Your search resulted in 672 documents. Displaying 25 entries per page.
A Green and Novel Technology for Recovering Copper and Wood from Treated Waste - Part I
2015 - IRG/WP 15-50309
Preservative treatment of wood extends its service life. The US consumes about 70 million pounds of copper and produces about 7 billion board feet of treated wood annually. Burning and reusing CCA and copper treated wood wastes are disallowed by US EPA due to health and environmental concerns. Millions of pounds of copper and wood are disposed by landfill annually. The objective of this study was...
S Chen
Environmental Fate of Micronized Copper
2015 - IRG/WP 15-50310
The environmental fate of wood preservatives is an important aspect to estimate the health and environmental impact. Although biocides from treated wood may be released into the soil, water or air, the latter pathway is frequently neglected in favour of leaching studies. Nonetheless, wood dust is well known to cause a variety of adverse health effects, in particular diseases to the respiratory tra...
C Civardi, L Schlagenhauf, J Benz, C Hirsch, J Van den Bulcke, M Schubert, J Van Acker, P Wick,
Recycling of used railroad ties via two-staged pyrolysis for fractionation of wood preservatives and bio-oil: pyrolytic characterization by TGA and Py-GC/MS
2015 - IRG/WP 15-50311
Creosote and copper naphthenate (CuNap) (in an oil carrier) treated railroad tie materials (crossties or sleepers) were initially heat-treated at 200 – 300 oC and subsequently pyrolyzed via thermogravimetric analysis (TGA) and pyrolysis-gas chromatography/mass spectrometry (Py-GC/MS) to recover wood preservatives and produce a higher quality bio-oil. Preservative-desorptive temperatures at 200 a...
Pyoungchung Kim, J Lloyd, Jae-Woo Kim, N Labbe
Effect of exposure site on metal migration from copper azole, alkaline copper quat or chromated copper arsenate treated southern pine decking
2015 - IRG/WP 15-50313
Metal migration from chromated copper arsenate, copper azole or alkaline copper quaternary compound treated southern pine lumber was assessed at sites in Mississippi and Oregon. Metal levels tended to be consistently higher in decks exposed in Mississippi. Rainfall characteristics did differ slightly at the two sites, but the levels did not appear to be of a magnitude that might affect metal mobi...
J J Morrell, H M Barnes
Above-ground performance of a buffered amine oxide treatment system against Mastotermes darwiniensis
2016 - IRG/WP 16-10855
Above-ground H2 field tests against Mastotermes darwiniensis were conducted in far north Queensland to assess the efficacy of buffered amine oxide treatments in the softwoods Pinus sylvestris and P. radiata, and the hardwoods Eucalyptus regnans and E. diversicolor. Untreated hardwoods and slash pine bait wood (P. elliottii) were severely attacked or destroyed, while untreated P. sylvestris was mod...
L J Cookson, R W Clawson Jr
The copper-transporting ATPase pump and its potential role in copper-tolerance
2016 - IRG/WP 16-10859
Copper-tolerant brown-rot decay fungi exploit intricate mechanisms to neutralize the efficacy of copper-containing preservative formulations. The production and accumulation of oxalate is the most widely recognized theory regarding the mechanism of copper-tolerance in these fungi. The role of oxalate, however, may be only one part of a series of necessary components required for this complex mecha...
K M Ohno, C A Clausen, F Green III, G Stanosz
Release of Copper from Pressure Treated Wood
2016 - IRG/WP 16-20584
Micronized copper based wood preservatives including micronized copper quat (MCQ) and micronized copper azole (MCA) have been introduced commercially to the North American market since 2006 as alternatives to alkaline copper quat (ACQ) or soluble copper azole (CA) preservatives. Unlike ACQ or CA, MCQ and MCA use dispersed particulate copper particles rather than soluble ionic copper to make treat...
Jun Zhang, J Horton
Performance of copper treated poles and posts after three to fifteen years of exposure
2016 - IRG/WP 16-20595
Copper based wood preservatives are one of the most important wood preservatives for heavy-duty applications. Wood treated with copper-based preservatives performs excellent if applied according to preservative specifications. If used improperly premature failures might appear. In order to elucidate properties of copper treated wood in use, utility poles and posts treated with copper-based preserv...
M Humar, N Thaler
Moisture monitoring in WW2 partisan hospital Franja
2016 - IRG/WP 16-20596
Material climate of wood used for construction of WW2 Partisan hospital Franja was monitored for approximately one year. Partisan hospital is located in the bottom of tiny gorge Pasice in Slovenia. Hence, wood moisture content on eight respective location and wood temperature was determined twice per day with Scanntronik equipment Gigamodul and Thermofox. The results clearly showed that despite of...
M Humar, N Thaler, B Lesar, A Žagar
Evidence for a role for precipitated copper on the chemistry of micronized copper treatments
2016 - IRG/WP 16-30690
Micronized copper preservative treatments of softwoods, result in mobile copper being formed by reaction of the basic copper carbonate (BCC) with the carboxylic acid functional groups in hemicellulose and pectic substances present in wood. Typically, the amount of reacted copper formed is approximately 0.3% Cu m/m. In this paper, two examples are discussed where remaining unreacted basic copper ca...
Wei Xue, P Kennepohl, J N R Ruddick
The termite resistance of wood impregnated with nano-zinc oxide and nano-zinc borate dispersions
2016 - IRG/WP 16-30691
In this work, the effects of the impregnation with nano-ZnO and nano-ZnB dispersions on the termite resistance of European beech wood were investigated. Three different concentrations (namely 0.5%, 1% and 2%) of the above two materials were tested. Water leaching effect was also investigated. It was concluded that a severe effect in terms of termite workers mortality is induced by the use of both ...
C Lykidis, T de Troya, M Conde, J Galván, G Mantanis
Incorporation of raw boron minerals to protect particleboard against decay and mold fungi, termites and insects
2016 - IRG/WP 16-40729
This paper evaluated the biological performance of particleboards incorporated with the raw boron minerals ulexite and colemanite against decay, mold fungi, termites and insect larvae in comparison with that of particleboards with zinc borate, or boric acid plus a borax mixture. The results showed that ulexite and colemanite were highly effective against the decay fungi and termite attack in labor...
S N Kartal, E Terzi, P Gerardin, C M Ibanez, T Yoshimura
Development of a new method for wood hydrophobizing and fixation of copper compounds by chemical hardening of vegetable based modified oils
2016 - IRG/WP 16-40754
Wood products with ground and direct water contact, but without sufficient biological durability, have to be protected against biological degradation by fungi and other microorganisms. Due to European legislation (Biocidal Products Regulation 528/2012), the selection of possible chemical agents, which are still allowed to be used, is diminishing rapidly. The use of previously widely applied, very ...
C Swaboda, M Fischer, K Jacobs
A Treatability Study of Western Wood Species with Water Based Azoles and Insecticides Using Buffered Amine Oxides
2016 - IRG/WP 16-40766
The use of Western U.S. Wood Species remains small in today’s global wood product market when compared to the use of other commercially available softwoods. One reason that other fiber sources, those that may be less naturally durable or exhibit slightly inferior mechanical properties, are utilized is ease of treatment. In an attempt to ensure adequate penetration in commercially important an...
R W Clawson Jr, C N Cheeks, K A Cutler
Untreated and copper-treated wood soaked in sodium oxalate: Effects of decay by copper-tolerant and copper-sensitive fungi
2017 - IRG/WP 17-10888
Copper is widely used as the primary component in wood protectants because it demonstrates a broad range of biocidal properties. However, a key concern with using copper in wood preservative formulations is the possibility for brown-rot basidiomycetes to resist the toxic effect. Many brown-rot basidiomycetes have evolved mechanisms, like the production and accumulation of oxalate, which helps thes...
K M Ohno, G T Kirker, A B Bishell, C A Clausen
Overview of the treated wood quality control program in the United States with the recent challenges and advances
2017 - IRG/WP 17-20616
In the past two decades, there have been significant and rapid changes in wood protection technologies for residential applications which have moved away from long established heavy duty metal oxide based products such as chromated copper arsenate (CCA). The successor generation of wood protection systems usually contain copper as the primary biocide, in combination with carbon-based co-biocides s...
L Jin
Activity of Two Strobilurin Fungicides Against Three Species of Decay Fungi in Agar Plate Tests
2017 - IRG/WP 17-30704
The objective of this study was to examine the toxicity of strobilurin fungicides against wood decay fungi in order to assess their potential to act as a co-biocide for copper-based wood protection. Two strobilurin fungicides, Heritage (50% azoxystrobin active ingredient) and Insignia (20% pyraclostrobin active ingredients), and copper sulfate pentahydrate were tested against one white rot fungus...
J D Tang, T Ciaramitaro, M Tomaso-Peterson, S V Diehl
Field Performance of Refractory Species Treated with MCA
2017 - IRG/WP 17-30706
Micronized copper azole (MCA) has been used extensively over the past decade to preserve southern pine, and other wide sapwood species. Treatment of refractory species is less common, in part due to concerns about treatability and resulting efficacy. To address these concerns, white spruce and Pacific silver fir stakes, and lodgepole pine and red pine posts, were pressure-treated with multiple ret...
R Stirling, J K Ingram, P I Morris
Decay Resistance of MDF Manufactured with Huntite- Hydromagnesite and Zinc borate
2017 - IRG/WP 17-30710
The objective of this study was to evaluate the effectiveness of some mineral based fire retardants on decay resistance of Medium density fiberboard (MDF). Two mineral based chemicals containing (Huntite/Hydromagnesite) and zinc borate (ZB) were used at two different concentrations for panel manufacturing. Decay test of samples was performed according to EN 113 standard method. At the end of the t...
U E Başer, D Ustaömer, Ö Özgenç
Controlled deposition of copper nanoparticles using wood inherent architecture as natural template
2017 - IRG/WP 17-40783
As one of the most abundant renewable biomass resources, wood can be used as templates for synthesizing functional nanoparticles with controlled shapes and sizes. In this study, copper nanoparticles were synthesized with controlled shapes and sizes using poplar wood as the natural inexpensive and renewable templates. The crystal structure and morphologies of the copper nanoparticles were character...
Youming Dong, Kaili Wang, Yutao Yan, Jianzhang Li, M Hughes, Shifeng Zhang
A Green and Novel Technology for Recovering Copper and Wood from Treated Wood Waste – Part II: Optimization, copper metal recovery, and process design
2017 - IRG/WP 17-50326
The US consumes 70 million pounds of copper and produces 580 million cubic feet treated wood annually. The EPA disallows burning and reusing treated wood waste due to health/environmental concerns. Vast quantities of copper and wood are landfilled. Two safe and low cost extraction systems, citric acid and ammonium citrate, were identified in Part I of this study. In Part II of the study, effects o...
S Chen, R Patel
Review of Leaching Experiments of CCA-Treated Wood and Wood Treated with Copper-based Alternatives
2017 - IRG/WP 17-50330
The objective of this study was to compare leaching rates of various wood preservatives from treated wood and the tests used to gather this information. The preservatives compared included CCA and the copper-based alternatives, MCQ, ACQ, and MCA. The tests compared included AWPA E11, SPLP, TCLP, and environmental leaching tests. Among all of the tests evaluated, environmental tests most closely si...
A Jones, J Marini, H Solo-Gabriele
Uncertainty in life cycle assessment of preservative treated wood – copper and freshwater ecotoxicity
2017 - IRG/WP 17-50331
Life cycle assessment (LCA) is a method for quantifying the environmental impacts of a product over the life cycle. In the last years, there have been a growing application of LCA in developments of environmental product declaration (EPD), which is utilised by professional procurement of materials for buildings. For legislative issues, LCA have also been used to assess application of creosote to t...
L G F Tellnes
Five-year evaluation of a field trial of Eucalyptus grandis poles treated with zinc and boron
2017 - IRG/WP 17-30721
Round Eucalyptus wood treatment in sequential stages with inorganic borates and metal salts (zinc sulfate and boric acid+borax) was studied; the aims were to form an insoluble precipitate of zinc borate inside wood and to reduce treatment costs by performing the first treatment by simple ascent and diffusion of the preservative, at the same time as it was sought to impregnate the heartwood. The se...
C Ibáñez, A Camargo, C Mantero, M Rabinovich
Termite resistance of wood-plastic composites made with acetylated wood flour, coupling agent or zinc borate
2018 - IRG/WP 18-10917
There is little published scientific literature on the laboratory or field testing of wood-plastic composites (WPC) against termite attack. Therefore, the objective of this research was to investigate termite resistance (both laboratory and field) of 5 different extruded WPC blends of 50% western pine wood flour (WF) and high-density polyethylene (HDPE), and untreated pine solid wood. The study in...
R E Ibach, Y S Hadi, C M Clemons, S Yusuf