Your search resulted in 1258 documents. Displaying 25 entries per page.
Long term marine performance of ACZA treated Hem fir in Krishnapatnam harbour, east coast of India
2006 - IRG/WP 06-30409
The performance of Hem fir (Tsuga heterophylla) and Southern pine (Pinus sp.) treated with ammoniacal copper zinc arsenate (ACZA) and copper dimethyldithio carbamate (CDDC) at two retention levels of each preservative was assessed in tropical marine waters at Krishnapatnam harbour on the east coast of India. Panels treated with ACZA of lower loadings (23.1 Kg/m3) had failed in 38 months while the ...
B Tarakanadha, K S Rao, J J Morrell
Improvement of Grevillea robusta durability using heat treatment
2006 - IRG/WP 06-40333
Heat treatment of Grevillea robusta was carried-out under inert conditions to improve its durability. Resistance of heat treated samples was evaluated by malt agar block tests after three months of exposure to several wood rotting fungi. Results showed that the fungal durability was greatly improved after treatment. There was a good correlation between fungal resistance and mass loss which is a fa...
F Mburu, S Dumarçay, F Huber, M Petrissans, P Gérardin
Copper borate for the protection of engineered wood products
2006 - IRG/WP 06-40334
Copper borate was evaluated for use in protecting oriented strand board (OSB) from mould, decay, and termites. Aspen OSB bonded with either phenolic or isocyanate resin was treated with several formulations of copper borate at various loadings from 0.26 to 4 percent by weight. These panels were then tested to determine the impact of the preservative on mechanical properties as well as resistance ...
R Smart, W Wall
CCB Preservative treatment of split muli (Melocanna baccifera ) bamboo by soaking process
2006 - IRG/WP 06-40336
This study was carried out in order to investigate the retention of chemicals inside the split muli ( Melocanna baccifera ) bamboo after preservative treatment by soaking process. Treatment with 10% aqueous solution of CCB (copper-chrome-boron) was applied in split bamboo of two sizes (1/4 part and 1/8 part) at three different moisture contents and five time periods (24, 48, 72, 96, 120 hours). It...
K Akhter, M H Chowdhury
Effect of fumigation with Sulfuryl Difluoride on wood inhabiting fungi, a laboratory test
2006 - IRG/WP 06-30410
Special methods are necessary for the control of wood destroying organisms in the preservation of monuments and historic buildings because of the conservation of their originality and uniqueness.
The control of wood destroying organisms can be realized with conventional liquid wood preservatives or alternative methods. One of these methods is the fumigation. One fumigant, which was in the past of...
A Pfeffer, W Unger, G Fröba, G Binker
Ionic liquids with organic and inorganic anions as highly active wood preservatives
2006 - IRG/WP 06-30411
Quaternary ammonium tetrafluoroborates, nitrates(V), propionates, acetates and formates with alkoxymethyl substituents were prepared and tested on wood destroying and sapstaining fungi. These new compounds are ionic liquids (ILs), which penetrate very well into Scot pine wood. Alkoxymethyldecyldimethylammonium tetrafluoroborates and nitrates(V) show better microbial activity against Coniophor...
J Zabielska-Matejuk, A Skrzypczak
Non-pressure preservation technique of five less durable timber species – Kadam (Anthocephalus cadamba), Shimul (Bombax ceiba), Pithalu (Trewia nudiflora), Am (Mangifera indica) and Boroi (Ziziphus jujube) of Bangladesh
2006 - IRG/WP 06-40322
Wood is a versatile renewable resource, which has been extensively used as a reliable construction material as well in furniture ever since the beginning of civilization.
The Major disadvantage of wood is its susceptibility to biodeterioration by fungi, insects and bacteria. In tropical countries like Bangladesh, fungi is the most significant of these biodeterioration agents. Kadam (Anthocephalus...
G N M Ilias, A H Kabir, F Begum, M F Alam
The Effect of Wick Action upon Moisture Distribution in Ellagate Treated Pinus radiata Wood
2006 - IRG/WP 06-40328
Sapwood stakes of Pinus radiata D. Don were treated with water-soluble tetraguanidinium, tetracholine and tetrakis-benzyltrimethylammonium ellagates. The effect of these treatments upon moisture distribution was investigated by wick action. Given that chemical reactions within the wood substrate between nutrients and treatment solutions may alter the properties of the wood with regard to moistur...
S R Przewloka, B J Shearer, J A Hann
Corrosiveness of metal by copper-based preservatives
2006 - IRG/WP 06-40329
The corrosive rates of 4 types of metal as well as epoxy-coated metal by a variety of preservatives derived from different copper source and ingredients were conducted in this paper. The main results shown that: CCA is less corrosive to red brass and Q235A steel than other copper formulations; Copper-based preservatives such as ACQ and copper azole derived from basic cupric carbonate or cupric hyd...
Ying Zhang, Mingliang Jiang
Beetle-Fungus Associations in Woody Substrates in the Context of International Trade
2007 - IRG/WP 07-10610
Interest in the role of insects in transmitting various fungi and in the potential for outbreaks of insects vectoring plant disease organisms has resulted in a large volume of literature on insect-fungi relationships. Mites are mentioned as an important third partner in these associations. This paper summarizes information and provides an update on major aspects of these intricate associations in ...
A Uzunovic
Wood-Plastic Composites and the Durability Dilemma: Observations from the Field
2006 - IRG/WP 06-40351
Wood-Plastic Composites (WPCs) used for decking, window & door moldings have experienced dramatic growth in North America over the last several years, with annual production increasing at rates greater than 20% per annum since 1998. A key factor contributing to this growth has been the successfully communicated message that they are "virtually maintenance free". The common perception being t...
M J Manning, F M Ascherl, M E Mankowski
Resistance of DMDHEU-treated pine wood against termite and fungi attack in field testing according to EN 252. Results after 30 months
2006 - IRG/WP 06-40354
The aim of this study was to determine the effectiveness against decay and termite attack of pine sapwood treated with pure and modified DMDHEU in a field test according to European Standard EN 252. Some of the treatments tested were able to increase, within the period of the test reported (30 months), the resistance of the wood both to micro-organisms and termites. The curing process seems to be ...
S Schaffert, L Nunes, A Krause, H Militz
Leaching of CCA from Paraserianthus falcataria panels exposed to field conditions at Krishnapatnam harbour, Andhra Pradesh
2006 - IRG/WP 06-50241
This study assessed the leaching of copper, chrome and arsenic (CCA) from Paraserianthus falcataria (=Albizia falcataria) panels exposed to marine condition at Krishnapatnam harbour on the east coast of India. Metal loss was assessed in test panels after 6, 12, 24 and 36 months of exposure using Atomic Absorption spectrophotometer (AAS). The metal loss was found slightly higher in panels treated ...
B Tarakanadha, K S Rao
On the reasons of Prunus africana natural durability
2007 - IRG/WP 07-10611
Analysis of Prunus africana heartwood extractives was studied with the aim of understanding the reasons for its high natural durability. Soxhlet extractions of wood powder using different solvents were carried out. Effect of each extracts at different concentrations was evaluated on the growth of several fungi among which Coriolus versicolor, Poria placenta, and Aureobasidium pullulans. Results sh...
F Mburu, S Dumarçay, M F Thévenon, P Gérardin
An Investigation of the use and Durability of some Industrial and Domestic woods of Iran against Destructives factor in Caspian Sea
2007 - IRG/WP 07-10613
Use of domestic and commercial woods of the Caspian Sea forest fringes and evaluation of their durability against marine destructive factors were investigated. The samples of species of elm (Zelkova carpinifolia), oak (Quercus castanifolia), beech (Fagus orientalis), Maple (Acer insgin), Alder (Alnus subcordata), and horn beech (Carpinus betulus) were impregnated with CCA (Chrome–Cupper-Arsenic)...
S M Kazemi
Wood decay fungi from New Zealand ‘leaky’ buildings: PCR identification and laboratory decay tests of wood preservative-treated Pinus radiata (Part 1)
2007 - IRG/WP 07-10620
Fungi colonising Pinus radiata D. Don framing timber of ‘leaky’ New Zealand buildings were isolated to produce pure cultures. Mycelia from these cultures on agar media were collected to extract DNA. To identify the fungi to the species level, polymerase chain reaction (PCR) with primer pairs ITS1-F and ITS4 were performed followed by sequencing of the internal transcribed spacer (ITS) region. ...
D Stahlhut, R L Farrell, R Wakeling, M Hedley
Detecting fungal DNA in treated and non-treated wood
2007 - IRG/WP 07-10621
Isolating fungi from wood has long involved culturing on selective media followed by identification using various keys. This process can be cumbersome, costly, and, most importantly, not always capable of detecting all of the fungi present. The recent development of molecular methods for isolation and identification of fungi has created tremendous opportunities for expanding our knowledge of the...
C Freitag, M Freitag, J Morrell
The use of X-ray diffraction for analyzing biomodification of crystalline cellulose by wood decay fungi
2007 - IRG/WP 07-10622
X-ray diffraction (XRD) is based on the creation of an interference pattern by x-rays when they encounter a regularly spaced matrix. In wood, this process has been used to determine, among other things, the average width of the cellulose microcrystals, the percent of crystalline cellulose within the wood, and can be used to examine the changes in these parameters during degradation. Enhanced under...
C Howell, A C Steenkjær Hastrup, J Jellison
Effect of chitosan on the morphology and ultrastructure of two wood inhabiting fungi
2007 - IRG/WP 07-10606
An investigation was undertaken to compare the antifungal effects caused by chitosan against two selected wood degrading fungi Sphaeropsis sapinea and Trichoderma harzianum on their growth, morphological and ultra-structural characteristics, using differential interference microscopy, epifluorescence microscopy and transmission electron microscopy.
The effect of chitosan on fungal morphology was ...
T Singh, A P Singh, G Daniel
Corrosion of metal fasteners in contact with copper preservative treated wood
2007 - IRG/WP 07-20370
The corrosion rates of metal fasteners in contact with alkaline copper quat (ACQ) treated wood with or without commercially available water repellent was compared to that of cedar. In this experiment, fasteners were sandwiched between two pieces of treated wood and exposed to a humid environment at a slightly elevated temperature. The use of a “sandwich” design allowed periodic examination of ...
BaekYong Choi, J N R Ruddick
Use of the Digital Refractometer for the On-site Analysis of Copper-based Preservative Systems
2007 - IRG/WP 07-20371
In some counties, there are no on-site chemical analysis methods available for treatment plants to use to determine the key active ingredients in the preservative treatment solutions. The complexity of the sophisticated methodology; cost of analytical instruments and training required for operating these instruments in treating plant level are the reasons for lacking such practice. In this paper...
L Jin, T Cashman, A Preston, J Trompetter, H Trompetter
Growth and succession of mould on commercial paint systems in two field sites
2007 - IRG/WP 07-30421
Discolouring fungi reduce the service life of coated wooden claddings in façades and increase the total cost of ownership due to shorter maintenance intervals. It is of major importance to find paint systems for wood which are durable and have a high resistance to mould growth. A total of 15 paint systems from 9 different manufacturers were exposed on two field sites, Sørkedalen and Birkenes, ...
L Ross Gobakken, K M Jenssen
Study of natural durability of Spanish Eucalyptus globulus wood
2007 - IRG/WP 07-10617
In some countries such as Australia, the wood of Eucalyptus globulus is recommended, due to its high durability, in risk situations where attack by organisms is likely to occur. In Galicia this species has been used for many decades for timber structures, which are still used. However, European Standard EN-350-2 places Eucalyptus globulus in the worst category of natural durability, a situation th...
D Lorenzo, M T Troya, M J Prieto, C Baso, M Touza
Chelator-Mediated Fenton Chemistry in Wood Degraded by Fungi
2007 - IRG/WP 07-10618
Wood specimens were colonized by individual isolates of brown rot, white rot, soft rot and blue (sap) stain fungi. Ethyl acetate extracts of the ground wood were analyzed for their iron-reducing capabilities using a ferrozine-based assay. Extracts from wood colonized by brown rot fungi showed a significantly greater iron-reducing capability than extracts from wood colonized by white rot fungi or n...
B Goodell, G Daniel, J Jellison, Yuhui Qian
Potentiality of use extracts from Tetraclinis articulata like biocide against wood destroying organisms: Reticulitermes santonensis
2007 - IRG/WP 07-30418
Screening trials were conducted to determine the antitermitic and antifungal properties of essential oil and methanolic extractives obtained from Tetraclinis articulata heartwood. Extract-treated cellulose pads were used to evaluate antitermitic activity and complete termite mortality was obtained with the essential oil: the threshold is situated under 5% (v/v). Standardised tests according Europe...
F El hanbali, N Amusant, F Mellouki, M Akssira, C Baudasse