation of copper-ethanolamine based wood preservatives is not as good as fixation of copper-chromium ones. The main object of this manuscript was to prove, that ethanolamine is the prime reason for insufficient fixation of copper-ethanolamine formulations...
M Humar, B Bucar, M Zupancic, D Žlindra, F Pohleven
Theory of Aesthetics – Charm in Furniture and an Aesthetic Evaluation of Bleaching of the Natural Color of Wood through the Application of Experimental Bleaching Process
2007 - IRG/WP 07-30424
This paper consists of mainly three sections: In the first section, brief information is given on the theory of aesthetics as a branch of philosophy, historical progress of the aesthetics theory is summarized within the context of the term “beautiful”, and aesthetic values as well as the color and aesthetic effects of color in preparing the designs are explained. In the second section, relatio...
I Usta
Amine Oxides for Use in Wood Protection: I. A Formulation Adjuvant and Performance Enhancer for Wood
2007 - IRG/WP 07-30425
Amine oxides have great potential for use in the area of wood protection. This paper highlights the advantages of using amine oxides as a formulation adjuvant and performance enhancer for different azoles. It was found that azoles are readily soluble in aqueous amine oxide solutions and form soluble concentrates. These azole/amine oxide concentrates have excellent storage stability and can be dilu...
Xiao Jiang, L Walker
Amine Oxides for Use in Wood Protection: II: Water Repellent Agents for Wood
2007 - IRG/WP 07-30426
Wood treated with cetyl and stearyl amine oxides was evaluated to determine its long term water repellency. Comparative water uptake data, generated during two years of outdoor exposure, illustrated that Lonza’s products, Barlox® 18S (N-octadecyl-N, N-dimethylamine oxide) and Barlox® 16S (N-hexadecyl-N, N-dimethylamine oxide), were effective water repellent agents, imparting lasting water res...
Xiao Jiang, L Walker
Effects of caffeine on growth of wood-decaying fungi
2007 - IRG/WP 07-30427
The wide-used triazoles alter the biosynthesis of ergosterol leading to a disruption of fungal membrane functions. The aim of this study was to investigate the effects of another cell wall perturbing agent, caffeine, in combination with propiconazole on the growth of wood-decaying fungi. 10 mM caffeine inhibits totally the growth of five fungal species. The obtained results showed that caffeine ha...
S Lekounougou, J P Ondo, J P Jacquot, G Nevers, P Gérardin, E Gelhaye
Effects of chlorothalonil (CTN) and butylated hydroxytoluene (BHT) on microbial communities involved in the deterioration of wood using T-RFLP II: Results from field studies
2007 - IRG/WP 07-30429
The effects of Chlorothalonil (CTN) and Butylated Hydroxytoluene (BHT) on microbial species diversity in wood and the surrounding soil are being assessed by Terminal Restriction Fragment Length Polymorphism (T-RFLP). CTN was selected as a trial organic wood preservative, and the non-biocidal BHT was evaluated for its synergistic effects with CTN. ACQ-C was a positive control and untreated SYP sta...
G T Kirker, M L Prewitt, S V Diehl
Laboratory test of blue stain control by chemicals
2007 - IRG/WP 07-30430
8 chemicals and some mixtures against Botryodiplodia theobromae Pat., Fusarium verticillioides(Sacc.)Nirenberg, Trichoderma harzianum Rifai, Trichoderma viride Pers., and Penicillium purpurogenum Stoll were conducted in laboratory by inhibition zone in the paper. The results were shown that: CBZ and benomyl as well as copper oxine alone are much high efficacy for inhibiting most of the 5 fungi tha...
Zhijuan Wang, Zehui Jiang, Mingliang Jiang, Chungen Piao
The effect of wood moisture content and rod dosage on movement of boron through Douglas-fir heartwood
2007 - IRG/WP 07-30431
The potential for moisture sorption by boron rods following application to wood to affect subsequent boron diffusion was investigated in small Douglas-fir blocks conditioned to 30, 60 or 90% moisture content (MC). MCs tended to decline over the 180 day test period, but there was no evidence that the rods acted to draw moisture away from the wood. As expected, boron movement tended to increase with...
Y Cabrera, J J Morrell