Your search resulted in 978 documents. Displaying 25 entries per page.
Quantifying the effect of microclimatic parameters on the moisture-induced decay risk of wooden structures
2019 - IRG/WP 19-20649
Wood exposed outdoors is prone to fungal degradation. Besides its material-inherent resistance, numerous factors are impacting on its service life with both, climate and design having a major effect. In addition, topography, shading, wind barriers, and other local parameters have an effect on the microclimatic conditions at site and therefore need to be quantified for service life prediction of wo...
L Emmerich, C Brischke
Improvement of analytical methods of wood preservatives and its validation with collaborative testing
2019 - IRG/WP 19-20655
This discussion paper presents on-going collaborative test of analytical methods of wood preservatives according to the standardization process of Japan Agricultural Standard (JAS) by the Ministry of Agriculture, Forestry and Fisheries (MAFF). Food and Agricultural Materials Inspection Center (FAMIC) in close cooperated organization with the MAFF, has wide range of tasks about inspections and anal...
T Miyauchi, K Yamamoto, N Shota, Y Akabori, M Ikeda, J Eisawa, K Kambara, T Osawa, C Igarashi, Y Baba, W Ohmura, M Shimizu, M Samejima
Accumulation of copper in parenchyma cells in southern pine wood treated with micronized and amine-copper preservatives
2019 - IRG/WP 19-20657
Our previous research used X-ray micro-computed tomography to examine the micro-distribution of copper in southern pine wood treated with a micronized wood preservative (MCA) and an amine-copper preservative (ACQ). We found that copper in wood treated with MCA was mainly concentrated in fusiform rays (rays containing resin canals), and in vertical (axial) resin canals. A similar, although not iden...
D Feng, M L Turner, A Limaye, M A Knackstedt, P D Evans
Impact of water holding capacity and moisture content of soil substrates on the moisture content of wood in terrestrial microcosms
2019 - IRG/WP 19-20662
Terrestrial microcosms (TMC) are frequently used for testing the durability of wood and wood-based materials as well as the protective effectiveness of wood preservatives. In contrary to experiments in soil ecology sciences, the experimental set-up is usually rather simple. However, for service life prediction of wood exposed in ground, it is of immanent interest to better understand the different...
C Brischke, F L Wegener
COPPER NAPHTHENATE: A Product for All Seasons: Protecting the Americas’ Infrastructure for Over 100 Years and Potential for Expanded Usage in Europe
2019 - IRG/WP 19-30738
This paper is a brief review of the history and use of the wood preservative Copper Naphthenate, with a focus on use patterns within the USA and opportunities for expansion in Europe and Canada. This paper reviews how copper naphthenate has performed to preserve and protect cellulosic and wooden items essential to critical infrastructure, and why it is the ideal choice for use in the replacement o...
M H Freeman, J A Brient, M Manning
Relative efficacy of various oxine copper formulations against brown-rot fungi
2019 - IRG/WP 19-30741
This paper investigates the relative resistance of three different oxine copper formulations (oil-borne, water-borne, water-borne with pH-adjustment) as a preservative treatment for wood against brown-rot fungi. Impregnated southern pine sapwood cubes were exposed to R. placenta and G. trabeum cultures in a soil-block test. After eight weeks, the weight losses of the cubes were examined in relatio...
M Petruch, J Lloyd, A Taylor
Performance of field cut preservatives above-ground and in ground contact exposures
2019 - IRG/WP 19-30742
Field cut preservatives are needed to protect cut ends and drill holes that expose the untreated interior of preserved wood. A series of field cut preservatives were assessed in ground contact and above-ground exposures. After 10 years in ground contact exposure, all of the untreated controls had failed or exhibited very advanced decay. In contrast, the copper naphthenate (2% Cu in mineral spirits...
R Stirling, D Wong
Antifouling wood matrix with natural water transfer and micro reaction channels for water treatment
2019 - IRG/WP 19-40853
Wood with abundant nutrition transport channels could be considered as a kind of natural water purifier due to quick and effective passages for separation. Nevertheless, microporosity as main porous structure of initial wood are not enough to effectively separate small molecular, such as organic dye pollutants. Meanwhile, like most filters the fouling resulting in blocking and poor water flux will...
G Liu, D Xu, S Chang, J Hu, Xianjun Li5, Y Liu
Wood veneer with high flexible decorated with nanoparticles for highly efficient water treatment
2019 - IRG/WP 19-50347
Natural wood is mainly comprised of numerous long, partially aligned channels (lumens) as well as nanochannels. Wood with these quick and effective passages is suitable for a membrane/separation material. However, a suitable thickness range of wood along its growth direction is essential to effectively separate small molecular, and the wood membrane is too thick to clean easily. In this paper, woo...
S Chang, D Xu, G Liu, J Hu, X Li, Y Liu
Effect of long-term immersion in fresh and salt water on mould growth on Scots pine (Pinus Sylvestris L.) wood
2020 - IRG/WP 20-10962
Wood exposed outdoors will eventually be degraded by fungi, depending on exposure and material characteristics. Numerous wooden constructions in the Røros municipality have existed since the 17th century, but wood used in recent repairs have decayed faster than expected. Before 1970 timber was mainly transported by log driving or rafting, and the logs were immersed in water for longer or shorter ...
M Sand Austigard, J Mattsson
Monitoring of wood preservatives exposed to weathering: Extraction and analysis methods of organic biocides from treated wood and collected rain runoff
2020 - IRG/WP 20-30753
Weathering is the cause of numerous damages for outdoor joineries. Protection of wood using a preservative treatment covered with a coating is a process widely used to limit these damages. However, biocides from preservative treated wood are prone to degradation and leaching, having a direct influence on the joinery service life. This document deals with extraction and analytical methods for bioci...
O Ouali, K Le Ménach, E Raphalen, L Podgorski, S Legay, H Budzinski
Water interactions in wood polyesterified with sorbitol and citric acid
2020 - IRG/WP 20-40888
Polyesterifcation of wood with sorbitol and citric acid seems to be a promising chemical wood modification technique that is both low-cost and produced from bio-based chemicals. An interesting aspect of the modification is the interaction of water with the polyesterified wood since the relationship with moisture appears to be unique compared to other wood modification systems. This communication p...
G Beck, A Treu, E Larnøy
Studying amount, location and state of water in modified wood at moisture levels relevant for fungal degradation
2020 - IRG/WP 20-40889
Water is an essential parameter for fungal degradation of wood, but degradation primarily occurs at high moisture levels at water potential in the range of -4 to -0.1 MPa, which corresponds to 97-99.9% relative humidity. At these moisture levels, water is present in the wood structure both in and outside of cell walls. The majority of previous studies on the interaction between wood and water for ...
M Fredriksson, E Engelund Thybring, Ramunas Digaitis
Performance of a water-borne stain on beech, spruce, MDF and OSB improved by plasma pre-treatment
2020 - IRG/WP 20-40897
Coatings are an important part of wood protection, especially for outdoor applications. In order to provide a good protection, protective coatings need to exhibit good adhesion, mechanical resistance, and weathering resistance. Plasma pre-treatments are an established method to increase the performance of existing coatings including those on wood and wood-based substrates. Moreover, plasma deposit...
S Dahle, J Žigon, I Uranjek, M Petrič
Comprehensive protection of timber in seawater
2020 - IRG/WP 20-10970
The hazard of wood in seawater can be divided into two areas: Below the water level, shipworm (Teredo navalis) and gribble (Limnoria lignorum) can attack non-resistant or insufficiently protected wood; above the water level, there is a risk by wood-destroying fungi and, to a lesser extent, insects. In a national project funded by the Deutsche Bundesstiftung Umwelt (DBU, German Federal Environmenta...
E Melcher, J Müller, T Huckfeldt
Potenzy of Azadirachta indica heart wood extracts as wood bio-preservative against termite attack
2020 - IRG/WP 20-10972
Extractives in wood are one of the main reasons for wood resistance against bio-degradation. The chemical compositions of extractives from matured Azadirachta indica that are known to be very resistant against bio-degradation were studied to assess their role as wood preservative. Ethanol and toluene were used in the extraction of these compounds from the heartwood of Azadirahcta indica. Chemical ...
L O Aguda, O B Olajide, O Y Aguda
Monitoring uptake and penetration of pesticides during impregnation of pine (Pinus sylvestris) and spruce (Picea abies) wood with bio-based microemulsion gel formulations
2020 - IRG/WP 20-30756
Even in dry state wood is susceptible to biological degradation. Preservation against biological decay in exposed conditions is conventionally achieved by impregnating the wood with pesticides applied at professional and industrial levels. Impregnation of wood with preservatives is a complex process that involves wood macro- and microstructure, and the physical characteristics of woods. Here we fo...
D Messaoudi, K Ruel, J-P Joseleau
Silicate coatings for wood substrates
2020 - IRG/WP 20-40906
Silicate coatings are surface finishing products containing alkali metal silicates or ethyl silicates as main binders. They are traditionally designed and well established for mineral substrates or corrosion protection of steel. The interest for these coatings in wood field is growing because of the benefits they could provide such as high durability, weathering resistance and fireproofing and sus...
A M Cheumani Yona, M Pavlič, M Petrič
Surface morphology and short-term water uptake of charred and coated wood
2021 - IRG/WP 21-40916
Charring of the wood surface represents a traditional alternative surface treatment technique with the purpose of aesthetics and protection. By the treatment with flame the surface of wood becomes carbonized and a few millimetres thick charred layer is formed on the top of the wooden element. Further, the charred layer can be removed by brushing, which accentuates the structure of the surface. Add...
J Zigon
Studies on the material resistance and moisture dynamics of Douglas fir and Sitka spruce from Slovenia
2021 - IRG/WP 21-20677
Wood in outdoor applications is subject to various decomposition factors. Wood degradation can be prevented by construction details, biocide protection of wood, wood modification, or selection of naturally durable wood species. Unfortunately, the majority of timber species in Europe do not have naturally durable wood. Imported tree species represent a new pool from which we can draw wood species w...
M Humar, B Lesar, D Krzisnik, E Kerzic, R Brus
Effect of a Water Repellent Treatment on Moisture Behavior of Three Australian Hardwoods: A Preliminary Report
2021 - IRG/WP 21-40921
Wood is inherently hygroscopic and will sorb moisture either directly from the atmosphere or via capillary action. Moisture can have marked effects on wood properties and repeated wetting and drying creates dimensional changes that lead to physical damage. Exposure to elevated moisture levels also increases the risk of fungal attack.
Wood preservatives have long been used to minimize the risk of ...
B Hassan, J J Morrell, K Wood
Evaluation of weathering and termite resistance of the Myoung-oil as a Korean traditional coating agent
2022 - IRG/WP 22-10996
This study investigated the applicability of Myoung-oil (MO) as an eco-friendly preservative of Korean wooden cultural properties and buildings. Wood test specimens painted with various concentrations of MO were exposed in the external environment. Then color change and wettability of the wood surface were evaluated and compared depending on the exposure time. As a result of exposure for 12 months...
S-M Yoon, Y Park, W-S Jeon, H-M Lee, J-G Park, K Dal Nam, W-J Hwang
Efficiency of three resin fractions from Aucoumea Klaineana Pierre, Canarium schweinfurthii Engl and Dacryodes edulis (G. Don) H. J. Lam from Gabon combined with Tebuconazole as wood preservatives
2022 - IRG/WP 22-10998
Pure resins from Aucoumea Klaineana, Canarium schweinfurthii and Dacryodes edulis were harvested and then hydro-distilled to obtain essential oils and purified resins fractions. Due to the potential leaching and volatility hazards of the compounds that constitute these fractions, resins and essential oils were combined with tebuconazole to produce both antifungal and anti-termite wood preservative...
W F Bedounguindzi, K Candelier, P Edou Engonga, S Dumarcay, M-F Thevenon, P Gerardin
Evaluation of ecotoxicological effects of different coniferous wood treatments on two marine bioindicator species
2022 - IRG/WP 22-10999
Coniferous wood panels (Picea abies) were treated with two concentrations of copper-based impregnating agent to increase its durability in marine and brackish environment. In order to assess the environmental compatibility of the treatments a laboratory experiment was conducted with two marine invertebrate species: bivalve Mytilus galloprovincialis and a gastropod Steromphala albida. The bioindica...
T Marčeta, N Nesto, I Guarneri, D Tagliapietra, V Moschino
Evaluation of Decay Resistance of Copper-based Preservatives Treated-Wood exposed to different field test sites in Korea
2022 - IRG/WP 22-20679
In Korea, preservative treated wood is required to have a stamp on the surface which contains information such as wood species, use categories, and the company that treated the wood. Such stamping is necessary to safely and appropriately use the treated wood. Since majority of treated wood is being used outdoor environment, the treated wood must have efficacy against wood decay fungi or termite. I...
W-J Hwang, S-M Yoon, Y Park, Y-S Choi, H-M Lee, J-W Kim