Your search resulted in 511 documents. Displaying 25 entries per page.
Possibility of using lichen (Usnea filipendula) and mistletoe (Viscum album L.) extracts as potential natural wood preservative
2017 - IRG/WP 17-30712
Increasing environmental pressures on toxic chemical wood preservatives lead to the development of natural and environmentally friendly wood preservatives. In this study, using possibilities of lichen (Usnea filipendula) and leaves of mistletoe (Viscum album L.) as potential natural wood preservative were researched. Treatment solutions have been prepared with two different solvents, water and met...
Ü C Yildiz, C Kiliç, A Gürgen, S Yildiz
Controlled deposition of copper nanoparticles using wood inherent architecture as natural template
2017 - IRG/WP 17-40783
As one of the most abundant renewable biomass resources, wood can be used as templates for synthesizing functional nanoparticles with controlled shapes and sizes. In this study, copper nanoparticles were synthesized with controlled shapes and sizes using poplar wood as the natural inexpensive and renewable templates. The crystal structure and morphologies of the copper nanoparticles were character...
Youming Dong, Kaili Wang, Yutao Yan, Jianzhang Li, M Hughes, Shifeng Zhang
Performance of Norway spruce bridge in North-West Spain after 12 years exposure
2017 - IRG/WP 17-40796
Across Europe is very common to find bridges build in sawn and glue-laminated wood. Most of these bridges used softwood wood species such as: fir, spruce, larch and pine.
In Spain wooden bridges, became more and more popular since nineties, when sawn and glue-laminated wood were utilized for building exterior wooden structures in overall Spain.
This material, sawn and glue-laminated wood, are ma...
D Lorenzo, J Fernández-Golfín, M Touza, M Guaita, A Lozano, J Benito
Moisture behaviour and biological durability of high performance flax fibre reinforced composites
2017 - IRG/WP 17-40803
For natural fibre composites in structural and load bearing applications long reinforcing fibres are required. Therefore, much research is performed on flax fibre reinforced composites to optimize them for high performance use. In most cases such research focuses on the mechanical properties, yet the assessment of moisture behaviour, dimensional stability and biological durability is an important ...
N Defoirdt, J Van den Bulcke, F Bensadoun, J Ivens, I Verpoest, J Van Acker
Studying Weathering Performance of Coatings on Thermally Modified Wood
2017 - IRG/WP 17-40805
Thermal modification and degree of improved properties depends on wood species and treatment parameters. Southern pine and spruce are the two common wood species for decking, fences and siding in North America. This study was the first to evaluate coating performance when applied on oil-heat-treated southern pine and spruce wood samples. Water uptake, colour and gloss changes of samples were analy...
M Nejad, M Dadbin, P Cooper
Decay resistance of beams made from thermally modified Scots pine and Norway spruce after 6 years’ exposure in ground contact
2017 - IRG/WP 17-40806
In the present study the resistance of beams treated by ThermoWood® process was studied in ground contact and the results given are based on a “modified” EN 252 test. After six years’ exposure clear differences were found between untreated Scots pine and Norway spruce beams and treated ones. In all cases thermal modification improved the performance. Thermally modified pine heartwood showed...
S Metsä-Kortelainen, H Viitanen
Corrosion of fasteners in furfurylated wood – final report after 9 years exposure outdoors
2017 - IRG/WP 17-40810
The corrosion of some common fastener materials – mild steel, stainless steel, zinc-coated steel, brass and Sanbond Z (nickel, zinc and chromate) coated steel – has been evaluated after nine years exposure outdoors in untreated Scots pine and furfurylated beech and southern yellow pine (SYP).
The furfurylation was carried out according to a process that resulted in approximately 40 % WPG (We...
J Jermer, B-L Andersson, J Schalnat
Effects of exposure time on detection of the behavior of white-rot fungi on Oriental beech wood properties
2017 - IRG/WP 17-10902
The comparison of fungal degradation of Orientalis beechwood by two white-rot fungi was evaluated in this study. Biological, mechanical, and chemical assessments of beech wood were carried out at 30 day interval for 120 days. The results demonstrated that both fungi have greater effects on beech wood during each exposure time. However, Trametes versicolor degraded beech wood more effectively than ...
E Bari, D D Nicholas, K M Ohno
Preliminary Investigation into the Natural Decay Resistance of Nigerian Grown Hevea brasiliensis and Mitragyna ciliata wood to Phanerochaete chrysosporium White-Rot Fungus
2018 - IRG/WP 18-10919
Wood is an important and versatile structural building material that finds applications in numerous uses. However, wood is also a biological material vulnerable to degradation by microbial activities; this is especially true in the tropics. Following the scarcity of highly durable species from our natural forests and the introduction of so many lesser used/durable wood species into the booming tim...
J M Owoyemi, U O Emmanuel
Wood chemistry completes natural durability as criteria for shorting best provenances in the improvement of teakwood quality: case of five provenances from Ivorian Séguié’s trial
2018 - IRG/WP 18-10920
In order to determine the best provenance for continuing breeding program in Côte d’Ivoire, five provenances of teak planted in 1970 at Séguié’s trial (Agboville, in the south of Côte d’Ivoire), were compared. Fifteen trees (three trees per provenance) composed the sample. Decay resistance and the chemical content especially, non-structural carbohydrates, total phenolics and quinone comp...
F B Niamke, N Amusant, A A Adima, A A Kadio, G Chaix, C Jay-Allemand
Understanding of the effect of ancestral and natural saltwater treatment on durability, fibers densification and chemical modification of palm wood
2018 - IRG/WP 18-10921
The palm-tree sector plays a very important role on both the socioeconomic and ecological levels, in Tunisia. There are three million trees in Tunisian palm plantations, ensuring a potential significant wood production, mainly in the craft and furniture industries.
In the past, Date Palm wood (Phoenix dactylifera L.,) was also used as structural material. Its low natural durability and its low m...
M T Elaieb, A Namsi, M Tella, M-F Thévenon, K Chandelier
Use of x-ray microdensitometry for assessing the resistance to the fungus C puteana of a hybrid larches population
2018 - IRG/WP 18-10923
The aim of this research was to utilize the X-ray microdensitometry to determine the natural durability and its variability of a hybrid larch population. The method was applied on slices obtained by increment cores collected on standing trees before cutting them down. The methodology was discussed also in order to propose as a new screening method especially suited for trees populations. X-ray mic...
S Palanti, F Alderighi, F Stefani, J P Charpentier, L E Pâques
Natural resistance of Bambusa vulgaris to termite and powder-post beetle attack in laboratory and graveyard tests
2018 - IRG/WP 18-10925
Deterioration is the major setback to the utilisation of bamboo products. To enhance bamboo utilization, an understanding of the level of resistance to degradation is important. In this study, level at which Bambusa vulgaris will naturally resistant attack by subterranean termites and powder-post beetles were evaluated. B. vulgaris aged 2, 3 and 4 years were subjected to attack by subterranean ter...
N A Sadiku, S O Bada
Natural durability, ethanol-toluene extractives and phenol content prediction of eight wood species from Madagascar using NIRS multispecific models
2018 - IRG/WP 18-10926
Madagascar has nearly 4000 species of trees and shrubs, but wood properties of only 200 species have been studied. Some properties, such as the natural durability or chemical composition are of importance for adequate and optimal use of these timber species. Since durability tests take long time and chemical analyzes can be very expensive, alternative methods such as near infrared spectroscopy (NI...
A R Razafimahatratra, H Rakotovololonalimanana, M-F Thévenon, C Belloncle, G Chaix, T Ramananantoandro
On the natural durability of RED MERANTI for window frames as a function of gross density wood
2018 - IRG/WP 18-10927
MERANTI is a wood species belonging to the family Dipterocarpaceae, in the genus SHOREA (Shorea spp.). The genus has approximately 196 species with four subgenera. The subgenus RUBROSHOREA is commonly named RED MERANTI (RM) and is found on the Malayan Island of Sarawak, Indonesia, with approximately 65 varieties (Symington 1943). According to Brazier (1956), the distribution of gross densities wi...
K Hasse, W Unger, T L Woods
Study of the effect of extractives on the natural durability of Eucalyptus bosistoana wood
2018 - IRG/WP 18-10928
Wood as a natural material is degradable both by biotic deterioration agents (fungi, bacteria, marine borers, insects) and abiotic (UV and IR radiation, moisture, fire, etc.). The inherent resistance to the attack of the deteriorating agents is defined as the natural durability of the wood. This is an important property when considering the shelf life of wood products exposed to extreme conditions...
M Ibáñez, C Mantero, N Silva, F Resquín
Bio-preservative properties of technical lignins from South African pulp mills: An investigation towards a conceptualized development of natural compound-based wood preservatives
2018 - IRG/WP 18-30724
The depletion of naturally durable timber and the risk posed by some of the conventional wood preservatives to human health and the environment continue to drive research efforts towards developing new formulations that are benign. Furthermore, the global concept of environmental sustainability aims at optimal use of resources and to comprehensively include conversion of waste to value added produ...
A Alade, L Tyhoda, M Meincken
Properties and potential use of Irvingia gabonensis and Irvingia wombolu kernel extracts as natural wood adhesives: Towards formaldehyde free wood composite products
2018 - IRG/WP 18-40832
Irvingia species are widely distributed in central and West Africa as well as parts of Asia and are earmarked for domestication due to the multitude of potential products that can be obtained from them. With renewed interest in renewable sources, the current study establishes the feasibility of utilizing extracts from Irvingia gabonensis and Irvingia wombolu kernels as wood adhesives. Proximate an...
A O Alawode, S O Amiandamhen, M Meincken, L Tyhoda
Visual appearance of unpainted wooden claddings during the first year of outdoor exposure: Evaluation of surface mould growth, lightness (L*) and wasp attack
2018 - IRG/WP 18-40841
This study addresses changes in visual appearance of unpainted wood materials exposed outdoors. Specimens of Norway spruce (Picea abies) Scots pine (Pinus sylvestris), aspen (Populus tremula), acetylated Radiata pine (Pinus radiata) and DMDHEU-modified Scots pine sapwood were exposed facing south in Ås, Norway for 60 weeks. During this period, surface mould growth development and wasp attack were...
S Karlsen Lie, L Ross Gobakken, G I Vestøl, O Høibø
Natural durability of four Tunisian Eucalyptus wood species and their respective compositions in extractives
2019 - IRG/WP 19-10942
In the 50’s, Tunisia government introduced more than 11 Eucalyptus wood species. Eucalyptus species were planted in Tunisia in different arboreta throughout the country for close observation and adaptation to climate and soil. These fast-growing wood species were mainly used as fire wood, for the production of mine wood and to fight against the erosion. These tree species were adapted themselve...
S Ben Ayed, M T Elaieb, S Dumarçay, B De Freitas Homen De Faria, M-F Thévenon, P Gerardin, K Candelier
Chemical defense of trees and wood natural durability: from protection to valorization
2019 - IRG/WP 19-10943
Natural durability of wood is defined as “the inherent resistance of wood against various wood-destroying organisms” (European standard EN 350-1). This property is due in particular to heartwood extractives. However, the wood natural durability is included in a wider defense system, and other organs such as bark and roots also host protective compounds. Studying the mechanisms on which global ...
E Houel, D Stien, N Amusant
Determining the natural durability on xylarium samples: mini-block test, wood powder and chemical profiling
2019 - IRG/WP 19-10944
Xylaria, or wood collections, can be considered sleeping beauties in terms of wood technological and biological output. In this study we focus on determining the natural durability of xylarium specimens from the Federal Xylarium in the Royal Museum for Central Africa. The Federal Xylarium contains over 80,000 specimens, covering more than 13,000 species, mainly from Central Africa. These specimens...
V Deklerck, L De Ligne, J Van den Bulcke, E Espinoza, H Beeckman, J Van Acker
Wood natural durability an asset to the circular economy of wood industry: valorization of waste from sawmills for the cosmetics sector through the ValorExtr@ct project
2019 - IRG/WP 19-10954
The French Guiana ‘s forest is characterized by its incredible biodiversity; more than 1200 wood species have been listed to date. Some argue that this diversity would be linked to the hot, humid climate with no seasonal variation, which would be ideal conditions for the installation of a constant "arms race" between predators and prey. Thus, to cope with biotic and abiotic attacks, wood species...
N Amusant, J Passelande, D Fernand, J Beauchene, E Houel, M Royer
Performance of wood decking after 5 years of exposure: verification of the combined effect of wetting ability and durability
2019 - IRG/WP 19-20647
Wood is one of the most important construction materials and its use in building applications has further expanded in recent decades. In order to enable even more extensive and reliable use of wood, factors affecting wood’s service life need to be understood. More recently, a new concept to characterize the durability of wood-based materials and to predict the service lives of wood was proposed,...
M Humar, D Krzisnik, B Lesar, C Brischke
Durability by design – a case study of the performance of wooden decks after 9.5 years of natural weathering
2019 - IRG/WP 19-20648
The service life expected for wood decking manufactured with poorly durable wood species, left untreated and exposed to severe environmental conditions such as high humidity and active biological agents, is usually assumed to be short (less than 10 years). The current classification of wood’s natural durability is based on EN standardised tests which do not fully reflect the real end-use conditi...
M Kutnik, M Montibus