Your search resulted in 3471 documents. Displaying 25 entries per page.
Performance of Borate-Treated Wood Against Reticulitermes flavipes in Above-Ground Protected Conditions
2003 - IRG/WP 03-30309
Termites cause economically significant damage in Canada only in a few localized areas. However, one of those is in Canada’s largest city, Toronto, Ontario. In 1996, a test was set up of borate-treated lumber above ground, protected from rain but exposed to subterranean termites (Reticulitermes flavipes) in Kincardine Ontario. The material included western hemlock and amabilis fir lumber trea...
P I Morris, J K Grace, K Tsunoda, A Byrne
Effect of compression wood on leaching of chromium, copper, and arsenic from CCA-C treated red pine (Pinus resinosa Ait.)
2000 - IRG/WP 00-30232
In this study, the effect of compression wood formation on the release rate of chromium, copper, and arsenic elements from red pine (Pinus resinosa Ait) was investigated. Wood blocks from red pine containing compression and normal wood portions were treated with a 1.0% CCA-C solution and were then allowed to fix at 23 ± ??2°C (74 ± 4°F) for 0, 6, 24, 48, 96, 192, and 336 hours. After each fixa...
S N Kartal, S T Lebow
International standards - can we make them simple? Stage 2: Reflection arising from the discussion at IRG 27
1996 - IRG/WP 96-20103
For the purpose of the ISO FAST TRACK project on preventive wood protection and durability, one shall refer to the 3 following stages:
Hazards: (for wood in service), a review of biological agencies defining the scope;
Exposure: a review of local, geographical parameters influencing the virulence of biological agencies towards wood in service (i.e climate indexes);
Risks: as a combination of ha...
G Ozanne
A diffusion and reaction model for the leaching of Cr-VI from unfixed CCA-treated wood
2001 - IRG/WP 01-50169
A physical model applicable to the leaching of any substance undergoing a first-order fixation reaction with wood is presented. Using this model and a laboratory leaching experiment with small wood samples immersed in water, the radial and tangential diffusion coefficients and the reaction rate constants of Cr-VI in unfixed CCA-treated red pine (Pinus resinosa Ait.) are measured. Reaction rate con...
L Waldron, P A Cooper
Proceedings from the wood preservation symposium "The Challenge - Safety and Environment" 19-20 February 1990, Cannes, France
1990 - IRG/WP 3600
Contains the List of Participants and the following 29 Documents (IRG/WP/3562-3590):
Canadian code of good practices - Recommendations for design and operation of wood preservation facilities. (IRG/WP/3582)
Current models used by the European health authorities to evaluate the vililization of active ingredients from treated wood used inside dwellings. (IRG/WP/3565)
Creosote and cancer. (IRG/WP/...
Anonymous
Biological and physical properties of phenolic-resin treated wood before and after natural weathering
1999 - IRG/WP 99-40132
Biological and physical properties of phenolic resin-treated particleboards, which were made from fast growing tress and agrowaste as raw materials, were evaluated before and after natural weathering in tropical climate. The particles were sprayed with a mixture of a low molecular weight phenol-formaldehyde resin (5.0, 7.5 and 10% loading) and the adhesive phenol resin (8% loading). Results with l...
S Yusuf, Y Sudiyani, H Kajita, Y Imamura, M Takahashi
Migration of chlorothalonil and carbendazim in fruits stored in wood treated with the anti-sapstain formulation Tuff Brite C
1997 - IRG/WP 97-50097
Fruits and vegetables stored in treated wood boxes are in contact with the products used for the treatment. In order to obtain regulatory approval for incidental food contact it is necessary to determine the quantity of residues on these fruits or vegetables. When the active materials are used in agriculture it is required that residues found are below to the MRL fixed for these substances. In the...
J F Cooper, D Riboul, M De Vleeschauwer, T L Woods
Development of software to automate the quantification of checking occurring in preservative treated wood exposed to weathering
2001 - IRG/WP 01-20228
Surface checking often disfigures the appearance of wood treated with water-borne preservatives and treatments designed to reduce such checking have been receiving increasing attention. Progress in this area has however been slowed by the lack of a method of rapidly and accurately quantifying checking at treated wood surfaces. A software package has therefore been developed which identifies, measu...
A G Christy, P D Evans
Microdistribution of Copper in Copper-Ethanolamine (Cu-EA) Treated Southern Yellow Pine (Pinus spp.) related to density distribution
2004 - IRG/WP 04-40270
The relationship between copper absorption and density distribution in wood cell walls was investigated in this study. The density distribution on layer level was obtained from two approaches: (1) calculation by using data obtained from literature; (2) microdistribution of carbon and oxygen atoms in the wood cell. The microdistribution of carbon and oxygen in untreated southern yellow pine (Pinus ...
Jinzhen Cao, D P Kamdem, E Pasek
Environmental aspects of wood preservation
1987 - IRG/WP 3406
The preservation industry employs a wide range of chemicals and processes to provide timber commodities capable of resisting biodeterioration and degradation. The public often perceives the chemicals as health hazards and treatment plants as potential threats to the environment. This paper attempts to place in proper perspective the value of wood preservation. It discusses aspects of health and sa...
H Greaves
Evaluation of impact of CCA-treated wood on the marine environment
1995 - IRG/WP 95-50040-15
This paper reviews the literature relating to the potential of CCA-treated wood to affect the marine environment and outlines the compounds required for a model which could be used to predict the environemental impact of maritime construction using such timber. Marine pilings require high loadings of CCA to provide protection from marine borers. Though loadings of 32-48 kg/m³ provide long-term pr...
R M Albuquerque, S M Cragg
CCFZ, a new type of water-borne wood preservative for vacuum pressure impregnation
1991 - IRG/WP 3643
By combination of CCF-Salt types with zinchexafluorosilicate a remarkable improvement of efficacy is achieved. In the same time the ecotoxicoligical data become more save. As well as the efficacy against wood-destroying organisms (Basidiomycetes, Soft rot and Long horn beetle) the basic data to evaluate the ecotoxicological behaviour of a CCFZ-Salt are described and compared with the properties of...
W Metzner, D Seepe, H-W Wegen
The Disposal of CCA-Treated Wood in Simulated Landfills: Potential Impacts
2003 - IRG/WP 03-50198
Landfills are typically where CCA-treated wood is currently disposed, and will likely continue to be the primary form of management in the future. It has been shown that arsenic, copper and chromium leach from CCA-treated wood in certain situations; however, the impact of the disposal of CCA-treated wood on landfill leachate is currently unknown. The objective of this research is to examine the po...
J Jambeck, T G Townsend, H M Solo-Gabriele
Comparison of the anti-fungal efficacy of Cobra with drill perforation on oscillating pressure treated spruce transmission poles -Laboratory test
1988 - IRG/WP 3469
A laboratory method for measuring the depth of penetration of the fungicidal concentrations effective against basidiomycetes (brown rot) was developed. The tests on CCB oscillating pressure treated spruce transmission poles have shown that the depth of salt penetration can be increased by about 10 mm by a drill perforation before the impregnation. An even better penetration is reached, however, if...
E Graf, B Zgraggen
Management strategies for the disposal of CCA-treated wood
2000 - IRG/WP 00-50155
A two-fold management strategy is presented for the disposal of wood treated with chromated copper arsenate (CCA). The first part focuses on the use of alternative wood treatment preservatives. The second part of the management strategy addresses short-term disposal issues (less than 25 years) by developing new methods to handle the waste. A set of seven alternative wood preservatives were evaluat...
H M Solo-Gabriele, T G Townsend
International comparison of three field methods for assessing the in-ground resistance of preservative-treated and untreated wood to termites and fungal decay – Summary of observations after five years
2003 - IRG/WP 03-20261
Results are presented from a five-year study conducted in five locations in Australia, Thailand and the USA. Three methods of exposure were assessed (below-ground, graveyard and ground contact) for evaluating the in-ground termite and decay resistance of Pinus radiata D. Don sapwood stakes that had been vacuum pressure impregnated with CCA (Type C) and ACQ (Type D) each at two nominal retentions (...
M Lenz, J W Creffield, T A Evans, B M Kard, C Vongkaluang, Y Sornnuwat, A F Preston
A new type of biocide suitable for use in different fields of wood preservation
1993 - IRG/WP 93-30014
A new type of polymeric biocides was developed containing quaternary ammonium and boron ester groups as active structure elements, to overcome the disadvantages of AAC's in wood preservation use and to utilise their good performance due to a broad efficacy against fungi on the other hand. The new biocides called polymeric betains have been tested in laboratory and field tests and especial...
V Barth, H Härtner
Proceedings of the 3rd international wood preservation symposium "The Challenge - Safety and Environment" 6-7 February 1995, Cannes-Mandelieu, France
1995 - IRG/WP 95-50040
Contains the following 35 Documents (IRG/WP 95-50040/1 - IRG/WP 93-50040/35), conclusions (summaries of the sessions chairmen) and some poster abstracts:
Le pin: Matériau à contact alimentaire [Pine wood as a material for food contact] (IRG/WP 95-50040/1); The use of a physical field model to study the effects of remedially treated timber on the growth of perennial ryegrass (Lolium perenne) and...
Anonymous
Surface characteristics of wood treated with various AAC, ACQ and CCA formulations after weathering
1991 - IRG/WP 2369
Wood samples treated with various alkylammonium compounds (AACs) as well as ammoniacal copper quat (ACQ) and chromated copper arsenate (CCA) have been studied in accelerated weathering experiments. Microscopic examination of the surfaces of these samples after exposure in a weatherometer revealed several different changes. Samples treated with didecyldimethyl ammonium chloride (DDAC) show consider...
L Jin, K J Archer, A F Preston
Effect of Oil Content on The Performance of Wood Treated with Pentachlorophenol
2003 - IRG/WP 03-30324
This paper details a five-year study on southern pine treated with pentachlorophenol in oil at various oil contents. Results from field stake tests at two Gulf Coast test sites are presented. Both biological efficacy and preservative depletion data are discussed. Results suggest that increasing oil content leads to better performance of wood treated with pentachlorophenol. Test results indicat...
H M Barnes, T L Amburgey, M G Sanders
Fungal decay resistance of Rubber wood treated with heartwood extract of Rosewood
2005 - IRG/WP 05-30367
Alcoholic extract of Dalbergia latifolia heartwood was studied for its toxicity towards wood decaying fungi. Rubber wood blocks were treated with this extract to three different retention levels (0.1%, 0.2% & 0.5%) and the treated wood blocks were assessed for their resistance towards two white rot and two brown rot fungi. Treated blocks showed improved resistance over the control blocks. At 0...
A K Sethy, H C Nagaveni, S Mohan, K T Chandrashekar
Kinetics of the dissociation of Cr, Cu, and As in fixed CCA-treated wood
2001 - IRG/WP 01-50168
The results of an experiment showing the kinetics of the dissociation of CCA compo-nents in water within treated wood samples are presented. Dry red pine (Pinus resinosa Ait.) samples were simultaneously vacuum-treated with water, then expressed to re-move the water at successive time intervals. The expressate was then analyzed for Cr, Cu, and As concentration by inductively coupled plasma (ICP). ...
L Waldron, P A Cooper
Fungal decay of acrylate treated wood
2004 - IRG/WP 04-30357
Natural durability of wood species is variable. Chemical wood preservatives, such as biocides are necessary for extension of their service life. Many methods have been developed to increase the resistance of wood and wood products against wood-destroying organisms during the last years. The most frequently used methods are chemical and thermal modification of wood. In wood modification the basic c...
Z Tiralova, L Reinprecht
Inorganic preservative levels in soil under treated wood decks after 8 years natural exposure in Borås, Sweden
2005 - IRG/WP 05-50233
Inorganic preservative components (Cu, Cr and As) were measured to a depth of 150 mm under deck structures made with Scots pine lumber treated with several different wood preservatives and installed in Borås Sweden 8 years ago. Higher contaminant levels were observed mainly under the drip lines and in the top 50 mm of soil. Under CCA treated decks, soil arsenic concentrations increased from ba...
P A Cooper, Y T Ung, M-L Edlund, J Jermer
Modelling of copper emission fron treated wood leached according to NEN 7345 and ENV 1250.2
1996 - IRG/WP 96-20097
A series of water leaching experiments is carried out investigating pine and spruce treated and fixed using different copper-containing preservative solutions and process technologies. Water changes took place as prescribed in the Dutch standard NEN 7345 and the European test method ENV 1250.2, each of the leachates being chemically analysed for their copper content. Irrespective of the preservati...
G M F Van Eetvelde, S G L Michon, M Stevens