Your search resulted in 3031 documents. Displaying 25 entries per page.
Blue stain in service on wood surface coatings. Part 2: The ability of Aureobasidium pullulans to penetrate wood surface coatings
1992 - IRG/WP 92-1557
The ability of Aureobasidium pullulans to penetrate seven different wood surface coatings was examined. Eight isolates of Aureobasidium pullulans were used. Following penetration, light microscopy was used to examine the effect of the fungus upon the coating, and growth at the wood-film interface. The fungus showed different growth capabilities with different types of surface coatings. Some isolat...
P R Sharpe, D J Dickinson
Studies of the distribution and degradation of tributyltin naphthenate in double-vacuum treated wood
1983 - IRG/WP 3230
The effects of forced solvent evaporation by kilning redwood (Pinus sylvestris) that has been double-vacuum treated with tributyltin naphthenate (TBTN) have been investigated. Contrary to previous studies reported, it has been shown that forced evaporation can have a considerable influence on the losses of the fungicide. It has been found that, whether the solvent is allowed to evaporate slowly or...
J Jermer, M-L Edlund, W Hintze, S V Ohlsson
Rates of emission from CCA-treated wood in the marine environment: measurement, modelling and requirements for further research
2001 - IRG/WP 01-50166-12
Accurate estimates of rates of emission of leachate from preservative treated wood are crucial for realistic predictions of the environmental impact of its use in maritime construction. Estimates are available for some commonly used preservatives, but these vary widely. Though variable, these measurements suggest that emission generally decreases exponentially with time. Part of the variation is d...
S M Cragg, C J Brown, R A Albuquerque, R A Eaton
A new ground-contact wide-spectrum organic wood preservative: DNBP
1986 - IRG/WP 3358
A new organic wood preservative, which 25 years field tests have proved to be of efficiency and effectiveness comparable to CCA wood preservatives for ground-contact applications, is presented. Physical and chemical tests, supporting the long term field test results as well as indicating the characteristics of this preservative, are also presented....
W E Conradie, A Pizzi
The Thirteenth Report of the International Research Group on Wood Preservation 1983
1984 - IRG/WP 5194
R Cockcroft
Developments in wood preservation
1977 - IRG/WP 393
The purpose of this paper is to comment very briefly upon recent developments and trends in wood preservation so that members of this Working Group have a basic knowledge of activities in other countries. The last paper was prepared in April 1976 and the present paper refers to developments, since that time....
B A Richardson
Response of laboratory groups of Reticulitermes speratus (Kolbe) to different quantities of food
2003 - IRG/WP 03-10489
As part of a project aimed at improving understanding of the foraging biology of Japan’s most widespread wood-destroying termite, different sized groups of Reticulitermes speratus (0.5; 1 and 2 g) from two colonies were kept on 16 or 64 cm3 of sapwood of Cryptomeria japonica for 12 weeks in the laboratory. Patterns of wood consumption, wood consumption rates and survival are discussed....
M Lenz, T Yoshimura, K Tsunoda
Update on lab and field test results for polymeric alkylphenol polysulfide treated wood
2002 - IRG/WP 02-40240
The possibility of using Polymeric Alkylphenol Polysulfide (PXTS) as a wood preservative has been undergoing evaluation in our laboratories for the past four years. Various formulations prepared from this compound have been tested and found to be effective against wood decay fungi and insects in field stakes after 42 months exposure. In accelerated soil bed tests, PXTS has been shown to be consi...
J Goswami, A Abramson, R Buff, D D Nicholas, T Schultz
Corrosion of fasteners in heat-treated wood – progress report after two years’ exposure outdoors
2005 - IRG/WP 05-40296
The corrosion of common fastener materials now in use - mild steel, zinc-coated steel, aluminium and Sanbond Z-coated steel – has been evaluated after two years’ exposure outdoors in untreated and heat-treated spruce (Picea abies) respectively.
Spruce from South-western Sweden was used. The heat-treatment was carried out in Finland according to the ThermoWood process at a maximum temperature ...
J Jermer, B-L Andersson
Fluorine compounds for wood preservation
1971 - IRG/WP 304
Fluoride compounds have gained a considerable importance in wood preservation, especially in Germany and some other countries of Europe. They are used as single compounde or in mixtures of different compounds. In the International Research Group on Wood Preservation which continues the activities of a former OECD-Group, it was moved to prepare a survey on fluorides in wood preservation together wi...
G Becker
Accelerated ageing of preservatives in treated wood
1988 - IRG/WP 3476
New preservatives are tested in the laboratory and often in field tests before they are used commercially. Some preservatives, however, tested in the laboratory do not show the expected stability when used in service. The differences between laboratory tests and practical use can never be completely eliminated but must be minimized as far as possible by relevant testing methods. Studies of the eff...
M-L Edlund, B Henningsson, B Jensen, C-E Sundman
Regulations of pesticides (including wood preservatives) in the United States
1977 - IRG/WP 397
G B Fahlstrom
Performance results of wood treated with CCA-PEG
1986 - IRG/WP 3363
The addition of polyethylene glycol (PEG) to the CCA system has been shown to reduce the surface hardness of poles and ease spur penetration during climbing. This paper addresses the results of tests dealing with preservative retention and penetration, permanence of CCA and PEG, strength, drying rate, and checking characteristics....
W P Trumble, E E Messina
The Twelwth Report of the International Research Group on Wood Preservation 1982-1983
1983 - IRG/WP 5177
IRG Secretariat
The Phase Out of CCA in the United States
2002 - IRG/WP 02-50194
In mid-February, 2002 the Administrator of the United States Environmental Protection Agency, Christine Todd Whitman, announced that the US treated wood industry will have until the end of December 2003 to end residential uses for Chromated Copper Arsenate (CCA). Industrial uses of CCA will still be allowed after the December 2003 date. This paper explores the events that led up to the announcem...
J D Schert
Contribution to study of the degradation caused in Pinus spp. poles used in field test
1989 - IRG/WP 1417
The study of the degradation produced by soil natural microflora on wood in contact with it in the field, has been going on for several years now. Our contribution to this aim in the present work has dealt with the possible relationship of the microorganisms in the soil. The microscopic visualization of wood colonization by the microorganisms, and the chemical analysis of the degraded wood compare...
M T De Troya, A Garcia, M J Pozuelo, A M Navarrete, A Cabanas
Efficacy of anhydrides as wood protection chemicals - II. Performance against soft rot fungi
1998 - IRG/WP 98-30174
Pine sapwood modified with various anhydrides and with butyl isocyanate was tested for its resistance to soft rot decay. Small stakes were exposed for 20 months in unsterile soil in a fungal cellar test.
Wood modified with butyl isocyanate performed better than any of the anhydrides tested, with a threshold level of protection (less than 3% weight loss) at 12% weight percent gain (WPG). Stakes ac...
S C Forster, M D C Hale, G R Williams
Electron microscopic detection and chemical analysis of three-lamellar structures in wood-destroying fungi
1984 - IRG/WP 1240
In the course of transmission electron microscopical investigations of pine wood decay by various brown- and white-rot fungi extracellular three-lamellar structures (TLS) formed by the fungi were found in specimens stained with ruthenium red. These structures occured in the lumen of the wood cell surrounding the hypha at the outermost layer of the fungal cell wall. In the course of the investigati...
R Foisner, K Messner, H Stachelberger, M Röhr
Assessment of losses of wood preservatives from treated wood by leaching into the environment
1993 - IRG/WP 93-50001-13
Wood preservative chemicals may be lost from treated timber by leaching into water or soil. The degree to which this might occur and its effect on the environment is difficult to assess quantitatively due to the absence of appropriate test methods. This paper describes work to assess test methodology capable of allowing the rates of loss of wood preservative from treated timber to be quantified. T...
R J Orsler, G E Holland
Wood-attacking organisms in Brazil
1982 - IRG/WP 1168
Lists of the main wood-attacking beetles, termites, fungi and marine borers in Brazil are presented with the respective wood species from which they were collected....
M S Cavalcante
Forest products laboratory methodology for monitoring decay in wood exposed above ground
1995 - IRG/WP 95-20074
Research at the Forest Products Laboratory on the durability of wood in service has included a full complement of laboratory and field tests. In this report, we present a review of past and current methods used to evaluate the condition of preservative-treated wood exposed above ground. Current protocols are described for tests on wood packaging, roofing, and dimension lumber....
R C De Groot, T L Highley
Fiji wood preservation regulations
1980 - IRG/WP 3138
A S Alston
The Fourth Annual Report of the International Research Group on Wood Preservation 1972-1973
1973 - IRG/WP 522
IRG Secretariat
Protocols for assessment and approval of wood preservatives in the Nordic countries
1994 - IRG/WP 94-20046
This paper reviews the protocols presently in use in the Nordic countries (Denmark, Finland, Iceland, Norway and Sweden) for assessment and approval of wood preservatives with respect to their biocidal efficacy....
J Jermer, B Henningsson
Environmental issues: Messages for the wood preservation industry
1985 - IRG/WP 3353
A review of the origins and structure of environmental legislation throughout those territories of the world where wood preservation is a major industry is given. The implications of media, industry and legislation interaction is discussed and suggestions made as to the key issues the wood preservation industry should concentrate its attentions on in the immediate future....
D G Anderson, P Waldie