Your search resulted in 264 documents. Displaying 25 entries per page.
Studying fungal growth using automated image analysis and computer simulations
2016 - IRG/WP 16-20590
Wooden materials are prone to fungal attack resulting in damage and economic losses. Therefore many efforts have been made to understand the degradation of wood and to avoid the adverse effect of fungi. Even though the extent of degradation of a material is inversely proportional to the extension of the fungi attacking it, most researchers focus mainly on the former, leaving the study of the latte...
G Vidal-Diez de Ulzurrun, J M Baetens, J Van den Bulcke, B De Baets
Preparation of Calibration Standards for the Analysis of Pentachlorophenol in Treated Wood by X-ray Fluorescence
2016 - IRG/WP 16-20591
The primary purpose of this project was to develop a method for preparing calibration standards that can be used by the wood treating industry to calibrate X-ray fluorescence instrumentation. Calibration standards of penta/P9-oil in southern yellow pine that cover the retention range of 0.2 to 0.9 pcf (0.6 to 1.9 %) were successfully prepared. A detailed procedure for mixing penta in treating sol...
L L Ingram Jr, H M Barnes, R Shmulsky, D Jeremic
How intraspecific radial variability of the European Oak’s may influence mild pyrolysis process and durability of the material
2016 - IRG/WP 16-40725
Last decades wood is promoted as building material. Unprotected wood exposed to outdoor conditions undergoes a variety of degradation induced essentially by fungi attacks. Heat treatment of wood by mild pyrolysis (180°C T 240°C under inert atmosphere) is a preservation process with a weak environmental impact, and therefore, is viewed as an interesting alternative to the chemical impregnation me...
J Hamada, A Pétrissans, F Mothe, M Pétrissans, P Gérardin
Combustion and thermal characteristics of Korean wood species
2016 - IRG/WP 16-40727
This study examined the combustion and thermal characteristics of domestic woods in Korea. Wood was confirmed by a cone calorimeter according to the KS F ISO 5660-1 standard. The combustion properties of the wood were measured in terms of the heat release rate (HRR), total heat released (THR), mass lose rate (MLR), and ignition time (time to ignition; TTI). Also, the thermal properties were measur...
Huyun Jeong Seo, Jung-eun Park, Dong Won Son, Won-Joung Hwang
Dynamic mechanical analysis of viscoelastic properties of heat treated glycerol-impregnation poplar wood
2016 - IRG/WP 16-40732
The viscoelastic properties of glycerol-impregnated poplar wood after heat treatments at various temperatures were examined by dynamic-mechanical analysis. The spectra of storage modulus (E’) and loss tangent (tgδ) in the frequency at 10 Hz were measured at the temperature range from -100 to 300℃. Compared to no peak in E’ spectra and two relaxation processes in tanδ spectra of...
Li Yan
Bacterial Degradation of Pentachlorophenol Indicated in Groundwater Undergoing Long Term In-Situ Remediation
2016 - IRG/WP 16-50318
Pentachlorophenol (PCP, Penta) is a worldwide soil and water contaminant. The pervasive use of PCP as a fungicide, herbicide, pesticide, and as preservative for wood products has led to its global distribution. It is a highly effective preventative measure for most invasive insects, bacteria, fungi, and molds, as well as an excellent wood protection treatment. This study examined a known PCP conta...
C E Stokes, H Borazjani, L Prewitt
Analysis of hindgut bacterial phyla frequency and diversity in subterranean termites exposed to chitosan-treated wood
2017 - IRG/WP 17-10882
The termite hindgut contains a microbial community that symbiotically aids in digestion of lignocellulosic materials. For better understanding of the dynamics of the bacteria-termite relationship, a species survey of bacterial hindgut microbes in subterranean termites (Reticulitermes flavipes: Kollar) collected from Louisville, Mississippi was performed after exposure to chitosan-treated and contr...
O Raji, J D Tang, T Telmadarrehei, D Jeremic
Nondestructive analysis of oviposition of the bamboo powderpost beetle Dinoderus minutus using acoustic emission and X-ray CT
2017 - IRG/WP 17-10889
The bamboo powderpost beetle Dinoderus minutus is a major pest of dry bamboo culms in Japan. In this study, acoustic emission (AE) and X-ray computed tomography (CT) was applied to the nondestructive analysis of the ovipositional behavior of adult D. minutus beetles inside bamboo pieces. Newly mated adult females were individually exposed to oviposition bamboo pieces prepared from culms of Phyllos...
H Watanabe, Y Yanase, Y Fujii
Genetic characterisation of the deathwatch beetle – Call for support
2017 - IRG/WP 17-10890
The deathwatch beetle (Xestobium rufovillosum) is one of the most important pests of historical wood constructions. Further analysis of the exact nature of the feeding habits regarding diet and wood characteristics might deliver answers for controlling this pest. Also there is little known about genetic variability and population structure within the species. For analysis of infested wood and also...
M Höpken, E Melcher, J Trautner
Use of small volume cups in XRF analysis of treated wood retention
2017 - IRG/WP 17-20602
Efforts are underway in the United States to improve the conformance of commercially-treated wood with the applicable retention standards. As part of an effort to devise a practical method for on-site assessment of within-charge retention variation, we investigated whether small-volume x-ray florescence (XRF) sample cups could be used with treated wood. A range of cup sizes, preservative types, re...
R Stelzer, A Taylor, P Lebow
Analysis of Wood Industrial Pollutants Based on Emission Coefficients
2017 - IRG/WP 17-50325
Accurate calculation and estimation pollutants is one of the basic tasks of environmental protection .The low carbon economy put forward However,low carbon economy data of wood industry is lack. The paper research on emissions and pollution of Chinese wood industry. The results showed dust emissions from much to least is: fiberboard, plywood and particle board; the amount of industrial ...
Chu Jie, Ma Ji, Zhangjing Chen
NGS analysis of fungal OTUs in Aquilaria sp. from French Guyana, Cambodia, Laos and Thailand
2017 - IRG/WP 17-50328
Aquilaria is a tree species belonging to the Thymeleaceae family. When Aquilaria sp. is injured, it produce agarwood. Agarwood is characterized by a darker wood colour than the healthy one and by a strong perfume that is much esteemed by perfumers and some oriental religious communities. The production of agarwood is presumed to depend of environmental factors, among them fungi. The aim of this wo...
C Zaremski, C Malandain, O Sibourg, C Andary, G Michaloud, M Ducousso, N Amusant, A Zaremski
Exploration of waterlogged piles and wooden constructions of Riga Dome Cathedral
2017 - IRG/WP 17-10901
The Riga Dome Cathedral’s waterlogged wood piles and the roofs and tower's wooden structures were investigated, the extent of biological damage was evaluated, and the wood rot fungi and insects were identified. The pile wood’s component composition and elemental composition were analysed; the wood structure damage by erosion bacteria was microscopically determined. In the roofs and tower ...
B Andersons, I Andersone, I Irbe, V Fridrihsone, R Lūsis
Multivariate modeling of mould growth in relation to extractives in dried Scots pine sapwood
2017 - IRG/WP 17-20629
Influence of extractives on mould growth on Scots pine sapwood dried in air or in kiln was studied. Boards were sprayed with water mixtures of spores of the fungal species Penicillium sp., Aspergillus sp., Mucor sp., Paecilomyces sp., Trichoderma sp., treated at a temperature of 22ºC at 90% RH, classified into a percentage of covered area. Acetone and water extracts were isolated and analyzed for...
O Karlsson, O Myronycheva, M Sehlstedt-Persson, M Öhman, D Sandberg
Assessing the nutrient value of bio-based materials in relation to early fungal growth
2017 - IRG/WP 17-20631
Bio-based materials are gaining importance in the building industry, as the focus on sustainability and life-cycle-assessment has increased dramatically over the last decade. Wood and wood-engineered products as well as insulation materials made from flax, hemp, etc. are hence increasingly used. These materials originate from renewable resources and are often biodegradable, which can cause problem...
L De Ligne, J Van den Bulcke, J Baetens, B De Baets, J Van Acker
A Conceptual Review of Young People’s Perceptions about Wood
2018 - IRG/WP 18-40836
This article was adapted from the previous study “Young People’s Perceptions about Wood” prepared by Usta (2017), and extended through the development and evaluation of the initial data in terms of the conceptual framework regarding the descriptions of wood by young people. Because it was highlighted by previous study that the university students as the full members of society have the aware...
I Usta
Difference of wood decay manner between brown-rot species
2019 - IRG/WP 19-10938
Wood blocks (Cryptomeria japonica) which were decayed by a Polyporales white-rot fungus (Trametes versicolor) and brown-rot fungi (Fomitopsis palustris, F. pinicola, and Wolfiporia cocos), respectively, were analyzed by X-ray diffraction and infrared spectroscopic methods followed by multivariate analysis. In the analyses, the differences in the cellulose crystallinities and infrared spectral patt...
R Kondo, Yo Horikawa, S Nakaba, K Ando, M Yoshida
Performance of modified wood in service - multi-sensor data fusion and its multi-way analysis
2019 - IRG/WP 19-20660
Recent developments in the field of electronic sensors and analytics provide new opportunity for accurate characterization of materials often based on portable and non-destructive methods. By using several complementary techniques, the material description is precise and complete. The data provided by multiple equipment, however, are often not directly comparable due to different resolution, sensi...
A Sandak, J Sandak, M Cocchi
Effect of pretreatment of wood surfaces with a copper monoethanolamine solution on the natural weathering performance of semitransparent stains
2019 - IRG/WP 19-40881
Semitransparent stains for wood products are favored for outdoor applications in Japan because these finishes do not hide the wood grain. However, the photoprotective effects of wood surfaces are low, therefor there is a need to improve the weathering performance. We examined the natural weathering performance of semitransparent stains on wood pretreated with a copper monoethanolamine solution (Cu...
S Isaji, H Shibui, Y Hirabayashi
FTIR analysis of wood blocks decayed by brown-rot fungi
2020 - IRG/WP 20-10959
Calibration curves of the relative lignin contents in Cryptomeria japonica decayed by brown-rot fungi were developed with Infrared Spectroscopy and Klason technique. First, wood decay test was conducted using brown-rot fungi (Fomitopsis palusris, F. pinicola, Wolfiporia cocos, Gloeophyllum trabeum, and Neolentinus suffrutescens) and white-rot fungus (Trametes versicolor) was used as a comparison. ...
R Kondo, Y Horikawa, R Kose, M Yoshida
Chemical Analysis of Southern Pine Pole Stubs Sixty Months Following Treatment with a Methylisothiocyanate-Based Solid Fumigant Stick
2019 - IRG/WP 19-30740
Methylisothiocyanate-based fumigants have been commercially used in the United States for over 35 years to control internal decay in utility poles and other wooden structures with little technological advancement. The most recently commercialized methylisothiocyanate-based fumigant is chemically known as dazomet. Dazomet is a free-flowing powder or granule that decomposes in the presence of mois...
D J Herdman, T Pope, R R Browning
Analysis of larval development and feeding of an Anobiid beetle using X-ray computed tomography
2020 - IRG/WP 20-10961
Priobium sp., an anobiid beetle, can attack wood used for historic constructions in Japan. Its life history and feeding biology, especially larval development and behavior, are poorly understood because the beetles are hidden inside wood most of the time. We used X-ray computed tomography (CT) to regularly scan wood blocks infested with the larvae of the Priobium sp. and observed the process of ...
H Watanabe, R Kigawa, Y Fujiwara, Y Fujii
New methods for estimating the volume of shipworm tunnels supported by image analysis
2020 - IRG/WP 20-20668
In marine environment, the main threat for wood is the bioerosion by woodborers, both peracarid crustaceans (such as gribbles Limnoria and pincher scuds Chelura) and bivalve molluscs (shipworms, Teredinidae).
The damage caused by gribbles on wood structure is surficial and easy identifiable, whereas the damage caused by shipworms is internal, therefore not evident, inducing unexpected crashes wit...
I Guarneri, M Sigovini, E Keppel, D Tagliapietra
Monitoring of wood preservatives exposed to weathering: Extraction and analysis methods of organic biocides from treated wood and collected rain runoff
2020 - IRG/WP 20-30753
Weathering is the cause of numerous damages for outdoor joineries. Protection of wood using a preservative treatment covered with a coating is a process widely used to limit these damages. However, biocides from preservative treated wood are prone to degradation and leaching, having a direct influence on the joinery service life. This document deals with extraction and analytical methods for bioci...
O Ouali, K Le Ménach, E Raphalen, L Podgorski, S Legay, H Budzinski
Comprehensive protection of timber in seawater
2020 - IRG/WP 20-10970
The hazard of wood in seawater can be divided into two areas: Below the water level, shipworm (Teredo navalis) and gribble (Limnoria lignorum) can attack non-resistant or insufficiently protected wood; above the water level, there is a risk by wood-destroying fungi and, to a lesser extent, insects. In a national project funded by the Deutsche Bundesstiftung Umwelt (DBU, German Federal Environmenta...
E Melcher, J Müller, T Huckfeldt