Your search resulted in 343 documents. Displaying 25 entries per page.
Effect of thickened boron in preventing conidial germination of sapwood-inhabiting fungi
1994 - IRG/WP 94-30059
We evaluated the efficacy of thickened boron preservative "Diffusolä" in preventing conidia germination of sapwood-inhabiting fungi using plate bioassay, Southern Yellow Pine and sweetgum block tests, and green pine log sections. The test fungi were sapstain fungi Ceratocystis coerulescens, Ceratocystis minor, and Aureobasidum pullulans and mold fungi, Aspergillus niger, Penicillium spp, and Tric...
S C Croan
BG- an easiest preservative paste and its effective diffusibility in timbers for indoors and outdoors uses
2001 - IRG/WP 01-30253
After application of a newly formulated paste "BG-1" on all surfaces of air-dried lumbers, the boron have been found diffused completely in permeable and impermeable hardwoods at the rate of 12 mm radial thickness per week. The new paste may be a solution to protect lumbers being used or to be used under cover where timber is susceptible to termite and borer attack. The new cost effective paste wa...
A K Lahiry
The efficacy of polymer/preservative treatments in soil-bed exposure
1992 - IRG/WP 92-3729
Southern pine was treated with CCA, CCB, sodium borax/boric acid, or disodiumoctaborate, alone or in combination with an acrylic polymer system containing a water repellent. Treated samples were subjected to an unsterile soil burial test. The addition of polymer reduced the weight loss in borontreated samples at the lower retentions but not at the higher retention. Results with borates indicate th...
R J Murphy, H M Barnes, S M Gray
Leaching of Boron - more than 3 years of field exposure
1997 - IRG/WP 97-30143
The diffusibility of Boron in wood and thus the ability of its leaching is known since long. Nevertheless quantitative data on this process are only rarely available. To overcome this lack of information field exposure tests were started with beam-segments treated with pure boric acid and poles treated with CCB. In addition some of the beam-segments were surface-treated with a varnish to investiga...
A Peylo, H Willeitner
Intrigue Dust - A new method of eradicating subterranean termite (Isoptera: Rhinotermitidae) colonies
2001 - IRG/WP 01-10396
Arsenic trioxide is used by pest controllers in Australia to eradicate subterranean termite colonies. In 2000 Bayer Australia introduced Intrigue Termite Dust as a more environmentally acceptable alternative. Intrigue, containing 80% triflumuron, a chitin synthesis inhibitor, disrupts the moulting process in termites. Dusted termites return to the nest and pass around triflumuron via mutual groomi...
W Madden
Dip diffusion treatments in the tropics. A preliminary report
1973 - IRG/WP 316
Diffusion treatments based on the use of boric acid alone or in combination with other preservatives are widely used in Australasia (see IRG/WP/310). As part of a general survey covering both temperate and tropical countries, a survey of diffusion treatments in South East Asia, Southern Asia and the South Pacific was carried out, and the results of this survey are reported here. The survey is far ...
C R Levy
Protection of rubberwood timber. Part 1: Impregnation with boron preservatives
1989 - IRG/WP 3551
Rubberwood (Hevea brasiliensis) were treated with a 3% proprietary mixture of borax/boric acid using three different treatment schedules i.e. full-cell, full-cell to refusal and full-cell with 12 cycles of vacuum/pressure. Freshly cut samples had mean preservative retentions of 187 kg/m³, 214 kg/m³ and 178 kg/m³ respectively. Pre-air dried samples for one week had retentions of 252 kg/m³, 308 ...
L T Hong, C C K Liew
Gaseous boron treatments of wood and wood products
1992 - IRG/WP 92-3691
Treatment of wood and wood products by gaseous organoborates has now been under study for about 5 years. This technique has potential for boron treatment of a wide range of substrates from solid wood through to wood composite materials such as particleboard or wet and dry formed fibreboards. The vapour treatment technique is proving to be very flexible in that it can be adapted to integrate into a...
A J Bergervoet, R Burton, K Nasheri, D R Page, P Vinden
Fire retardant treated wood and plywood: A comparative study
Part III. Combustion properties of treated wood and plywood
2002 - IRG/WP 02-40236
The fire retardant treated and untreated plywood and alder wood samples were prepared with the aim to investigate the effects of the way of treatment on the combustion properties. Alder wood was used for the preparation of plywood. Boric acid and borax were used as fire retardant. The plywood samples were impregnated by using three different methods; first group samples were impregnated by soaki...
S Çolak, A Temiz, Ü C Yildiz, G Çolakoglu
Fouling organisms as indicators of the environmental impact of marine preservative-treated wood
1995 - IRG/WP 95-50063
This study evaluates the use of fouling organisms (epibiota) to assess the environmental impact of preservative treated wood. This paper presents initial findings from treated panels exposed for 6 months at Sagres, Algarve, Portugal. Panels were treated with CCA, two copper-containing quaternary ammonium (ACQ) formulations and creosote, with nominal retentions from 10 to 40 kg/m³ (creosote 25 pcf...
R M Albuquerque, S M Cragg
Fouling assemblage development on copper-chromium-arsenic-treated timber submerged in European waters
2002 - IRG/WP 02-50181
The effect of the anti-marine-borer timber preservative CCA on community development of non-target marine fouling animals was investigated. Panels of Scots pine treated to target retentions of 12, 24 and 48 kg CCA per m3 of wood, plus untreated controls were submerged at seven coastal sites (Portsmouth, UK; La Tremblade (2 sites), France; Ria Formosa, Portugal; Sagres, Portugal; Kristineberg, Swed...
C Brown, R J Eaton, S M Cragg, P Goulletquer, A Nicolaidou, M J Bebianno, J Icely, G F Daniel, T Nilsson, A J Pitman, G Sawyer
Development of threshold values for boron compounds in above ground exposures: Preliminary trials
1998 - IRG/WP 98-30179
Boron is increasingly used both as an initial and remedial treatment for protecting wood against fungal and insect attack. While establishing lethal dosages for boron against insects through feeding tests is relatively simple, establishing thresholds for fungal attack poses more of a challenge. Tests using boron dispersed in agar artificially surround the fungus with both boron and excess nutrient...
J J Morrell, C M Freitag, S Unger
Performance of copper-chrome formulations in ground contact in five test sites in New Zealand
1996 - IRG/WP 96-30113
Copper-chrome-arsenate (CCA), copper-chrome-boron (CCB), copper-chrome-fluoride (CCF) and copper-chrome-phosphate (CCP) have been tested at four retentions each in ground contact (25 x 50 x 500 mm³ radiata pine sapwood stakes) for 16 years in five test sites in New Zealand. Results to date show that test site characteristics have a marked effect on relative performance. In a warm and wet site (an...
M E Hedley, R N Wakeling, J Foster, B E Patterson
Recovery of copper, chromium, and arsenic compounds from the waste preservative-treated wood
1991 - IRG/WP 3651
In Japan, about 40 percents of waste wood is incinerated and the residue is dumped into the landfill site. The waste preservative-treated wood, which is mixed in nontreated wood, is incinerated in the same way, too. However, it will cause the serious problems that the gases contained with high concentration arsenic compounds are discharged from the smokestacks of the incineration facilities and th...
A Honda, Y Kanjo, A Kimoto, K Koshii, S Kashiwazaki
Economical schedule for boron treatment of rubber wood: Pilot plant investigations
1993 - IRG/WP 93-40002
An economical treatment schedule (15 minutes initial vacuum of 85 kPa; 15 minutes pressure of 1000 kPa; 5 minutes final vacuum of 85 kPa) was arrived at for treating air-dried rubber wood (Hevea brasiliensis) in a pilot plant cylinder. Treating with 3% BAE (boric acid equivalent) solution resulted in a dry salt retention of 13.1 kg/m³. Also, the study showed that green rubber wood can be treated ...
R Gnanaharan, T K Dhamodaran
Effect of compression wood on leaching of chromium, copper, and arsenic from CCA-C treated red pine (Pinus resinosa Ait.)
2000 - IRG/WP 00-30232
In this study, the effect of compression wood formation on the release rate of chromium, copper, and arsenic elements from red pine (Pinus resinosa Ait) was investigated. Wood blocks from red pine containing compression and normal wood portions were treated with a 1.0% CCA-C solution and were then allowed to fix at 23 ± ??2°C (74 ± 4°F) for 0, 6, 24, 48, 96, 192, and 336 hours. After each fixa...
S N Kartal, S T Lebow
Bibliography on the use of boron compounds for the preservation of wood
1973 - IRG/WP 315
This bibliography is based on an earlier literature survey prepared by J. Thornton and Wm. E. Bruce (O.E.C.D. Document No. 27/DAS/CSI/M/91) which was enlarged and revised for a meeting in Paris in October 1968 (Document 27/DAS/CSI/M554) by Professor W. Bavendamm of Reinbek. The latter (1968) document with its 166 references has now been extended and brought up to date. Acknowledgments are due to B...
R Cockcroft, J F Levy
The content and mobility of copper, chromium and arsenic in the soil of a wood preserving plant using CCA
1998 - IRG/WP 98-50122
Analyses were carried out on soil and water samples obtained from a wood preserving plant using CCA-type preservatives. The plant has been in operation since 1969. The soil samples were obtained on 8 points from 4 different depths. The estimation of the type of soil was followed by investigations of copper, chromium and arsenic contents, and the mobility of these elements. The soil samples were al...
N Erdin, S N Kartal, A Dilek Dogu, M O Engür
Performance of groundline bandage remedial treatments in western US species transmission poles
1993 - IRG/WP 93-30019
Groundline bandages are an important element in remedial treatment strategies for utility poles in the United States. Several bandages containing new or reformulated components have recently been developed but have not been adequately tested. This paper reports on the degree of diffusion of copper naphthenate, boron, and sodium fluoride from groundline bandages into pressuretreated Douglas-fir, po...
P G Forsyth, J J Morrell
Comparison of the inhibitory effects of borate, germanate, tellurate, arsenite and arsenate on 6-phosphogluconate dehydrogenase
1991 - IRG/WP 1508
Sodium borate inhibits the enzymatic activity of many dehydrogenases, and it is thought that this is due to the complexation of the borate anion with the coenzyme nucleotide. It has been suggested in the past that complexation of this type, leading to enzyme inhibition and other biological effects, is responsible for the inhibition of fungal growth and consequently the protection of boron treated ...
J D Lloyd, D J Dickinson
The influence of drilling patterns on the distribution of toxicants from Polesaver Rods in hardwood poles
1994 - IRG/WP 94-30051
Polesaver Rods are solid rods of wood preservative that are used as a groundline maintenance treatment to control biodeterioration in hardwood transmission poles in Australia. The rods are inserted in holes that are drilled in a prescribed manner to distribute the toxicants into the critical groundline region of the poles. To determine the influence of drilling patterns on the distribution of toxi...
W D Gardner, C N McEvoy
Effect of treatment process on performance of copper-chrome-arsenate. Part 1: Fungus cellar tests
1995 - IRG/WP 95-40045
Pinus radiata sapwood stakes 20 x 20 x 400 mm³ were treated with CCA Type C using a range of concentrations and three treatment processes; Bethell, Lowry and Rueping. Preservative retention was determined by chemical analysis of treated material. Following fixation, fungus cellar stakelets, 5 x 10 x 180 mm³ were cut from treated material and after leaching were exposed in unsterile soil beds in ...
M E Hedley, J Anderson, J B Foster, B E Patterson
On the use of probit analysis for assessing the toxicity of wood preservatives
1974 - IRG/WP 244
To elucidate the general character of the action of the toxic material on the fungus, it is sufficient to carry out preservative tests using the previously described procedure, but in doing so, it is necessary somewhat to change the number of specimens and their arrangement in jars. Five concentrations of toxic material are tested simultaneously. For the testing of one preservative ten jars should...
D A Belenkov
Standard and accelerated testing of boron-additive wood protection systems
2005 - IRG/WP 05-30381
The main objective of this research was to determine the effectiveness of boron-additive protection systems for above ground applications by means of field testing. The two field test procedures used are based on the L-joint test described in the European standard EN 330. For the first set up the boron treated timber was coated in accordance with the standard EN 330 system. The second set up is ba...
A Mohareb, J Van Acker, M Stevens
The effect of acid rain on CCA treated timber
1990 - IRG/WP 3579
The effect of acid precipitation on the leaching of copper, chromium and arsenic from timber treated with different CCA preservatives was studied in the presence of three types of soil under simulated field conditions. Pine sapwood, embedded in soil, was subjected to simulated rainfall at three different levels of acidity. The CCA preservative formulations tested were:- American Wood Preservers&am...
R J Murphy, D J Dickinson