Your search resulted in 3170 documents. Displaying 25 entries per page.
Weathering of copper-amine treated wood
2000 - IRG/WP 00-40155
Copper ethanolamine (Cu-EA) treated southern pine (SP) were artificially weathered with a QUV Weathering Tester. The weathering regime was composed of a continuous UV-light irradiation for 2 hours followed by a water spray for 18 minutes for a total time of 1200 hours. The changes on the surface of the weathered samples were characterized by Fourier transform infrared spectroscopy (FTIR) analysis,...
J Zhang, D P Kamdem
New principles for the protection of wood: Impregnation with waterborne resins
1995 - IRG/WP 95-40047
The environmental impact of classical wood preservatives as well as the use of tropical wood species with high natural durability is regarded increasingly critically in the public. Therefore other partially new principles for the protection of wood, like chemical modification, or treatment with resins were examined especially in USA, Japan and in Europe with promising results predominantly in the ...
A O Rapp, R-D Peek
The effect of a chelator mediated fenton system on activation of TMP fibres and decolorization of synthesized dyes
2004 - IRG/WP 04-50223
The purpose of this work is to improve our current knowledge of the non-enzymatic mechanisms involved in the brown rot degradation of wood, but also to study the potential applications of a chelator-mediated Fenton system in activation of wood fibers and decolorization of synthesized dyes. In this work, Electron Spin Resonance (ESR) spin-trapping techniques were used to study the generation of hyd...
Yuhui Qian, B Goodell, J Jellison
Mercury porosimetric evaluation of the impregnability of wood
1985 - IRG/WP 2234
Mercury porosimetric measurements for specimens of a given length can not be used to evaluate the treatability of wood. The reason is that the permeability for low permeable woods deviates from Darcy's law with the specimen length. This paper presents a method of evaluation which respects this phenomenon in indicating not only pore size but also a factor describing the pore size as a func...
J P Hösli
Possibility and problems of characterizing treated wood after service with regard to disposal
1993 - IRG/WP 93-50006
For the disposal of wood waste under ecological conditions, information about its hazardous potential and the logistic aspects for its handling is needed. The main criterion to evaluate the hazardous potential besides the determination of the type and quantity of active ingredients in the wood will be the degree of mixture with different treated or untreated timber. Assortments can be homogeneous ...
A Voss, H Willeitner
Solid state NMR study on pine wood degraded by brown rot fungus Gloeophyllum trabeum
1994 - IRG/WP 94-10067
Blocks of Pinus koraiensis wood were degraded by Gloeophyllum trabeum and examined by solid-state 13C NMR spectroscopy. Chemical compositions were estimated from relative signal aras. There was no evidence for preferential degradation of the noncrystalline cellulose which accounted for about 4% by weight of the wood. Loss of partly ordered cellulose on crystal surfaces exceeded the loss of crystal...
Yoon Soo Kim, R Newman
New ways of chemical wood preservation
1997 - IRG/WP 97-40087
Synergistic effects pertaining to wood preservation have been investigated by combining different polymerizing agents with modifying chemicals, modifying chemicals with known preservatives and new types of preservative chemicals with each other. One of the investigated methods is the use of impregnating solutions based on furfuryl alcohol (produced from biomass), in which the chemicals polymerizes...
M Westin, T Nilsson, B Ohlsson, R Simonson
Hyphal tunnelling of belian (Eusideroxylon zwageri) wood cell walls
1996 - IRG/WP 96-10152
Belian (Eusideroxylon zwageri) is highly regarded among the naturally durable Malaysian hardwoods. Visual inspections at the groundline of belian transmission poles from Sarawak, Malaysia, showed only surface decay of wood after 20 years in service. The cause of decay in belian was investigated by light and transmission electron microscopy. Light microscopy of transverse sections of surface tissue...
A P Singh, A H H Wong
Penetration as Key Factor for Determining the Performance of Wood Preservatives
2004 - IRG/WP 04-20293
Stakes of Scots pine sapwood with a dimension of 4 x 4 x 75 cm³ were impregnated with preservatives containing 2 % of propiconazole which had passed the EN 113 test criteria without any problems. The
penetration of the colourless preservative was determined successfully by a fungal screening test described by Sutter (1978). The test revealed the insufficient penetration behaviour within the gi...
H Leithoff, I Stephan, R-D Peek
A possible role of unique TCA cycles in wood-rotting basidiomycetes
2003 - IRG/WP 03-10461
The copper tolerant brown-rot fungus, Fomitopsis palustris, acquires metabolic energy by use of the constitutively-occurring Kornberg’s glyoxylate cycle coordinating with oxalate biosynthesis and glucose oxidation (Erman Munir et al. Proc. Natl. Acad. Sci. USA, (2001) 98, 11126-11130). Furthermore, this fungus does not have the normal TCA cycle, lacking 2-oxoglutarate dehydrogenase which is a ke...
E Munir, T Hattori, M Shimada
Mobility of zinc borate wood composite preservative
1997 - IRG/WP 97-30153
Zinc borate (ZB) is being used as an antifungal and insecticidal wood preservative for flake/strand-based composites. Data is reported on the laboratory and field leaching behavior of ZB when contained in apen flake composites. In general, the performance results correlate with leaching hazard. Although the boron in ZB is more resistant to depletion than in sodium borates, the ZB boron will deplet...
P E Laks, M J Manning
In-house accelerated method for testing decay resistance of treated wood
2004 - IRG/WP 04-20286
Fungicidal compounds often change their effectiveness when they are incorporated into candidate formulations. For this reason fungistatic effectiveness needs to be re-evaluated as many times as the formula has been modified for better performance. To avoid multiple expenses, in-house fungistatic tests are essential. Our goal was to develop in-house usable, simple but reliable and reproductive proc...
N Vidovic
Evaluation of the natural durability and ultrasonic method for decay detection of some european hardwood and softwood species
2004 - IRG/WP 04-10537
This paper presents the first part of an investigation on the natural durability of mixed plywood made of durable and non durable plies from the following selected timbers : Cedrus atlantica, Cupressus sempervirens, Castanea sativa, Populus sp. I 214 and Fagus sylvatica.
In order to carry out this study, the natural durability of the massive wood used to manufacture the plywood panels was asses...
F Faraji, M-F Thévenon, B Thibaut
Effectiveness of wood preservatives by IUFRO's method
1984 - IRG/WP 3305
Pinus elliottii and Eucalyptus saligna stakes treated with 4.9; 6.9; 9.6 and 13.5 kg/m³ of CCA-A, CCA-C and CCB and with 30-50; 60-80; 90-110 and 120-140 kg/m³ of Benzotar and CNSL (cashew-nut shell liquid) were exposed in seven test sites in Sao Paulo State, Brazil. After 4 years it was concluded that the mean useful life of untreated Pinus elliottii stakes was 8 months and of untreated Eucalyp...
G A C Lopez, E S Lepage, O B Neto
The use of selective media for studying the colonization of wood in ground contact by microorganisms
1978 - IRG/WP 186
In October1976 a field trial was set up in order to monitor the progressive colonisation of wood in ground contact using orientated small stakes of Scots pine (Pinus sylvestris) and birch (Betula sp.) (30 x 45 x 250 mm³). Half the number of each species were treated with a 1% solution of CCA by a vacuum impregnation process. All the stakes were coated on three sides with an epoxy-resin sealant to...
C P Clubbe
Oxidation of wood components during CCA-C fixation
1993 - IRG/WP 93-30024
Pre-extracted radial sections of southern yellow pine sapwood were treated with CCA-C and analyzed by X-ray photoelectron spectroscopy (XPS). The ratio of C1 (carbon bonded to carbon and/or hydrogen) to C2 (carbon bonded to one oxygen) in XPS Cls spectra was taken as a measure of the progress of oxidation of wood components during CCA fixation. This ratio was 0.82 before CCA treatment and increase...
M Kaldas, P A Cooper
Rapid fixation of Chromated Copper Arsenate (CCA) wood preservatives by microwave treatment
2000 - IRG/WP 00-40184
Rapid microwave heating of freshly chromated copper arsenate (CCA) treated timber indicates that rapid preservative fixation is possible within approximately 40 seconds. The leaching of CCA was evaluated using simulated rainfall. Cost analyses indicates that microwave fixation using an on-line conveyor belt fixation process with an output of 4m3/hour using a microwave power supply of 230 kW costs ...
G Torgovnikov, P Vinden, E Mapanda, P R S Cobham
Preliminary testing of an improvised wood preservative mixture applied against dry wood beetles
1986 - IRG/WP 1308
An improvised wood preservative mixture was preliminarily tested in situ against some dry wood beetles which had infested structural timbers in a semi-finished building. The results obtained should encourage further research towards mobilizing/improvising locally available resources in the face of scarce standard wood preservatives, against the background of a dilemma in wood utilization in the de...
M O Akanbi, E M Bayode, A A Alabi, J Gbadebo
A voluntary system to control the usage of wood preservatives in Austria
1993 - IRG/WP 93-50001-28
In 1991, approximately 8000 tons of solvent based and 1000 tons of mostly chromium containing water based preservatives were sold on the market annually. Already in 1959 the Austrian Wood Preservative Examination Committee (AWPEC) was founded. From the beginning, the aim was to achieve a quality control system for wood preservatives to protect both the end user of preservatives and the environment...
R Gründlinger, H Hofer
Special seminar on screening techniques for potential wood preservative chemicals
1978 - IRG/WP 2113
This paper continues following issues:
I. SCREENING INSECTICIDES
1) R W Berry (BRE/PRL, UK): Screen testing of insecticides for use in remedial wood preservatives.
2) D J Cross (FRI, New Zealand): Rapid screening of contact insecticides for use on forest products.
3) C R Coggins; A Forsyth; A E Glaser (Rentokil, UK): Experience in the use of indicative screening techniques for termiticides.
...
Anonymous
Redox regulation of enzyme activity during wood decay
1996 - IRG/WP 96-10172
A potential strategy in the search for alternative wood preservatives against fungal decay is to target the extracellular wood-decay process itself, rather than the decay organisms. This presents novel targets for selective disruption and possibly without the broad-spectrum toxicity associated with conventional wood preservatives. The enzymes of white rot decay are mechanistically diverse (e.g. hy...
P J Kersten, B Kurek, J W Whittaker
IRG/COIPM INTERNATIONAL MARINE TEST - to determine the effect of timber substrate on the effectiveness of water-borne salt preservatives in sea-water. Progress Report 19: Report on the condition of specimens at Sekondi, Ghana after 42 months
1984 - IRG/WP 4109
The results of the first formal inspeation of CCA- and CCB- treated test panels exposed at Sekondi, Ghana, in June 1980, are presented. All untreated control panels of both reference and local species have been destroyed. Of the% CCA- treated specimens, only those of Pinus sylvestris (reference species) and Mitragyna stipulosa (local species) have not been attacked. 3% CCB-treated local species ha...
F F K Ampong
Microwave treatment to Accelerated fixation of copper-ethanolamine (Cu-EA) treated wood
2004 - IRG/WP 04-40271
This study evaluated the use of microwave post-treatment to accelerate fixation of copper-ethanolamine (Cu-EA) treated 19 mm southern yellow pine sapwood cubes. Cubes were pressure treated at 3.2 and 6.4 kg/m3 Cu retention target, after which they were microwave post treated during different duration periods. An accelerated AWPA leaching test was conducted during 300 hours to determine the amount...
Jinzhen Cao, D P Kamdem
Heat inactivation of mould fungi on wood
1993 - IRG/WP 93-40012
Heat treatments have been successfully used for eradication of dry rot. The effect of heat treatments at 40, 50 and 60°C for various time intervals on the inactivation of Penicillium brevicompactum was determined. The effect of heat on ungerminated spores and spores "pregerminated" for 24 hours was evaluated by plating on malt-extract agar. Although most ungerminated spores were inactivated after...
J Bjurman
Pole yield of some softwood and hardwood species grown in Bangladesh
1999 - IRG/WP 99-40143
Growth study on 9 timber species planted in Bangladesh soils revealed that 6 species fall under wooden electric pole yield group-A, produce 33% poles within 10 years, another 33% within 15 years and additional 33% within 20 years of rotation. Two species under yield group-B produce 33% poles within 15 years and another 33% within 20 years. One species under yield group-C produce at best 25% poles ...
A K Lahiry