Your search resulted in 367 documents. Displaying 25 entries per page.
Promoting Commercially Available Epoxy Resins for Non-biocidal Wood Preservation
2019 - IRG/WP 19-40877
Commercially available epoxy and polyamine resins were evaluated with the aim of developing new non-biocidal wood preservation treatments. A simple method allowing the impregnation of wood by vacuum double impregnation followed by a curing process was developed for two reference species, beech Fagus sylvatica and Scots pine Pinus sylvestris. The tested products were evaluated for their ability to ...
P Poveda, M Mubarok, S Dumarcay, M Montibus, I Le Bayon, M Kutnik, P Gerardin, F Simon
Alternative products enhancing dimensional stability comparing to conventional treated products in Japan
2019 - IRG/WP 19-40885
The Act on the Promotion of the Utilization of Wood in Public Buildings (2010) in Japan has made a new stream of the utilization field of timber from housing constructions to larger scale non-housing constructions. After the act, the performance of dimensional stability in preservative treated products becomes more important factor than before. Therefore, various technologies have been developed, ...
K Yamamoto, D Tezuka, Y Sugai, S Maeda, I Momohara
Study on Nailed Joint with Iron Contamination. Part1: Shear Performance of Nailed Joint with Iron Contamination
2019 - IRG/WP 19-50349
In Japan, The building standard law was amended in 2000.1) The use of metal joint was obligated by this law. Since then, metal joints have been largely used for wooden buildings. Also, Act on the Promotion of Popularization of Long-life Quality Housing was enacted in 2009 and leaving Long-life Quality Housing has been focused on2). However, leaving houses to posterity for a long time causes severa...
R Nakano, D Nakano, H Ishiyama
Studying amount, location and state of water in modified wood at moisture levels relevant for fungal degradation
2020 - IRG/WP 20-40889
Water is an essential parameter for fungal degradation of wood, but degradation primarily occurs at high moisture levels at water potential in the range of -4 to -0.1 MPa, which corresponds to 97-99.9% relative humidity. At these moisture levels, water is present in the wood structure both in and outside of cell walls. The majority of previous studies on the interaction between wood and water for ...
M Fredriksson, E Engelund Thybring, Ramunas Digaitis
Preliminary investigation for preservation method of CLT using non-pressure treatment
2021 - IRG/WP 21-40919
Cross-laminated Timber (CLT) is increasingly being used in residential and non-residential construction around the world, and some of these areas are at high risk of biodeterioration. Addition to moisture management of construction, preservative treatment of CLT may be needed to prevent decay and termite attack in the area. Pressure treatment being most reliable, is not feasible due to the large d...
T Miyauchi, Y Ohashi, J Miyazaki, R Takanashi, H Shibui, S Isaji, T Shigeyama, Y Sugai, A Yamamoto, T Hramiishi, T Mori, H Matsunaga
Evaluation of ecotoxicological effects of different coniferous wood treatments on two marine bioindicator species
2022 - IRG/WP 22-10999
Coniferous wood panels (Picea abies) were treated with two concentrations of copper-based impregnating agent to increase its durability in marine and brackish environment. In order to assess the environmental compatibility of the treatments a laboratory experiment was conducted with two marine invertebrate species: bivalve Mytilus galloprovincialis and a gastropod Steromphala albida. The bioindica...
T Marčeta, N Nesto, I Guarneri, D Tagliapietra, V Moschino
Brief introduction to a research project on preparations of various paste formulations from boron, fluoride and copper for supplemental treatments
2022 - IRG/WP 22-30759
Wood preservatives to be used for supplemental purposes are present in various forms such as powders, liquids, rods, pastes, or gels. Boron compounds have been receiving a lot of attention in supplemental treatments since they have good mobility in wood. Application of boron compounds via internal treatments is vital to stop decay to be occurred inside the wood since large wood elements are too th...
E E Soytürk, D Bakır, E Terzi, C Köse, S N Kartal
Utilization of Pressure Treated Lumber in Cross Laminated Timber Manufacture and its Impact on Bondline
2022 - IRG/WP 22-40953
Mass timber building construction is increasing dramatically across North America which presents challenges to these structures not seen in Northern Europe. Large parts of the United States harbor termites and existing mass timber building technologies that rely solely on moisture exclusion to increase durability are insufficient in these areas. The successful expansion of mass timber construction...
G Presley, C Wainscott, J Valenti, S Noble
A six-year ground proximity trial of TRU-CORE treatments at Innisfail, Queensland
2023 - IRG/WP 23-30775
This article describes an H3 (above ground outdoor) ground proximity field trial that compares the performance against decay fungi of TRU-CORE (also known as the Buffered Amine Oxide Enhancement System) Copper Quat (CQ) with CCA and commodity Alkaline Copper Quat (commodity-CQ) treatments, all in Pinus radiata. The retentions achieved reflected commercial practice, where higher mean retentions are...
L Cookson
Establishing the minimum effective penetration of wood preservatives in the refractory heartwood of E. nitens
2023 - IRG/WP 23-30780
Conventional pressure treatment of many Australian hardwoods results in little to no penetration of heartwood and a non-uniform envelope treatment of <5 mm surrounding a mostly untreated core. This is a major issue for many of the low durability plantation hardwood timbers that are grown in Tasmania, which contain high percentages of heartwood. Long term studies on softwoods such as spruce decking...
J R Vargas, J J Morrell, L Yermán, K C Wood
Identifying compatible waterborne timber preservatives and fire retardants for use in a VPI system: a practical approach
2023 - IRG/WP 23-30796
To enhance the use and suitability of timber in all applications in both exterior and interior settings, timber typically needs to be treated with a preservative and/or a fire retardant chemical. Combining fire retardants with preservatives into a single treatment process has been a long-term aim of researchers in the timber preservative industry because of the significant logistic and economic ad...
R Robinson, S Meldrum
Evaluation of the efficacy of silver nanoparticles and chitosan oligomer composites as poplar wood protective treatments against termites
2023 - IRG/WP 23-40963
Populus × euramericana ‘I-214’ (poplar) is a fast-growing species widely distributed throughout the world, and in the Castile-Leon region of Spain it accounts for more than 50% of all plantations. Its wood is becoming increasingly appreciated, yet its low durability against xylophagous agents —termites being one of the most aggressive and destructive in warm climates— continues to be a li...
E Spavento, M T Troya, M Casado-Sanz, J Martín-Gil, P Matín-Ramos, L Robertson, L Acuña-Rello
Non-vacuum/pressure ACQ treatment
2023 - IRG/WP 23-40971
Many developing countries are located in sub-tropical or tropical regions where rapid wood deterioration results in early failure of many structures. Whilst preservative treatment would help to reduce these losses and extend the forest resource commercial vacuum pressure treatment systems are often too expensive. The use of lower technology treatment systems, while not as quick as vacuum pressure ...
J Norton
UV protection and dimensional stability of lignin-based wood treatments
2023 - IRG/WP 23-40979
New developments in the field of wood modification aim to enhance the intrinsic properties of natural timber. The limitation of wood should be preferably achieved with biobased ingredients and efficient, eco-friendly treatments possessing low environmental impact. Consequently, new solutions assuring expected properties and functionality over elongated service life and reducing the risk of product...
R Herrera,O Gordobil, F Poohphajai, A Sandak
Modification of wood by fast pyrolysis bio-oil – the NewWave project concept for bio-based wood treatment
2023 - IRG/WP 23-40990
The NewWave project aims to contribute to building a circular economy by introducing sustainable raw materials in different manufacturing lines, replacing toxic chemicals and lowering the environmental footprint of the products. The raw materials are obtained from the thermochemical fractionation of biomass. This process converts biomass residues by fast pyrolysis into Fast Pyrolysis Bio-Oil (FPBO...
A Sandak, J Sandak, F Poohphajai, R Herrera Diaz, A Gubenšek, K Butina Ogorelec, L Kiezebrink, K J Swager, H Heeres, B van de Beld
Effects of phosphoric acid and diammonium phosphate treatments on the physical and fire-retardant properties of five selected Nigerian wood species
2024 - IRG/WP 24-20713
Wooden products in buildings are major sources of fuel for fire outbreaks. Effects of phosphoric acid and diammonium phosphate treatments on the physical and fire-retardant properties of wood species commonly used in buildings were evaluated. The timber species utilized in this study were sourced from the sawmill sector located in Akure, Nigeria, encompassing Brachystegia laurentii, Khaya ivorensi...
J Owoyemi, T O Akinwamide, O M Ibrahim, E A Iyiola
Elevated pressure hybrid wood modification: Synergistic effects on durability performance
2024 - IRG/WP 24-20725
The combination of different wood modification technologies to obtain improved performance is increasingly receiving attention in research. In this study, Scots Pine was impregnated with furfuryl alcohol (FFA) in pure aqueous 20, 40 and 60% solution strength without adding any catalyst. In a second step, the FFA was polymerized while simultaneously performing thermal modification in a closed syste...
P Klaas, D Jones