Your search resulted in 248 documents. Displaying 25 entries per page.
FTIR analysis of wood blocks decayed by brown-rot fungi
2020 - IRG/WP 20-10959
Calibration curves of the relative lignin contents in Cryptomeria japonica decayed by brown-rot fungi were developed with Infrared Spectroscopy and Klason technique. First, wood decay test was conducted using brown-rot fungi (Fomitopsis palusris, F. pinicola, Wolfiporia cocos, Gloeophyllum trabeum, and Neolentinus suffrutescens) and white-rot fungus (Trametes versicolor) was used as a comparison. ...
R Kondo, Y Horikawa, R Kose, M Yoshida
Moisture and temperature conditions in an old, highly moisture-loaded timber building in the Røros municipality, Norway
2020 - IRG/WP 20-10966
A 150 years old log building near Røros, Norway, has been in active use as a cowshed since its erection. The animals are kept inside the cowshed all winter and this causes a situation of a high moisture load on the wooden floor, wooden walls and ceiling. Logging of temperature and humidity over one year shows that there are favourable levels of moisture in the wood and air for development of moul...
M Sand Austigard, J Mattsson
Profiling fungal degradation of Scots pine sapwood by short wave infrared hyperspectral image analysis
2020 - IRG/WP 20-20667
Hyperspectral image analysis of Scots pine sapwood wood affected by decay fungi has been carried out as part of a Ph.D. thesis within the project Remote Inspection of Wooden Utility Poles (RIWUP).
In a lab experiment, Petri-dishes with Scots pine sapwood samples on malt agar medium were infected with two types of decay fungi, a brown rot and a white rot. The wood samples were scanned with a HySpe...
A Jochemsen, G Alfredsen, I Burud
Studying amount, location and state of water in modified wood at moisture levels relevant for fungal degradation
2020 - IRG/WP 20-40889
Water is an essential parameter for fungal degradation of wood, but degradation primarily occurs at high moisture levels at water potential in the range of -4 to -0.1 MPa, which corresponds to 97-99.9% relative humidity. At these moisture levels, water is present in the wood structure both in and outside of cell walls. The majority of previous studies on the interaction between wood and water for ...
M Fredriksson, E Engelund Thybring, Ramunas Digaitis
Macro biological degradation of wood treated with sorbitol and citric acid – first results from marine environment and termite exposure
2020 - IRG/WP 20-40901
Most European wood species are rapidly and severely degraded in termite-infested areas and the marine environment. There is a need for new solutions, especially in the marine environment, since we lack wood preservatives approved for marine applications in Europe. Several wood modification systems show high resistance against both marine borers and subterranean termites. However, the existing comm...
A Treu, L Nunes, E Larnøy
The iron reduction by chemical components of wood blocks decayed by wood rotting fungi
2021 - IRG/WP 21-10979
Brown-rot fungi, a group of wood rotting fungi, is well known to be one of major microorganisms that cause the deterioration of wooden buildings in Japan and have been considered to use chelator-mediated Fenton (CMF) reaction in concert with hydrolytic and redox enzymes for degradation of wood cell wall. CMF can be described as a non-enzymatic degradation system that utilizes hydroxyl radicals pro...
R R Kondo, Y Horikawa, K Ando, B Goodell, M Yoshida
Decay capacity and degradation patterns of Xylaria hypoxylon on different wood species
2022 - IRG/WP 22-10985
A host of physical and environmental factors may influence fungal decay including the wood substrate, temperature, moisture, oxygen, light, pH, and nitrogen. Understanding the effects of these factors on fungal decay is important for the effective utilization of wood decay fungi in biotechnological processes and for understanding the role of these organisms in global carbon cycling. The ascomycete...
E Bari, G Daniel, A Singh, J J Morrell
Performance of wood exterior structures above ground in Spain. Performance and durability of a shelter of spruce in a shopping centre after 20 years
2022 - IRG/WP 22-20680
Across Europe is very common to find wood exterior structures mainly build in sawn and glue-laminated wood. Most of these exterior wood structures use softwood wood species such as: fir, spruce, pine or douglas. In Spain exterior wood structures, became more and more popular since nineties, when sawn and glue-laminated wood were utilized for building exterior wood structures in overall Spain. In m...
D Lorenzo, A Lozano, M Alonso, J Fernández-Golfín, M Touza, J Benito
Combining MRI and X-ray CT to monitor fungal decay of plywood and OSB in a lab test
2022 - IRG/WP 22-20683
Bio-based building materials, such as wood and wood-engineered products, are susceptible to degradation by decay fungi. In-depth knowledge on the intricate material-fungus relationship as well as performance data for many bio-based building materials are still lacking, and especially knowledge on how a material’s structure and moisture properties affect the degradation process is missing. Althou...
L De Ligne, T Núñez Guitar, C Vanhove, J Van Acker, J Van den Bulcke
Role of microbiota in wood degradation by Reticulitermes grassei and Bursaphelenchus xylophilus
2022 - IRG/WP 22-20684
Xylophagous organisms can cause damage both in forests and in felled wood. Bursaphelenchus xylophilus, which causes "Sudden Pine Wilting" in coniferous forest masses, and is currently considered a quarantine organism in the European Union. On the other hand, structural and carpentry wood is affected by subterranean termites (Reticulitermes spp.), that cause serious damage, both in buildings and fu...
L Robertson, S Rames, M Uriel, J M González, F Llinares, S M Santos, M T Troya
Wood Protection Using Nano Metal Oxides in Propylene Glycol
2022 - IRG/WP 22-30760
Metals and metal oxides are known to have properties that can protect wood from degradation. Nanoparticles, due to its unique physical and chemical properties can enhance the protection to a much greater extent. Major constraints in dealing with nanoparticle dispersion can only be resolved by identifying a proper dispersive medium. Studies were carried out by preparing nanodispersion of four metal...
S Nair, G B Nagarajappa, K K Pandey
Chemical modification of cellulose nanofibrils for tailoring properties of composites
2022 - IRG/WP 22-40934
Due to its natural abundance, complete biodegradability and excellent properties, cellulose is one of the most promising materials for the production of bio composites, as well as one of the most promising fillers for biodegradable polymer composites. This is also true for nanocellulose. A large number of hydroxyl groups on the surface of fibers or fibrils enables a whole series of chemical reacti...
I Poljanšek, J Levanič, V Ž Bogataj, V Vek, P Oven
Biocomposites based on PVA, cellulose nanofibrils and tannic acid
2022 - IRG/WP 22-40957
Biocomposite films based on a polyvinyl alcohol (PVA) with the addition of cellulose nanofibrils (CNF) as a reinforcing component and with the addition of the biologically active tannic acid (TA) were prepared. The influence of different additions of CNF and TA in the polymer matrix PVA on the mechanical properties, improvement of hydrophobicity of the prepared films was studied. In all cases, the...
U Osolnik, V Vek, I Poljanšek, Poven
Metabolite analysis of fungal COS degradation and phylogenetic investigation of COSase genes
2023 - IRG/WP 23-11018
Fungi are the major species causing microbial deterioration that reduces the commercial value of wood, such as wood decay and surface contamination, so it is important to accumulate knowledge on the physiology of fungi in order to develop countermeasures against these problems. Most physiological studies of fungi that have been reported have concerned the metabolism of carbohydrates as a source of...
R Iizuka, S Hattori, I Ohtsu, D Hibbett, Y Katayama, M Yoshida
A novel cellulose-binding domain from the brown-rot fungus Gloeophyllum trabeum
2023 - IRG/WP 23-11019
Wood-rotting basidiomycetes are the major organisms decomposing wood in nature. They are classified into two groups based on their decay modes; white-rot fungi and brown-rot fungi. White-rot fungi secrete various cellulolytic enzymes during the wood degradation process. The enzymes are known to be often appended with a cellulose binding domain (CBD) which assists the activity of catalytic domain. ...
Y Kojima, N Sunagawa, M Aoki, M Wada, K Igarashi, M Yoshida
The cellulose binding mechanism of a novel cellulose binding domain from the brown-rot fungus Gloeophyllum trabeum
2023 - IRG/WP 23-11021
In nature, wood decay is caused by various wood-rotting basidiomycetes. Wood-rotting basidiomycete are mainly divided into white-rot fungi and brown-rot fungi. Their main carbon source is cellulose of the wood cell wall during wood decay, and they produce a variety of enzymes to decompose cellulose. The cellulolytic enzymes often possess a cellulose binding domain (CBD) as an additional domain con...
M Aoki, Y Kojima, M Wada, M Yoshida
Mini-stakes – an alternative test method for EN 252?
2023 - IRG/WP 23-20691
Market approval of wood treatment products requires knowledge and prove of long-term durability. Efficiency of wood treatment with a specific product is evaluated based on variety of tests, including penetration evaluation, leaching studies as well as decay tests. EN 252 standard test is a core method for wood durability evaluation in a ground contact, both for commercial product approval and scie...
R Digaitis, P Larsson Brelid, N Terziev, M Klamer, A W Christof, J Stenaek, N Morsing
UV protection and dimensional stability of lignin-based wood treatments
2023 - IRG/WP 23-40979
New developments in the field of wood modification aim to enhance the intrinsic properties of natural timber. The limitation of wood should be preferably achieved with biobased ingredients and efficient, eco-friendly treatments possessing low environmental impact. Consequently, new solutions assuring expected properties and functionality over elongated service life and reducing the risk of product...
R Herrera,O Gordobil, F Poohphajai, A Sandak
Research on gaseous COS degradation by brown-rot fungus Gloeophyllum trabeum
2024 - IRG/WP 24-11033
Physiological studies of wood rotting fungi have mostly focused on the metabolism of carbon and nitrogen sources, which constitute the dominants components of wood. On the other hand, despite the physiological importance of trace elements such as sulfur, studies on their acquisition sources and metabolic pathways are limited. Until now, wood rotting fungi have been thought to utilize slight amount...
R Iizuka, R Tsukida, Y Katayama, M Yoshida
Cellulose nanomaterials in growth media for wood decay fungi
2024 - IRG/WP 24-11035
Cellulose nanofibrils (CNFs) were investigated as a partial substitution for agar in growth media for wood decay fungi. Radial growth measurements of eight basidiomycete fungi were taken on solid growth media with and without CNFs. Additionally, fungal strain virulence was evaluated using the European CSN Standard EN 113-2 wood decay durability test. The inclusion of CNFs did not significantly aff...
K M Ohno, R A Arango, R Sabo, C M Clemons, G T Kirker, A B Bishell
Cellulose nanomaterials in growth media for wood decay fungi
2024 - IRG/WP 24-11035
Cellulose nanofibrils (CNFs) were investigated as a partial substitution for agar in growth media for wood decay fungi. Radial growth measurements of eight basidiomycete fungi were taken on solid growth media with and without CNFs. Additionally, fungal strain virulence was evaluated using the European CSN Standard EN 113-2 wood decay durability test. The inclusion of CNFs did not significantly aff...
K M Ohno, R A Arango, R Sabo, C M Clemons, G T Kirker, A B Bishell
A novel cellulose-binding domain from the brown-rot fungus that can be used to evaluate cellulose in wood
2024 - IRG/WP 24-11046
Wood-rotting basidiomycetes are the primary microorganisms that decay wood in nature. They are classified as white-rot fungi and brown-rot fungi by the difference in decaying types. White-rot fungi secrete a variety of cellulolytic enzymes during wood degradation. These enzymes often have an additional cellulose-binding domain (CBD) that adsorbs to the cellulose surface and localizes the catalytic...
Y Kojima, N Sunagawa, S Tagawa, T Hatano, S Nakaba, M Aoki, M Wada, K Igarashi, M Yoshida
Binder-free, fire-resistant, light-weight fiberboard materials encrusted with expandable graphite and borax
2024 - IRG/WP 24-20714
Despite abundant data on innovative fire protection technologies tailored for wood and lignocellulosic materials, the prevailing approach revolves around the formulation of fire retardant solutions employing water-soluble salts, e.g., phosphorus or boron compounds. On the other hand, additives fostering the formation of a char layer during the combustion of lignocellulosic materials as a non-leach...
W Perdoch, W Grześkowiak, B Mazela